Scribd
Upload
228 views

3 Install+Cisco+ISE+on+EVE

Uploaded by

shahrukh khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
228 views

3 Install+Cisco+ISE+on+EVE

Uploaded by

shahrukh khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Install Cisco ISE on EVE-NG:

Initial base/default image will be approximately 16Gb. After you will setup it in the lab, it will
take approximately 80Gb extra HDD space. Open WinSCP, once you connected to WinSCP type
the IP address of EVE-NG in host name choose the File Protocol: SFTP, Port number: 22,
Username: root and Password: eve.

The column on the left represent file on local machine and the column on the right represent
files and folder on remote machine.

1 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717


Go to the path opt->unetlab->addons->qemu on the remote machine.

Navigate to the folder from local to remote machine and upload. Once the process completed
the file will be available immediately.

Save the configuration by fixing the permissions using the following command on EVE-NG.
/opt/unetlab/wrappers/unl_wrapper -a fixpermissions

2 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717


Open the EVE-NG in the browser then ‘Add an Object’ and select the Node.

Add an object’ and select the Network make Type Management(Cloud0) and press Save button.

Connect Network Object to Cisco Identity Service Engine (ISE) G0 interface.

3 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717


Type the set username: admin and Password: Test123 to login to the Cisco ISE device.

To check the Management IP address of Cisco Identity Service Engine (ISE) type command.

Change the IP address using below commands to suite to your Lab environment.
ISE2-2/admin# configure
ISE2-2/admin(config)# interface gigabitEthernet 0
ISE2-2/admin(config-GigabitEthernet)# ip address 192.168.114.200 255.255.255.0
Continue with IP address change? Y/N [N]: Y

Type https://192.168.114.200 in browser, Type Username: admin and Password: Test123

4 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717

You might also like