Scribd
Upload
5 views

Nadim Lab Rep

Faculty of Science and engineering

Uploaded by

Emon 01
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
5 views

Nadim Lab Rep

Faculty of Science and engineering

Uploaded by

Emon 01
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 9

Green University of Bangladesh

Depertment of EEE
Faculty of Science and engineering
Lab report

Experiment No: 2 and 3.

Experiment Name: Schemetic design of eletronic circuit,

Date of submission: 5 december 2022

Submitted by Submitted to
Azharul Islam Nadim Monjila afreen Dorothi
201901022 Lecturer
EEE-201 Dept of EEE
Dept of EEE
OBJECTIVE:
1.Familiar with the interface of electronic simulation
software Proteus 8
2.To draw basic circuit in Proteus window
3.To check circuit simulated output

List of Equipmet :
1. VSINE
2. TRAN-2P2S
3. 1N4007 (6)
4. CAP-ELEC (2) 220uf & 200p
5. 7801
6. MINERES5K1 (2) 100k & 220k
7. POT-HG 100K
8. BC547
9. G5CLE-1-DC12
10. TOURCH- LDR

Calculation

SCAMETIC PCB:
Discussion: This is the experiment design of a circuit
where we used many components in this experiment and
learned a lot about Proteus. we are Saw new components and
learned how to use PCB layout. While doing this experiment
we faced some problems with our values so we overcome it
by using voltage level detector equation.
Green University of Bangladesh
Depertment of EEE
Faculty of Science and engineering
Lab report

Experiment No: 4

Experiment Name: : Alphabet and Numerical Display


Using Proteous

Date of submission: 5 december 2022

Submitted by Submitted to
Azharul Islam Nadim Monjila afreen Dorothi
201901022 Lecturer
EEE-201 Dept of EEE
Dept of EEE
OBJECTIVE:
1. Familiar with Alphabet and Numerical display
2. Write suitable name for this Display

EQUIPMENT LIST:
1. 14SEG-MPX1-CA-GRN DISPLAY (3)
2. 555 Timer
3. Button
4. CAPACITOR
5. RESISTOR (2)

SCAMETIC PCB
Discussion: This is the experiment of alphabetic and
numerical display from this test.
In the said test my name is displayed on my display. When we
doing this test we faced some problem which is before
setting up 14 segment display.
Circuit We need to learn how to use this 14 segment display.
If we can do that, there will be no more
Circuit problems.

Green University of Bangladesh


Depertment of EEE
Faculty of Science and engineering
Lab report

Experiment No: 5

Experiment Name: Battery Voltage Level Indicator With


Proteous

Date of submission: 5 december 2022

Submitted by Submitted to
Azharul Islam Nadim Monjila afreen Dorothi
201901022 Lecturer
EEE-201 Dept of EEE
Dept of EEE
OBJECTIVE:
1. Familiar with the Battery Voltage level detector.
2.To see how this Detector works.
EQUIPMENT LIST:
1. BATTERY
2. LED GREEN
3. LED BLUE (3)
4. LED YELLOW (4)
5. LED RED (3)
6. LM3916
7. POT-HG 1k
8. RESISTOR (2) 18k & 2.2k
9. SIWTCH
SCAMETIC PCB:
Discussion: This experiment we have to seen battery voltage
level detector and learned how to use it. By using the RV1
we seen how can we detect the voltage level at 100% the
green light will lighted more lower the RV1 more lights will
be off.This experiment we have main problem those we
faced that is the PCB design because the lights are hard to
connect in PC so it took long time to connect the LED’s.

You might also like