Scribd
Upload
9 views19 pages

2 PN

Uploaded by

Boppana Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
9 views19 pages

2 PN

Uploaded by

Boppana Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 19

SKILL SESSIONS -2

Three-Story Plane Frame, Dynamic Response


Spectrum Analysis.

 Open the ETABS Program

1) Click the File menu > New model command

Fig-1

2)The next form of Building Plan Grid System and Story Data Definition will be displayed after you
select the NO button.

1
Fig-2

2
3) TO show the story properties Edit>Edit stories and Grid System> modify/Show story data

Fig-3

4)To change the units, On bottom right corner you see the units.

Fig-4

3
5)Define the design code using the Design > Concrete Frame Design command>View/review
refence

Fig-5

6) This will display the Concrete Frame Design Preference form as shown in the figure.

Fig-6

4
7) Click the Define menu > Material Properties

Fig-7

 Add New Material or Modify/Show Material used to define material properties

Fig-7.1

5
8) Define section columns and beams using Define >Section properties > Frame section>Add
new material properties

a) Create a Beam:

Fig-8.1(a)

 Reinforcement:

Fig-8.2(a)

6
b) Create a Column:

Fig-8.3(b)

 Reinforcement:

Fig-8.4(b)

7
9) Generate the model

Draw beam using Create Line Command and draw column using Create Column command

Fig-9

 Above creating option used to generate the model as shown in below figure:

Fig-9.1

8
10) Define various loads (Dead load, live load)

Fig-10

11)Load Combinations:

Fig-11

9
12) Assign support condition Drop-down box in the lower right-hand corner of the ETABS window,
Select only bottom single storey level to assign fixed support using Assign > Joint/Point>Restrain
(Support) command

Fig-12

 Select the fixed support

Fig-12.1

13) Dynamic Response Spectrum Analysis:

10
Fig-13

Fig-13.1

11
14) Run analysis from Analyse > Run Analysis command

Fig-14

 Shear force Diagram of Frame:

Fig-14.1

12
 Bending moment Diagram:

Fig14.2

13
15) Design of frame:

Fig-15

Fig-15.1

14
 Check weather the all member in frame are passed

Fig15.2

Fig-15.3

15
16)Design of column

16
17
17)Design of beam:

18
19

You might also like