Electric Help For Bicycles

PVY
Precautions for use Preparation before the ride

■ Power supply circuit,lighting is good.

Comply with traffic regulations and safety tips
■ Whether the front and rear brakes can work
■ People under the age of 16 are forbidden to drive electric bicycles on the road; normally.
■ The maximum speed of an e-bike shall not exceed 15km/h in the non-motorized vehicle lane. On ■ Whether the handlebars and front and rear
roads with no non-motorized lanes, you should drive on the right side of the roadway; wheels are tight
■ Do not lend the electric bicycle to someone who cannot operate it, in case of injury; ■ Whether the tire pressure is normal.
■ Electric bikes should carry people or goods according to laws and regulations; ■ Check the reflectors for contamination before
■ It is recommended to wear a helmet and pay attention to driving safety;Do not ride with one hand or riding.
both hands off the handle;
■ When riding in rainy and snowy weather, the braking distance will be extended. Slow down and
walk slowly. Avoid traveling in bad weather such as heavy rain.
Vehicle coding position diagram

xxxxxxxxxxxx
Safety tips for electric vehicle use xxx
■ Do not park in building foyers,evacuation staircases,walkways and exits;
■ Electric bicycles should not be charged and parked in residential buildings,charging should be away from
combustible materials,charging time should not be too long.
■ Proper use and maintenance of batteries,old batteries shall not be dismantled without
authorization,should be organized by the relevant professional departments to recover;
■ Understand the safe use of the charger and warning language;When replacing the charger; it should match
the model of the battery;
■ Do not flush with water to avoid potential accidents caused by wetting of internal electronic parts and
wiring.
■ When adjusting handlebars or saddles,care should be taken not to expose the safety line marks of the risers and saddles.
 Electrical schematic diagram

Specification Battery Spec

Size(length x width x height) 1710 x 630 x 1290 mm Battery type Lithium ion battery
Folding 1070 x 520 x 750 mm
Capacity 14.5Ah/16.5Ah
weight 29 kg
Maximum design speed 25 km/h Voltage 48V
Assisting range(PLUS500） 100 km
Assisting range(PLUS1000) 120 km
Electric range(PLUS500） 40-60 km Motor Spec
Electric range(PLUS1000) 60-80km Motor type Brush-less dc motor
Loading weight ≤150 kg 250W
Power before unlocking
Rated power 500W/1000W
Under the condition of full power,the endurance is 75kg,the
Voltage 48V
temperature is about 25℃,the environment of flat road is still
without wind,and the driving condition is measured at 15km/h
uniform speed under the energy-saving mode.The actual
endurance will be different due to factors such as load, Controller Spec
temperature,wind speed,road surface and operating habits. Under voltage protection 40V
Over current protection 23±2A/15±2A
Operation and using
Folding step
Operation and using
Folding step
Transmission use
Transmission diagram
Gear Intensity Speed
1-2 Relax Slow
3-5 Moderate Moderate
6-7 Hard Fast
■ To speed up, start in a lower gear and switch to a higher gear as you speed up.
■ As you go uphill, your speed drops, and you lower your gear to maintain a certain
amount of pedal power.
■ When the wind is in the wind, you speed up and shift gears to maintain a certain
amount of pedal power.
The above is the cycling suggestion,You can use the gear properly according to your personal habits.

When using the driveline, pay attention to the following details

■ When using a gear shift system, try not to skip gears as they can easily damage the transmission.It is also possible to change more than two
gears, should be a level of adjustment, can better protect the transmission system.
■ When the bicycle stops running, or when going downhill, do not reverse the rotation system, which is not only bad for the transmission
system, but also can cause accidents.
■ If the transmission fails, or the gear is not accurate, it will affect the performance of the transmission. At this time, you should go to a
professional bicycle shop for maintenance in time to prevent the failure from worsening.
Dashboard and cycling mode

Power indicator

Headlight

Current gear value

Up key
Speed
Speed unit Mode key
Down key
Failure indication

Cumulative mileage
Current voltage

Real time current

Subtotal mileage
Single run time

Mileage unit
Multi-function display area
Battery instructions
The battery

■ The power supply pin of the charger is inserted into the

charging port of the battery, and the power supply pin
of the other end is connected to the power supply
■ When charging, the status light of the charger is red
■ When the battery is fully charged, the charger is in
green and charged
■ If the battery is charged in the e-bike, turn off the meter
Battery instructions
Battery removal and installation

■ Insert the key and twist it twice. When the

battery latch fully retracts the battery, pull out
the key and remove the battery.

■ Slowly push the battery into the bottom along

the predetermined position, insert the key and
twist it so that the battery latch pops out, and
the battery is installed. When the key is turned
a second time, the electric bicycle is in the
state of power.
 Display

Folding box

Folding stem Saddle

Taillight
Headlight

Rear disc brake /

Rear hydraulic brake
Front disc brake /
Front hydraulic brake
Motor


Pedal
The battery
Instructions before use of lithium battery

■ Before use, please confirm that the battery model is the original battery, do not use other brands of batteries at will.
■ Check the appearance of the lithium battery is in good condition and there is no obvious phenomenon such as damage, liquid leakage, hot
water and smoke.
■ In order to ensure the safety of transportation, the battery power in the battery plant is about 30%. Due to the power Consumption in the
process of transportation and storage, the battery power is low or no during the first use. This is a normal phenomenon, so please do not
worry.

Using the environment

■ The best use environment is 10℃-45℃;

■ In the case of low temperature, the available capacity of lithium battery will have different degrees of attenuation.The specific reference
degree is as follows:
The available capacity at -10C is about 70%, at 0'C it is 85%,and at 25'C it is 100%.lf the battery has odor,heat,deformation anoother
abnormal conditions. please immediately stop using, stay away from the battery and contact the after-sales department.

Warning
Battery is not a part that can be repaired by users. If there is any abnormal phenomenon, please contact the after-sales department for
maintenance.
Unauthorized dismantling of the battery will not be covered by the three-pack policy,and may lead to battery
heating,smoking,fire.explosion.
Charging environment

■ Use the battery to support the original factory charger manufacturing line charge, do not use other brand or model charger who line
charge.
■ Charge the battery at 0℃-40℃ to ensure that there are no flammable substances around and good ventilation.
■ Charging time description: the charging time of the battery should not exceed 12 hours. Excessive charging will affect the battery life and
there are safety risks.
■ The battery quantity of the charger rises quickly in the early stage and slowly in the later stage. This is the procedure set for charging safety
and is normal.
■ Outdoor charging is strictly prohibited in bad weather.
■ During the charging process, the surface temperature of the battery box is found to be very high(higher than 55℃), indicating that the
battery pack is in trouble. Cut off the power supply immediately and send it to the designated repair station for maintenance. It is normal
that the surface of the charger box is slightly heated (no more than 60℃) during the charging process.

Storage environment

■ After the battery is placed in the e-bike, it will slowly consume the battery power due to the vehicle's work. The vehicle can be kept for up
to two months. The meter shows that the battery power drops normally.
■ When the battery is not used for a long period of time (more than one month), please be sure to remove it from the e-bike and charge
the battery to a half-full and full state (after discharging the battery, use the charger for 1.5-2 hours), then store it in a cool and dry room (the
best temperature is 5℃-25℃), and charge it for 1 hour every two months.
■ Batteries and chargers should be stored in a clean, dry, ventilated place, away from contact with corrosive substances, away from fire and
heat sources (must be less than 2 meters), away from flammable substances, and disconnect the charger from the battery.
■ The most appropriate storage capacity of the battery is 50%. If the battery is lower than 10% , long-term storage will lead to irreversible
capacity attenuation of the battery.
■ Avoid placing the battery in a risky location where a drop could cause uncontrollable damage to the battery and cause leakage, heat, smoke,
fire or explosion.
Maintenance and repair

Maintenance and cleaning instructions

■ Do not flush with water to avoid potential accidents caused by wetting of internal electronic parts and wiring;
■ Please use neutral cleaner, gently wipe the dirt on the surface of paint or plastic parts with a cloth, and then wipe it clean with a dry cloth.
■ Please use lubricating oil to clean the metal parts of the e-bike body for maintenance.
■ Do not oil the brake parts to avoid brake failure and danger.

Regular inspection

■ Whether the fastener is locked tight, and whether the joints in each part are normal;
■ Whether the tread pattern of the outer tire is worn and cracked, whether the air pressure of the front and rear tires is appropriate, and
whether the driving system is smooth;
■ Whether the brake system is working normally.

Vehicle storage method

■ When the product is not used for a long time, please do not store it in the outdoor environment, bright light and the environment below
zero for a long time. The distance from the heat source (heating equipment, etc.) should not be less than 2M;
■ Store in dry, dean, well ventilated indoor environment with temperature between 10℃ and 45℃ and relative humidity no more than
90%;
■ If you do not use the e-bike for a long time, pay attention to charging the battery regularly (generally about two months apart) to maintain
battery performance;
■ This product should not be in contact with corrosive liquid to avoid any mechanical impact and pressure.
Trouble shooting

Issue Reason Solution way

■ Whether the power switch is on or not

Turn on the power No power ■ No power supply for vehicles
■ Battery under voltage, charge the battery

■ In the braking state ■ Whether the brake handle is in the braking

Turn on the power and twist the handle state
Motor does not start ■ Start switch fault
■ Contact the after-sales
■ The battery is undercharged
■ Check the charger for any damage
■ Tire pressure is low ■ Check the tire pressure before each use
■ Frequent braking ■ Develop good driving habits
Insufficient range
■ Battery aging or normal attenuation ■ Change the battery
■ Low ambient temperature, battery ■ It is normal
capacity attenuation
■ Check whether the power plug is loose
■ The charger is not plugged in properly ■ Wait for the battery to resume charging
■ Battery temperature is too low temperature
The battery won＇t charge
■ Battery temperature is too high ■ Wait for the battery to resume charging
■ Battery under voltage temperature
■ Contact customer service
 RoHS
Bike name Electric help for bicycles

The name and content of harmful substances in the product

Hazardous substance
Parts name
(Pb) (Hg) (Cd) (Cr(VI)) (PBB) (PBDE)

Display ○ × ○ ○ ○ ○
Head lamp ○ × ○ ○ ○ ○
Tail lamp ○ × ○ ○ ○ ○
Battery ○ × ○ ○ ○ ○
Controller ○ × ○ ○ ○ ○
Charger ○ × ○ ○ ○ ○
1、This form is prepared in accordance with the provisions of SJ/T 1136
○:Indicates that the content of the hazardous substance in all homogeneous materials of the part is below the limit
set by GB/T 26572.
×:Indicates that the content of the hazardous substance in at least one homogeneous material of the component
exceeds the limit specified in GB/T 26572.