Scribd
Upload
13 views

GE Mid-Range Training-Module 5-DISASSEMBLY

Uploaded by

tiojac7
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
13 views

GE Mid-Range Training-Module 5-DISASSEMBLY

Uploaded by

tiojac7
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 24

MODULE 5

DISSASSEMBLY
P3, P5, A5, P6
AIR FILTERS

Transformer Fans on right side –


Check for airflow.
ACCESS TO CARD CAGE

Both side panel covers come off by


removing 2 screws on either side of the
back of the panel.
FRONT COVER REMOVAL

First remove both side covers.

Remove 2 screws on either side of the


unit that hold the dummy cover.
FRONT COVER REMOVAL CONTINUED

After removing 4 screws


from the inside frame,
the front cover pulls off
the front of the unit.
REAR COVER REMOVAL

Remove 4 screws from


the back panel and it will
come off the back off the
unit easily.
VIVID S5, S6
SIDE COVER REMOVAL

Both side covers snap off the


machine. One of them contains the
system filter that needs to be
cleaned on a PM.
FRONT COVER REMOVAL

Remove the screws


on both the left and
the right sides of the
front panel. It can
then be pulled off.
BACK COVER REMOVAL

Remove the screws


on both the left and
the right sides of the
backA panel. It can
then be pulled off.
OPENING THE CABINET CAGE

Unlock the 2 fastening latches and then open the cage like a door.
POLARIS ARCHITECTURE
BACK COVER REMOVAL

Remove the power


cord.

Remove 5 screws
from the back
cover.

Remove all cables


and move to the
side.
CARD CAGE ACCESS

Remove the 4
screws that hold
the card cage
cover in place.
OPIO REMOVAL

Remove 2 screws from the Remove 5 screws from the


upper operator panel. under side of the Control
Panel.
KEY CAP REMOVAL
NEST BOX ARCHITECTURE
FRONT COVER AND FILTER REMOVAL

The front cover Pull it off. Turn the cover


snaps off the around to reveal
front of the unit. the filter.
TOP COVER REMOVAL

Top Cover

With the Front Cover and The panel snaps off the System with Front Cover,
Filter removed, pull front of the unit. No tools Filter, and Top Cover
forward on the top cover are required. removed.
and it will slide out off the
front of the unit.
BACK COVER REMOVAL

The back cover Use a Phillips head Snap the back


of the unit snaps screw driver to cover off by
off without any remove the bracket grabbing the
tools. that hold the power top and pulling it
cord in place. Then away from the
remove the cord. unit.
ACCESS TO CARD CAGE

With the rear


plastic cover With the metal mesh cover removed,
Card Cage with
removed, remove disconnect these 2 cables from the
covers removed.
the metal mesh back of the card cage. Then remove
cover at the top the screws that hold the card cage
of the card cage. cover in place.
LCD REMOVAL

Starting in the rear of the unit, Remove 5 screws and


remove the screws that hold the disconnect the corresponding
LCD back cover in place. cables. Then remove the 4
screws that hold the LCD on
the mount.
CONTROL PANEL REMOVAL

Access to the Operator Panel is on the under side of the panel. Remove the screws
and then gently lift the front of the OP Panel up so that you can see the cables that
need to be disconnected. Disconnect the cables and free the panel from the unit.

You might also like