0% found this document useful (0 votes)
14 views

ECU Power Source Circuit

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
14 views

ECU Power Source Circuit

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Inspection Procedure - Toyota Service Information 12/3/17, 12(58 am

Print Exit

THEFT DETERRENT / KEYLESS ENTRY THEFT DETERRENT SYSTEM ECU Power Source Circuit

DESCRIPTION

This circuit provides power to operate the body ECU.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:
· Inspect the fuses for circuits related to this system before performing the following procedure.
· w/ Door Control Battery:
As the door control battery is installed between the vehicle battery and body ECU, first perform the
inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before
performing this troubleshooting procedure.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION
· w/ Automatic Light Control System:
If the body ECU has been replaced, it is necessary to initialize the body ECU.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

https://toyotamanuals.com.au/docs/hilux-service-repair-man…RM100000000LWWS.html?PUB_TYPE=RM&MODE=3#RM100000000LWWS_04 Page 1 of 4
Inspection Procedure - Toyota Service Information 12/3/17, 12(58 am

a.

Front view of wire harness connector


*a (to Instrument Panel Junction Block
Assembly)

Disconnect the instrument panel junction block assembly connectors.

b. Measure the resistance according to the value(s) in the table below.


Standard Resistance:
Tester Specified
Condition
Connection Condition
2J-5 - Body
Always Below 1 Ω
ground

c. Measure the voltage according to the value(s) in the table below.


Standard Voltage:
Tester Specified
Condition
Connection Condition
2D-5 - Body Ignition switch
11 to 14 V
ground ON
2J-3 - Body
Always 11 to 14 V
ground

Result:
Proceed to
OK
NG

https://toyotamanuals.com.au/docs/hilux-service-repair-man…RM100000000LWWS.html?PUB_TYPE=RM&MODE=3#RM100000000LWWS_04 Page 2 of 4
Inspection Procedure - Toyota Service Information 12/3/17, 12(58 am

OK

2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

a. Remove the body ECU.


for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL

b. Measure the resistance according to the value(s) in the table below.

Component without harness connected


*a - -
(Instrument Panel Junction Block Assembly)

Standard Resistance:
Tester Specified
Condition
Connection Condition
2J-5 - A-1
Always Below 1 Ω
(GND)
2D-5 - A-7
Always Below 1 Ω
(IG)
2J-3 - A-6
Always Below 1 Ω
(BECU)

Result:
Proceed to
OK
NG (for LHD)
NG (for RHD)

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT


SYSTEM>PROBLEM SYMPTOMS TABLE

https://toyotamanuals.com.au/docs/hilux-service-repair-man…RM100000000LWWS.html?PUB_TYPE=RM&MODE=3#RM100000000LWWS_04 Page 3 of 4
Inspection Procedure - Toyota Service Information 12/3/17, 12(58 am

NG (for LHD)

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL

NG (for RHD)

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL

© 2012 TOYOTA MOTOR CORPORATION. All Rights Reserved.

https://toyotamanuals.com.au/docs/hilux-service-repair-man…RM100000000LWWS.html?PUB_TYPE=RM&MODE=3#RM100000000LWWS_04 Page 4 of 4

You might also like