Scribd
Upload
499 views1 page

Regulacion de Valvulas Motor Kubota V3307

Regulación de válvulas motor Kubota V3307

Uploaded by

Javier Yarleque
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
499 views1 page

Regulacion de Valvulas Motor Kubota V3307

Regulación de válvulas motor Kubota V3307

Uploaded by

Javier Yarleque
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CYLINDER HEAD (CONT'D) Valve Timing - Inspecting

Valve Clearance Adjustment (Cont’d) Figure 70-80-9

Figure 70-80-7 3 4
2

4 3 2 1

B 8 7 6 5 4 3 2 1 A

1 P-85974

B-05569
Stop the engine and open the rear door.

NOTE: (A) is the front cover side, (B) is the flywheel Remove the engine / hydrostatic pump package from the
housing side. loader. (See Engine Removal And Installation on Page
70-10-7.)
Figure 70-80-8
Remove the flywheel. (See Flywheel Removal And
Installation on Page 70-120-1.)
Cylinder Number 1 2 3 4
Remove the timing gearcase cover. (See Timing
Gearcase Cover Removal on Page 70-100-1.)
Valve Number 1 2 3 4 5 6 7 8
Make sure timing marks are in correct alignment [Figure
70-80-9].

Valve Injection Pump Gear (Item 1) [Figure 70-80-9].


I=Intake I E I E I E I E
E=Exhaust Idle Gear (Item 2) [Figure 70-80-9].

Crank Gear (Item 3) [Figure 70-80-9].

Cam Gear (Item 4) [Figure 70-80-9].


Adjust the valve clearance cold as follows:

0,13 - 0,17 mm (0.0052 - 0.0068 in) Intake & Exhaust

Use the following sequence to set the valves [Figure 70-


80-7] and [Figure 70-80-8]:

1. With the No. 1 cylinder set at compression top dead


center set valves 1,2,3 and 6.

2. With the No. 1 cylinder at overlap position set valves


4,5,7 and 8.

70-80-3 S650 Service Manual

You might also like