Scribd
Upload
10 views

Console, VTY, SSH, IPv6, Inter-VLAN, OSPFv6 - Basic

Uploaded by

Parvej Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
10 views

Console, VTY, SSH, IPv6, Inter-VLAN, OSPFv6 - Basic

Uploaded by

Parvej Khan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Cisco Router Basic configurations - Console, VTY, SSH, IPv6, Inter-VLAN,

OSPFv6

Today I am going to talk about the basic configurations on Cisco routers


where i can define the basic commands like setting console password, assign
VTY password, configuring IP addresses on the interfaces, Configuring the
router for SSH access.

Configuring basic IPv6 configurations on the router, configuring trunk based


inter-VLAN routing, configuring IPv6 configurations manually and at last
configuring OSPFv6 with the use of IPv6.

This is a basic article for the starters who are going to configure the router
from the scratch. Most of the basic configurations are for demo purposes and
you can use your IP addresses as per requirements in your network. Let’s
start with the basic configurations on the router now.
Fig 1.1- basic Layer 3 LAN network Architecture

As in traditional environment, Above is the basic network topology where we


have 3 layer architecture with the firewalls and the routers. We are going to
configure WAN routers with the basic configurations

Configure the Basic router- Host-name, security password/Secret


Now let's configure the console password on the Cisco routers, below is the
basic example showing the configurations of console on router.

Setting up Console Password

So at this point of time, we rename router and set console password on the
cisco router, now let go with the VTY password on the Cisco router.

Assign VTY Password to the router

As of now, we set console password, configure VTY password and let's going
forward we will need to configure the IP addresses on the interfaces which is
defined as Connection to Cisco ASA 1 and Connection to Cisco ASA 2. Here ASA
is Cisco stateful Firewalls.

Configuring IP addresses on the interface


Although we configure IP address on the interfaces, we need to configure the
SSH access for the router

Configure the router for SSH Access

This is just an optional configuration, if you required IPv6 configuration on to


your Cisco devices as an example. Although you can configure IPv4 as well.

Configuring IPv6 on Cisco Router

Configuring Trunk-Based inter-VLAN routing on to the Cisco router.


Configuring OSPFv6 on Cisco routers as an example which has OSPF
configurations with IPv6 there.

Configuring OSPFv6 on Cisco routers

You might also like