Scribd
Upload
85 views5 pages

Chromatography Problems

Document I have uploaded.

Uploaded by

ashish mishra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
85 views5 pages

Chromatography Problems

Document I have uploaded.

Uploaded by

ashish mishra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Chromatography Problems

1. A separation on an affinity column produced the chromatogram shown below. Overtop of the
chromatogram, sketch show what it would look like if a second sample with more (higher
concentration) of analyte was run.

2. Are the following changes in conditions likely to increase or decrease retention time?
a. faster flow rate
b. longer column
c. longer connector between column and detector
d. higher analyte concentration
e. higher temperature
f. larger sample size
g. using a less polar column while doing a reverse-phase separation
h. using a less polar mobile phase while doing a reverse-phase separation

3. In what order will the following substances elute?


In reverse-phase liquid chromatography:
a. butylamine, 2-butylene, ethylamine, ethylene
b. benzene, chlorophenol, phenol, trichlorophenol
In gas chromatography with a polar column:
c. butanol, methanol, water
In gas chromatography with a nonpolar column:
d. butanol, methanol, water
In ion chromatography:
e. bromide, fluoride, sulfide
4. For the following chromatogram, calculate retention time and adjusted retention time for each
peak.

5. The following chromatogram was obtained using a C18 column and a methanol:water mobile
phase.

How would the chromatogram change if


a. more ethanol were added to the sample
b. butanol was added to the sample
c. water was added to the sample
d. an unretained species was added to the sample
6. Chromatography was performed on the following solutions, where the total volume of each
solution is 100.0 mL:

solution volume 100 ppm X (mL) volume 50 ppm Y (mL) volume 50 ppm Z (mL)
1 5 20 10
2 10 15 20
3 15 10 5
4 20 5 15

This resulted in 4 chromatograms with the following results:

peak A peak B peak C


Chromat- time Area (x 104) time Area (x 105) time (min) Area (x 104)
ogram (min) (min)
1 6.44 0.68 8.00 4.10 9.72 7.99
2 6.54 1.98 7.96 8.30 9.68 7.63
3 6.34 2.18 8.03 2.53 9.66 7.27
4 6.49 3.02 8.12 6.29 9.58 6.93

a. Which peak corresponds to which analyte?

b. Make a calibration curve for each analyte

c. A unknown solution was analyzed with the same method. Based on the results below, what is
the composition of the sample?

retention time (min) peak area


6.59 33419
8.05 554193
9.68 76416

7. A calibration curve obtained from a chromatographic experiment resulting in a line with the
equation

Peak area = (139997±5949 ppm-1)[analyte] + 913±554

a. If sample had a resulted in a peak area of 568336, what is the concentration of analyte, with
error?

b. In another experiment, 10.00 µL of sample was diluted with water to make a 1.00 mL solution.
The resulting analyte peak had an area of 2765422. What is the concentration of analyte in the
original solution?

c. In another experiment, 1.00 L of sample was processed through a solid phase extraction
cartridge. The analyte stayed on the cartridge. Then 5.00 mL of methanol was used to elute the
analyte from the cartridge. When the eluted solution was chromatographically separated, the
analyte peak area was 6729661. What was the concentration of analyte in the original sample?
8. Standard Addition. The chromatographic analysis of Sample A resulted in a peak at 8.95
minutes and a peak area of 24237396. When 10.0µL of Sample A was mixed with 5.00 µL of
20.0 ppm standard, chromatographic analysis of the resulting solution resulted in a peak with a
retention time of 9.12 minutes and a peak area of 121220801. What is the concentration of
analyte in the original sample?

9. Standard Addition. A chromatographic analysis of Sample B produced the following results:


Time Peak area %area Height %height
5.726 764499 39.41 62503 35.89
7.207 241332 12.44 46947 26.96
10.735 934148 48.15 64691 37.15

a. What is a likely reason that the percent areas and percent heights are different?

b. When 4.34 g of Sample B are mixed with 3.98 g of pure analyte and the
mixture analyzed, the following results were obtained. What is the % analyte in the
mixture?
Time Peak area %area Height %height
5.739 528045 29.50 43954 28.90
7.554 162697 9.089 33037 21.72
10.686 1099110 61.41 75114 49.38

10. Graphical Standard Addition. The following solutions were made and analyzed with
ion chromatography--the results included in the table. Create a standard addition graph
and determine the concentration of fluoride in the original sample, with error.

Note: all solutions were made with a total volume of 10.00 mL and a fluoride standard
with a concentration of 35.21 ppm.

Vol sample (mL) Volume std (mL) Retention time (min) Peak area
5.00 0.00 2.50 135235
5.00 0.50 2.80 396313
5.00 1.00 2.15 764095
5.00 1.50 2.46 1050673
5.00 2.00 2.41 1523699
11. Graphical Internal Standard. The following solutions were made and analyzed with
ion chromatography using 81.7 ppm fluoride ion as an internal standard and 64.4 ppm
sulfate ion as an analytical standard. What is the concentration of sulfate in the sample,
with error?

Total volume of solution = 10.00 mL; last row is sample not standard
Vol SO42- Vol F- tR peak 1 Area peak 1 tR peak 2 Area peak 2
(mL) (mL) (min) (min)
1.00 3.00 3.09 62817 18.30 96234
2.00 3.00 2.93 68075 18.37 204377
3.00 3.00 3.20 61262 18.54 274731
4.00 3.00 3.03 67054 18.47 402935
5.00 (sample) 3.00 2.97 63281 18.39 278748

Solutions

You might also like