Scribd
Upload
62 views1 page

Rotary Compressor Blank Datasheet

Uploaded by

probo.nogoya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
62 views1 page

Rotary Compressor Blank Datasheet

Uploaded by

probo.nogoya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

COMPRESSOR DATA SHEET

Federal Uniform Test Method for Certain Air Compressors Not Applicable
Rotary Compressor: Fixed Speed
MODEL DATA - FOR COMPRESSED AIR

1 Manufacturer: A1B2C3, Inc.

Model Number: 12A 22B 40 - 125 psig / 460V/3ph/60Hz


Date: 8/12/2019
2 X Air-cooled Water-cooled Type: Screw

Oil-injected Oil-free # of Stages: 1


Rated Capacity at Full Load Operating Pressure
a, e a,e
3* 175.0 acfm
b b
4 Full Load Operating Pressure 125 psig
c c
5 Maximum Full Flow Operating Pressure 125 psig

6 Drive Motor Nominal Rating 40 hp

7 Drive Motor Nominal Efficiency 93.6 percent

8 Fan Motor Nominal Rating (if applicable) 1.3 hp

9 Fan Motor Nominal Efficiency 80 percent


e e
10* Total Package Input Power at Zero Flow 9.1 kW

Total Package Input Power at Rated Capacity d


11 36.12 kW
and Full Load Operating Pressured

Specific Package Input Power at Rated Capacity


12* e 18.69 kW/100 cfme
and Full Load Operating Pressure

*For models that are tested in the CAGI Performance Verification Program, these items are verified by the third party administrator.
Consult CAGI website for a list of participants in the third party verification program: www.cagi.org
NOTES: a. Measured at the discharge terminal point of the compressor package in accordance with
ISO 1217, Annex C; ACFM is actual cubic feet per minute at inlet conditions.
b. The operating pressure at which the Capacity (Item 3) and Electrical Consumption (Item 11) were measured
for this data sheet.
c. Maximum pressure attainable at full flow, usually the unload pressure setting for load/no load control or the
maximum pressure attainable before capacity control begins. May require additional power.
d. Total package input power at other than reported operating points will vary with control strategy.
e. Tolerance is specified in ISO 1217, Annex C, as shown in table below:
NOTE: The terms "power" and "energy" are synonymous for purposes of this document.
Volume Flow Rate Specific Energy No Load / Zero Flow
at specified conditions Volume Flow Rate Consumption Power
m3 / min ft3 / min % % %
Member Below 0.5 Below 17.6 +/- 7 +/- 8
0.5 to 1.5 17.6 to 53 +/- 6 +/- 7
+/- 10%
1.5 to 15 53 to 529.7 +/- 5 +/- 6
ROT 030.2 Above 15 Above 529.7 +/- 4 +/- 5

12/19 Rev 3 This form was developed by the Compressed Air and Gas Institute for the use of its members participating in the PVP. CAGI has not independently verified the reported data.

You might also like