0% found this document useful (0 votes)
30 views2 pages

Hx436c17fb3ak2 16

data sheet kingston RGB Fury

Uploaded by

John Betancourth
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
30 views2 pages

Hx436c17fb3ak2 16

data sheet kingston RGB Fury

Uploaded by

John Betancourth
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Memory Module Specifications

HX436C17FB3AK2/16
16GB (8GB 1G x 64-Bit x 2 pcs.)
DDR4-3600
DDR4 3600 CL17 288
288-Pin
Pi DIMM Kit

SPECIFICATIONS
CL(IDD) 17 cycles
Row Cycle Time (tRCmin) 45.75ns(min.)
Refresh to Active/Refresh 350ns(min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 32ns(min.)
UL Rating 94 V - 0
Operating Temperature 0o C to +70o C
Storage Temperature -40o C to +85o C

DESCRIPTION FEATURES
HyperX HX436C17FB3AK2/16 is a kit of two 1G x 64-bit (8GB) • Power Supply: VDD = 1.2V Typical
DDR4-3600 CL17 SDRAM (Synchronous DRAM) 1Rx8, memory • VDDQ = 1.2V Typical
module, based on eight 1G x 8-bit FBGA components per module.
• VPP = 2.5V Typical
Each module kit supports Intel® Extreme Memory Profiles (Intel®
• VDDSPD = 2.2V to 3.6V
XMP) 2.0. Total kit capacity is 16GB. Each module has been tested
to run at DDR4-3600 at a low latency timing of 17-21-21 at 1.35V. • On-Die termination (ODT)
The SPDs are programmed to JEDEC standard latency DDR4-2400 • 16 internal banks; 4 groups of 4 banks each
timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact
• Bi-Directional Differential Data Strobe
fingers. The JEDEC standard electrical and mechanical
specifications are as follows: • 8 bit pre-fetch

• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)

FACTORY TIMING PARAMETERS • Height 1.624” (41.24mm), w/heatsink

• Default (JEDEC): DDR4-2400 CL17-17-17 @1.2V


• XMP Profile #1: DDR4-3600 CL17-21-21 @1.35V
• XMP Profile #2: DDR4-3000 CL15-17-17 @1.35V

Continued >>

hyperxgaming.com
kingston.com/hyperx Document No. 4809216A 10/23/19 Page 1
continued

MODULE WITH HEAT SPREADER

133.35 mm 7 mm
41.24 mm

MODULE DIMENSIONS

All measurements are in millimeters.


(Tolerances on all dimensions are ±0.12 unless otherwise specified)
133.35

129.55

2.10±
±0.15
31.25

3.00
11.00
14.60

Detail A Detail B Detail D Detail E Detail C


17.60
2.70±0.15

8.00

Pin 1 Pin 35 Pin 47 Pin 105 Pin 117

3.35
64.60 56.10
28.90 22.95

The product images shown are for illustration purposes only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without notice.

FOR MORE INFORMATION, GO TO HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at
the published HyperX memory
memory speeds
speeds and
and timing
timing settings.
settings. Kingston
Kingstondoes
doesnot
notrecommend
recommendthatthatany
anyuser
userattempt
attempttotorun
runtheir
theircomputers
computers
faster than the published
published speed.
speed. Overclocking
Overclocking or
or modifying
modifyingyour
yoursystem
systemtiming
timingmay
mayresult
resultinindamage
damagetotocomputer
computercomponents.
components.

HyperX is a division of Kingston. Document No. 4809216A Page 2


©2019 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA.
All rights reserved. All trademarks and registered trademarks are the property of their respective owners. hyperxgaming.com

You might also like