ZONE TECH Full Length Paper - II 1

ZONE TECH
Best Institute For ASSISTANT & JUNIOR ENGINEER

Test ID. 276 Roll No.

CH
ELECTRICAL ENGINEERING
Full Length Paper - II Mains Test Paper
Duration : 2:00 hr.
TE
Read the following instructions carefully
Maximum Marks : 300

1. Candidates should be attempt 5 questions in all. All question carry equal marks.
2. Each condidate will be given one Answer Book.
3. Answers to all questions must be written in one language, i.e. , either in English
E
or in Hindi according to the option given by the candidate in his/her Application
Form. Candidates are not allowed to write the answers partly in English and
N

partly in Hindi.
4. Candidates must write their Name , Roll No., Name of the Examination and
Subject at the prescribed place on the cover page of the Answer Book correctly.
ZO

Candidates must also put their signature,The above instrucations must be fully
complied with failing which the Answer Book with not be evaluated and zero
mark will be awarded.
5. No credit will be given for answer written in a language other than the one
opted by the candidate.
6. Mobile phones and wireless communication devices are completely banned in
the examination halls/rooms. Candidates are advised not to keep mobile phones/
any other wireless communication devices with them, even switching it off, in
their own interest. Failing to comply with this provision with be considered as
using unfair means in the examination and action will be taken against them
including cancellation of their of their candidatiure.

DO NOT OPEN THIS TEST BOOKLET UNTIL YOU ARE ASKED TO DO SO

Call Us : 0141-2597591, +91-9828747676 ZONE TECH F-26/A Kisan Marg,Tonk Phatak, Jaipur
ZONE TECH Full Length Paper - II 2
Q.1 (c) Determine the value of R shown in the
below figure such that the 6  -resistor
(a) Consider the full wave rectified sine
wave as shown in figure below:– consumes the maximum power.

V(t)
R

Vm

H
 t 3 3
0 2 3 4
10V
3 6

C
Find its average value and RMS value.

[10 Marks]

(b) Determine the value of the unknown

TE [15 Marks]

node voltage 1 in the circuit shown in (d) For the circuit shown below, draw the
the figure below. phasor diagram, Derive the condition for
E
the two branch currents, IL and IC, be in
quadrature.
N

4

-3A
ZO

I
V2 V3
V1 –+ IL IC
22V
3
RL RC
1
-8A
5 V ~
-25A L
C

Reference Node

[20 Marks] [15 Marks]

Call Us : 0141-2597591, +91-9828747676 ZONE TECH F-26/A Kisan Marg,Tonk Phatak, Jaipur
ZONE TECH Full Length Paper - II 3
Q.2 (c) Discuss the various types of transmission
(a) Explain the tests to be performed on a lines.
tranformer to determine the equivalent
circuit parameters of transformer. [10 Marks]
[20 Marks]

(d) Discuss the merits and demerits of a

(b) Explain various methods of starting of
synchronous motor. vacuum circuit breaker for low voltage
[10 Marks] applications.

CH
[10 Marks]
(c) Draw the characteristics of various types
of dc generator. Compare these
characteristics. Q.4
[30 Marks]

Q.3
(a) What are pumped storage plants?
TE
(a) What are magnetic materials? Give
classification of magnetic materials and
name some materials in each class.
Describe with neat sketches the principle
of operation of such a plant. Also, discuss
[30 Marks]
E
the role of the plant in a large
interconnected power system.
[20 Marks]
N

(b) A lamp having a Candle power of 300 in

all directions is provided with a reflector
(b) Determine the generation cost per unit
that directions 70% of total light
ZO

of energy from the following plant data:

Installed capacity  120 MW uniformly on a circular area 40 m
Capital cost of plant  Rs. 40000 per kW diameter. The lamp is hung at 15 m above
Interest and depreciation  15% the area. Calculate
Fuel consumption  0.64 kg/kWh
(i) The illumination
Fuel cost  Rs.1500 per 1000 kg
(ii) The illumination at the center
Salaries, wages, repairs and other
Operating costs per annum  Rs.50,000,000 (iii) The illumination at the edge of the
Peak load  100 MW surface without reflector.
Load factor  60%
[30 Marks]
[20 Marks]

Call Us : 0141-2597591, +91-9828747676 ZONE TECH F-26/A Kisan Marg,Tonk Phatak, Jaipur
ZONE TECH Full Length Paper - II 4
Q.5 Q.6

(a) Draw the output characteristics of a (a) Define the following terms:
common-emitter transistor. Show (i) Deflecting torque
various regions of operation of the BJT on
(ii) Voltmeter sensitivity
this characteristic. Describe the
(iii) Shading rings
application of operating the BJT into
different regions. (iv) Power factor

[20 Marks]

H
[30 Marks]

(b) Explain how a dynamometer type

C
(b) Find Q, bandwidth,  and I at resonance.
wattmeter can be used to measure power
in a circuit having low power factor.
0.25 1H 1F
TE [15 Marks]

V(t)=9sin t (c) Write a short note on A.C. bridge.

[15 Marks]
E

[20 Marks]
N

(d) Why C.T. sec. never be open circuited.

(c) Write short notes on Advantage of [10 Marks]

ZO

interconnection of power stations.

[10 Marks]

Call Us : 0141-2597591, +91-9828747676 ZONE TECH F-26/A Kisan Marg,Tonk Phatak, Jaipur