Freestyle Libre Sensor Application Guide
Uploaded by
eboneholmesFreestyle Libre Sensor Application Guide
Uploaded by
eboneholmes112 mg/dL
FreeStyle Libre Sensors Application Guide
Here are some tips you can use to help keep your sensor in place
WHEN SELECTING YOUR SENSOR APPLICATION SITE, REMEMBER TO
• Select an area on the back of your upper arm that generally stays flat
(no bending or folding).
• Choose a site that is at least 1 inch (2.5 cm) away from an insulin injection site.
• Prevent discomfort or skin irritation by selecting a site other than the one
most recently used.
• Make sure the site is clean-shaven to avoid interference with the sensor.
PREPARING THE SKIN’S SURFACE TO SET THE STAGE FOR OPTIMAL ADHESION
1. WASH Only use non-moisturizing, fragrance-free soap to wash
the area where you’ll apply the sensor.
2. CLEAN Use an alcohol wipe to remove any oily residue.
Allow your skin to dry fully before applying the sensor.
3. DRY This is especially important if you plan to apply the sensor
after you shower or swim.
FRIENDLY REMINDERS OF WHAT TO AVOID BETWEEN YOUR SENSOR & YOUR SKIN
• Moisture of any kind
• Hair; consider shaving the application area
• Oily residue from soap, lotion, shampoo, or conditioner
You will not receive alarms or glucose readings while your phone is in airplane mode unless you enable Bluetooth.
See reverse for Important Safety Information. 1
ALWAYS PREPARE THE SENSOR AGAINST A HARD, FLAT SURFACE
FreeStyle Libre 2 FreeStyle Libre 3
• Peel lid from the sensor pack and unscrew • Lift the sensor applicator
cap from the sensor applicator. out of the sensor pack.
• Line up marks on the sensor applicator The sensor applicator is
and pack. Press down firmly on the sensor now ready to apply the
applicator until it comes to a stop. sensor.
• Lift the sensor applicator out of the sensor
pack. The sensor applicator is now ready to
apply the sensor.
NOTE: Sensor pack and sensor applicator codes must
match or glucose readings may be inaccurate.
CAUTION: Sensor applicators will contain a needle. Do not touch inside sensor applicator
or place back inside sensor pack.
FOLLOW THESE STEPS WHEN APPLYING THE SENSOR
• Place the sensor applicator over the application site, press firmly and
hold for a few seconds.
• Gently pull the sensor applicator away from your body.
• Make sure the sensor is secure by pressing the sensor down and
running your finger along the sensor adhesive.
USING PRODUCTS WITH MOISTURIZING PROPERTIES CAN HELP YOU REMOVE YOUR SENSOR*
BABY OIL REMOVE ADHESIVE REMOVER UNI-SOLVE ADHESIVE REMOVER
A soft moisturizer. Removes adhesive residue on skin. Formulated to reduce adhesive trauma to
the skin by thoroughly dissolving dressing
tape and appliance adhesives.
We’re here to help. For further assistance with sensor adhesion,
please contact Abbott Customer Care Team at 1-855-632-8658.
The team is available 7 days a week from 8 AM to 8 PM Eastern Time, excluding holidays.
*The information below does not constitute an endorsement of the manufacturer or the product quality. Abbott Diabetes Care is not responsible for the completeness or
accuracy of product information. Product availability may vary by country and region. The manufacturer’s instructions for use of each product should be followed.
Important Safety Information
FreeStyle Libre 14 day system: Failure to use FreeStyle Libre 14 day system as instructed in labeling may result in missing a severe low or high glucose event and/or making a
treatment decision, resulting in injury. If readings do not match symptoms or expectations, use a fingerstick value from a blood glucose meter for treatment decisions. Seek
medical attention when appropriate or contact Abbott at 855-632-8658 or https://www.FreeStyle.abbott/us-en/safety-information.html for safety info.
FreeStyle Libre 2 and FreeStyle Libre 3 systems: Failure to use FreeStyle Libre 2 or FreeStyle Libre 3 systems as instructed in labeling may result in missing a severe low or high
glucose event and/or making a treatment decision, resulting in injury. If glucose alarms and readings do not match symptoms or expectations, use a fingerstick value from a blood
glucose meter for treatment decisions. Seek medical attention when appropriate or contact Abbott at 855-632-8658 or https://www.FreeStyle.abbott/us-en/safety-information.html
for safety info.
The circular shape of the sensor housing, FreeStyle, Libre, and related brand marks are marks of Abbott. Other trademarks are the property of their respective owners.
© 2022 Abbott. ADC-22195 v4.0 12/22 2
