Scribd
Upload
11 views

Bee201 Solution

Uploaded by

justayushka30
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views

Bee201 Solution

Uploaded by

justayushka30
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 22

Solution

BRANCH-CS/IT ODD SEM 2022-23


UIT
B.TECH. FIRST SESSIONAL TEST
TIME:2HRS SUBJECT-FUNDAMENTALS OF ELECYTRICAL ENGINEERING (BEE101)
SECTION –A (Attempt All Questions) [Very Short Answer] 4
Compare active & passive elements with examples. 1

What do you understand by unilateral & bilateral elements. Give examples. 1

What is the difference between primary and secondary batteries? 1

Enumerate types of ELCB. 1

SECTION –B (Attempt Any One Part from Each Question) [Long Answer] 6
Find the current in the 4 Ω resistor shown in network using source transformation. 2

2 A

Converting the parallel combination of the current source of 5 A and the resistor of 2Ω into an equivalent
series combination of voltage source and resistor
Adding two voltage sources

Again, by source transformation

Adding two current sources

By current-division rule,

Find the voltage between points A and B in Figure. 2

B
In Figure, determine the current supplied by each battery. 2

Assigning currents to all the branches

Using nodal analysis, determine the current in 2Ω resistance in the circuit shown in Figure. 2

The circuit is redrawn with assumed current directions


Solving equation 1, 2 & 3,
V1=7.05 V, V2= 28.06 V
Find the current through RL in the network, as shown in Figure, using mesh analysis. 2

Solving equation 1, 2 & 3,

Find the voltage drop across 4Ω resistance in the network shown in Figure, using mesh analysis. 2

B
now solve equations 1, 2 & 3
i3= 4.11 A

SECTION –C (Attempt Any One Part from Each Question) [Long Answer] 6
What are the important characteristics of batteries and explain electrical characteristics of lead acid 2
batteries.

Important characteristics of batteries


5 A
What are the necessities of earthing? Explain various types of earthing system in short. 2
Necessities of earthing

B
Name the various cables used in electrical system based on insulation. Explain any two. What are the 2
6 A
features of good conductor in electrical circuit?
The Properties of good conductor are given below:
a. It possess very low resistance or specific resistance.
b. It possess more conductance and there by conducts electricity readily through it.
c. It is a good conductor of heat.
d. It is highly resistance to corrosion by liquid.
e. It must be malleable and ductile.
f. It must be flexible.
g. It possess better tensile strength.
h. It should not react with climatic conditions.
i. It can be drawn in very fine wires.
j. It must be readily joinable.
k. It must be very low in cost.
l. It must available in plenty.
Explain the construction, rating and specific applications of at least two types of wires used in electrical 2
engineering.

What are the types of air circuit breaker (ACB). Explain the arc chute type air circuit breaker with neat 2
diagram.

7 A
B Explain construction and working principle of MCB with neat diagram and write its applications. 2
SECTION –D (Attempt Any One Part from Each Question) [Long Answer] 4
8 A Using mesh analysis, voltage across and current through 4 Ω resistor in figure given below: 2
B Find the current through the 5 Ω resistor in the network of Figure. 2
Explain the busbar arrangements used in the system with suitable diagram? 2

9 A
B What is lightning? Explain the techniques used to protect against lightning? 2

You might also like