Bypass Valve
Bypass Valve
Altitude
PIP
Changes in the ambient temperature
-
202 059 1
Use the following procedure to adjust the exhaust bypass valve for local conditions.
1
10: /11/1 268 4
4
RE :24+ 6 8
N R 0
©2 935 4:00
0
Cat 1 C2 2
e r
Con pilla terpia
Illustration 1
fide r: llar g00814530
Inc
(1) Plug
ntia
(2) Locknut
(3) Adjustment screw
lG
1. Remove plug (1) and the seal. Loosen locknut (2).
.
ree
2. Turn adjustment screw (3) clockwise for approximately four turns in order to remove the function of the exhaust bypass valve. Be careful not
n
to tighten the screw too far.
3. Adjust the engine's exhaust emissions according to Systems Operation/Testing and Adjusting, "Air/Fuel Ratio Control - Adjust (Oxygen
Feedback)" or Systems Operation/Testing and Adjusting, "Air/Fuel Ratio Control - Adjust (NOX Feedback)".
4. After the desired exhaust emissions are obtained, turn adjusting screw (3) counterclockwise in order to obtain full load operation with a
throttle angle of approximately 70 degrees.
5. When the operation is satisfactory, tighten locknut (2) to the torque that is listed in the engine's Specifications.
DLR1-UP, GNS1-UP, N2M1-UP, N2N1-UP, N2P1-UP, N6A1-UP, N6B1-UP, N6C1-UP, N8A1-UP, N8B1-UP, WPM1-UP, WPN1-UP, WPP1-UP,
WPR1-UP, WPS1-UP, WPT1-UP, WPW1-UP
PIP-10594268
2021/11/18
10:45:33+04:00
i02789694
© 2021 Caterpillar Inc.
Caterpillar:
Confidential Green