#4

Wireless Metropolitan Area Networks: IEEE 802.16e Mobile WiMAX Part IV: MAC Layer
Wireless Networking Sunghyun Choi, Associate Professor Multimedia & Wireless Networking Lab. School of Electrical Engineering Seoul National University
1

MAC Features

MAC Features

Flexible BW Allocation by MAP Message Based MAC Signaling Dedicated Feedback Channel Various BW Request Mechanism Payload Header Suppression Support Security Support Sleep Mode Support HARQ/ARQ Support Handoff Support QoS Support AMC/Power Control Support

MAC Protocol Stack

- Transformation of external network data into MAC SDUs - Payload header suppression

System Access Bandwidth Allocation Connection set -up Connection maintenance QoS

- Authentication - Secure key exchange - Encryption

Convergence Sub-layer (CS)

Convergence Sub-layer

Tx

IP Packet from Network Packet Classification

IP Address Port No. Protocol Service Type

Header Suppression CS PDU to MAC CPS

Rx

CS PDU from MAC CPS Header Reconstruction IP Packet to Network

Packet Header Suppression

Packet Header Suppression (PHS)

A repetitive portion of the payload headers of the higher layer is suppressed PHSF (field): The header content which is suppressed PHSI: After PHS, MSDU is prefixed with PHSI PHSM: Select bytes not to be suppressed

The bytes in the higher-layer headers are suppressed except the bytes marked by PHSM

PHSV can be set (verification) Receiver recover suppressed header (PHSF) using CID and PHSI

PHS with Masking

Identifier

Identifier

48 bit MAC Address

Universal MAC address Used during initial ranging and as a part of authentication process

16 bit Connection Identifier (CID)

Unique only in one BS

That is, there can be 2^16 connections in a cell One SS maintains up to three management CIDs and multiple transport CIDs

Three pairs (DL & UL) of management CID

Shall be assigned in the RNG-REQ/RSP messages Same CID value is assigned to both DL and UL Established at SS initialization To exchange MAC management messages Inherently three different level QoS for management connection

Transport Connection Identifier

To exchange MAC data PDU

10

Identifier

Management Connection

Basic CID

Short and time-urgent MAC management messages (ARQ, DBPC-REQ/RSP, FPC, MOB_SCN-REQ/RSP, etc.)

Primary Management CID

Longer, more delay tolerant MAC management messages (DSA-REQ/RSP, DSC-REQ/RSP, etc.) Can be packed and/or fragmented

Secondary Management CID

Delay tolerant, standard-based management messages (DHCP, TFTP, SNMP, etc.) Carried in the IP datagram Can be packed and/or fragmented

Transport Connection

A multiple number of transport connections At the connection setup, assigned from the serving BS For MAC data PDU transmission
11

MAC PDU construction

12

MAC PDU Format

Generic MAC header

6 bytes long MAC PDU length CID Subheader indicator EKS (Encryption Key Seq.) Encryption indicator CRC Indicator

Payload (optional)

Variable Size Encrypted Portion of MAC PDU MAC message or data

CRC (optional)

4 bytes long Generic MAC header & ciphered payload

13

MAC Header

Generic MAC header

Type (6 bits)

Length LSB

Connection ID MSB Mesh Subheader

Connection ID LSB

Header Checksum

ARQ Feedback Payload Extended Type Fragmentation Subheader Packing Subheader DL: Fast-Feedback Allocation Subheader UL: Grant Management Subheader

1 Byte Is Packing or Fragmentation Subheader extended?

14

MAC Header

MAC header without payload

Applied to UL only No encryption, no CRC Two types of MAC signaling header

Type I & II

15

MAC Header

MAC signaling header Type I

Header Type =1 Encryption Ctrl =0

Type (3 bits)

Header Content MSB (11 bits)

Header Content LSB

Connection ID MSB 000 Bandwidth Request Incremental Bandwidth Request Aggregate PHY Channel Report Bandwidth Request with UL Tx Power Report Bandwidth Request and CINR Report Bandwidth Request with UL Sleep Control SN Report CQICH Allocation Request

Connection ID LSB

Header Checksum

001 010 011

1 Byte 100 101 # Payload does NOT exist 110 111

16

MAC Header

MAC signaling header Type II

Header Type =1 Encryption Ctrl =1

Type

17

MAC Header

MAC Subheader

Fragmentation subheader Grant Management subheader Packing subheader ARQ Feedback Mesh subheader FAST-FEEDBACK allocation subheader

Generic MAC Header

Subheaders

Payload

CRC

18

MAC PDU Construction

Packing
MSDU
Packing

MSDU

MSDU

Packing Subheader

MSDU

Packing Subheader

MSDU

Packing Subheader

MSDU

Generic MAC Header

MPDU

Fragmenting
MSDU
Fragmenting

Generic Fragmentation MAC Header Subheader

MPDU
Generic Fragmentation MAC Header Subheader

MPDU

Generic Fragmentation MAC Header Subheader

MPDU

19

Packing with Fragmentation

20

MAC PDU Construction

SDL for MPDU construction

21

MAC PDU Construction

CRC

Header Type = 0 Coverage: Generic MAC header , encrypted payload

Encryption

Generic MAC header shall not be encrypted EC, EKS, and CID in Generic MAC header Unused data bursts 0xFF

Padding

22

Concatenation

Multiple PDUs into a single transmission burst

23

ARQ support

24

ARQ Mechanism

Optional and unidirectional Per-connection basis The basic unit of ARQ: Block

Each SDU is logically partitioned into blocks Block size : ARQ_BLOCK_SIZE

Unit of transmission: Fragment

Block is the basic unit to make the fragment If fragmentation is not enabled, each fragment shall contain all blocks of parent SDU

Sequence number for ARQ: BSN (Block Seq. No.)

Fragmentation/Packing sub headers contain a BSN

Fragment can be rearranged when the blocks are retransmitted (flexible)

25

Type of ARQ

4 types of ARQ feedback (ACK)

Type 0: Selective ACK

Using 16-bit Selective ACK map

Type 1: Cumulative ACK Type 2: Cumulative ACK + Selective ACK

Cumulative ACK to BSN From the BSN + 1, selective ACK is applied

Type 3: Cumulative ACK + Block sequence ACK

Cumulative ACK to BSN Using 2 or 3-bit Sequence ACK Map From the BSN + 1, block sequence ACK is applied Similar to the run length coding

Flexible Acknowledgement

According to the error pattern, any one of these four ACKs can be sent at every ACK time

26

ARQ Mechanism

ARQ feedback IE

27

ARQ Mechanism

ARQ operation of four ACK types:

(a) selective ACK; (b) cumulative ACK; (c) cumulative with selective ACK; and (d) cumulative ACK with block sequence ACK.

28

Example of ARQ Block Usage

29

Scheduling Services and Bandwidth Allocation

30

Data Delivery Services

For mobile network 5 delivery services:

UGS, RT-VR (Variable Rate), NRT-VR, BE, and ERT-VR

Using scheduling services:

Being supported by UGS, rtPS, nrtPS, BE, and ertPS, respectively

31

Scheduling Services

Uplink Scheduling Services

Demand Assigned Multiple Access (DAMA) services based on request and grant Each scheduling service is associated with a set of rules for allocating uplink capacity for the request-grant protocol

Unsolicited Grant Service (UGS)

Periodic, fixed-sized, real-time data stream BS schedules grants of the negotiated size in a preemptive manner This eliminates the overhead and latency of bandwidth request e.g., T1/E1, VoIP without silent suppression

Real-time Polling Service (rtPS)

Periodic, variable-sized, real-time data stream Dynamic in nature, but offers periodic dedicated requests e.g., MPEG video

32

Scheduling Services

Non-Real-time Polling Service (nrtPS)

Delay-tolerant, variable-sized data stream with minimum data rate requirement These connections may utilize random access transmit opportunities

Best Effort (BE)

Data stream with no minimum service level SS sends requests for bandwidth in either random access slots or dedicated transmission opportunities

Extended rtPS

Taking efficiency of both UGS and rtPS Unicast grants in an unsolicited manner like in UGS UGS allocations are fixed in size, ertPS allocations are dynamic e.g., VoIP WITH silent suppression Newly introduced by 16e

33

Bandwidth Requests and Grants

Classification of Scheduling Services

34

Bandwidth Requests and Grants

Request

Mechanism that informs the SSs needed uplink bandwidth allocation Bandwidth request is incremental or aggregate SSs shall periodically use aggregate type Method

Bandwidth Stealing
Using BW request header

PiggyBacking
Using grant management subheader Piggybacked case can use only incremental type and most requests are incremental for efficiency

Polling
BS allocates to the SSs the bandwidth for the purpose of making bandwidth requests Polling is done on SS basis, not CID basis

35

Bandwidth Requests and Grants

Method (contd)

Polling
Unicast Multicast and Broadcast, then contention-based BW request

Using PM (Poll Me) bit (polling)

Contention-based CDMA Bandwidth request

Grants

Bandwidth is always requested on a CID basis and bandwidth is allocated (i.e., granted) on an SS basis. To the SSs Basic CID

36

Bandwidth Requests and Grants

Illustration of Bandwidth Request and Allocation:

(a) UGS; (b) rtPS; and (c) ertPS.

37