Downloaded from www.studiestoday.

com
1

SURE SHORT QUESTIONS FOR CLASSXII (PHYSICS)

2 MARKS QUESTIONS
1 A point charge is placed at the centre of spherical Gaussian surface. How will electric flux E
change if
(i) The sphere is replaced by a cube of same or different volume,
(ii) A second charge is placed near, and outside, the original sphere,
(iii) A second charge is placed inside the sphere, and
(iv) The original charge is replaced by an electric dipole?
Ans. (i) doesn't change . E independent of shape / size
(ii) doesn't change ,
(iii) change ,
(iv) zero
2 A parallel plate capacitor with plates of area A and separation d is charged to a potential
difference V and the battery used to charge is disconnected. A dielectric slab of thickness d and
dielectric constant K is now placed between the plates. Explain changes, if any, in the charge,
potential difference, capacitance, electric field and energy stored in the capacitor.
Ans. (i) q remains unchanged
(ii) V decreases
1
(iii) C increases C 
V
V
(iv) E = , decreases
d
1
(v) U = qV2, decreases
2

3 An electric dipole is held in uniform electric field

(i) Show that no translator force
acts on it.
(ii) Derive an expression for he
torque acting on it
Ans. Force on +q charge=qE along direction of E
Force on –q charge =qE opposite to E
Fnet=qE-qE =0
The forces are equal in magnitude, opposite in direction acting at different points,
therefore they form a couple which rotates the dipole.
Torque 𝜏 = 𝐹 × 𝑝𝑒𝑟𝑝. 𝑑𝑖𝑠𝑡𝑎𝑛𝑐𝑒
𝜏 = 𝐹 × 𝑑𝑠𝑖𝑛𝜃 = 𝑞𝐸 × 𝑑𝑠𝑖𝑛𝜃 = (𝑞𝑑)𝐸𝑠𝑖𝑛𝜃
𝜏 = 𝑝𝐸𝑠𝑖𝑛𝜃 𝑂𝑟 𝜏 = 𝑝 × 𝐸

4 1. How does the resistivity of (i) a conductor and (ii) a semiconductor vary with
temperature? Give reasons.
m 1 1
Ans: ρ = 2
 ρα and ρ α
ne  n 

Downloaded from www.studiestoday.com

 Downloaded from www.studiestoday.com
2

(i) For a conductor, the density of free e’s is almost independent of temperature but the
frequency of collision of e’s increases with increase in temperature. Therefore the
relaxation time decreases. Hence the resistivity of a conductor increases with increase in
temperature (conductivity decreases).
(ii) On increasing the temperature of a semiconductor, the density of free e’s increases and
the relaxation time decreases. But the increase in ‘n’ is large than the decrease in ‘τ’.
Hence the resistivity of a semiconductor decreases with increase in temperature
(conductivity increases).

5 Define the term resistivity and write its SI unit. Derive the expression for the resistivity of a
conductor in terms of number density of free electrons and relaxation time.
A: The resistivity of a material is equal to the resistance of the unit cube of that material. SI
unit – ohm metre.
eE eV
I  neAv d
---------- (1) Vd = τ = τ ---------(2)
m ml
2
ne A V m l
Putting the value of vd in (1), I  V  R   2
-------- (3)
ml I ne  A
l m
Resistance R = ρ ------ (4), comparing (3) & (4), ρ= 2
A ne 
6 Two students ‘X’ and ‘Y’ perform an experiment on potentiometer separately using the circuit
given. Keeping other parameters unchanged, how will the position of the null point be affected it
(i) ‘X’ increases the value of resistance R in the set-up by keeping the key K1 closed and the key K2
open? (ii) ‘Y’ decreases the value of resistance S in the set-up, while the key K2 remain open and
the key K1 closed? Justify.

A: (i) By increasing resistance R the current through AB decreases, so potential gradient

decreases. Hence a greater length of wire would be needed for balancing the same
potential difference. So the null point would shift towards B.
(ii) By decreasing resistance S, the current through AB remains the same, potential gradient
does not change. As K2 is open so there is no effect of S on null point.
7 Define the term magnetic dipole moment of a current loop. Write the expression for the
magnetic moment when an electron revolves at a speed ‘v’, around an orbit of
radius ‘ r’ in hydrogen atom.
Ans: Magnetic moment of a current loop:
M = NIA
i.e., magnetic moment of a current loop is the product of number of turns, current flowing
in the loop and area of loop. Its direction is perpendicular to the plane of the loop.
Magnetic moment of Revolving Electron, M = evr/2

Downloaded from www.studiestoday.com

 Downloaded from www.studiestoday.com
3

8 The following figure shows the variation of intensity of magnetization I versus the applied
magnetic field intensity H for two magnetic materials A and B.
(1) Identify the materials A and B
(2) Draw the variation of susceptibility with temperature for B.

Ans: 1) A is paramagnetic material.

B is diamagnetic material.
2)

9 How does the self induction of a coil change when?

(1) The number of turns in a coil is decreased
(2) An iron rod is introduced into it. Justify.
2
Ans. (1) L = n lA
When no. of turns decreases self induction will decrease.
(2) When iron rod is introduced
2
L n lAr
Since for iron r 1
Self induction will increase
10 An inductor L of reactance XL is connected in series with a bulb B to an a.c. source as
shown in the figure.

Briefly explain how does the brightness of the bulb change when
(a) Number of turns of the inductor is reduced.
(b) A capacitor of reactance XC = XL is included in series in the same circuit.

Downloaded from www.studiestoday.com

 Downloaded from www.studiestoday.com
4

Ans.

11 What are optical fibres? Give their one use?

Ans. Optical fibres consist of thin and long strands of fine quality glass or quartz coated
with a thin layer of material of refractive index less than the refractive index of strands.
They work on the principle of total internal reflection so they do not suffer any loss.
Uses
The optical fibres are used in medical investigations i.e. one can examine the inside view
of
stomach and intestine by a method called endoscopy.
12 In young’s double slit experiment how is the fringe width change when
(a) Light of smaller frequency is used
(b) Distance between the slits is decreased?
Ans.

13 Suppose the electric field part of an electromagnetic wave is given by

E = (3.1 N/C) cos [(1.8 rad/m) y + (5.4 X106 rad/s) t ] i
(i) What is the direction of propagation?
(ii) what is the wavelength 𝜆 ?
(iii) what is the frequency 𝜈 ?
(iv) what is the amplitude of the magnetic field part of the wave ?
Ans. (i) - j (ii) 𝜆 = 3.5 m
(iii) 𝜈 = 86 X 106 HZ
(iv) B = 10-11 cos [(1.8 rad/m) y + (5.4 X106 rad/s) t ]

Downloaded from www.studiestoday.com

 Downloaded from www.studiestoday.com
5

14 Write two points of difference between interference and diffraction?

Ans.

15 How the angular separation and visibility of fringes in Young will’s double slit experiment
change when (i) screen is moved away from the plane of the slits, and (ii) width of the
source slit is increased?
Ans. (i) Angular separation = β/D = λ/d It is independent of D; therefore, angular
separation remains unchanged if screen is moved
away from the slits. But the actual separation between fringes β = Dλ/d increases, so
visibility of fringes increases.
(ii) When width of source slit is increased, then the angular fringe width remains
unchanged but fringes becomes less and less sharp; so visibility of fringes decreases. If
the condition s/S =λ/d is not satisfied, the interference pattern disappears.

16 Draw a labelled ray diagram of a reflecting telescope. Mention its two advantages over
the refracting telescope.
Ans:Ray diagram

Advantages:
(i) It is free from chromatic and spherical aberrations.
(ii) Its resolving power is greater than refracting telescope due to larger aperture of
mirror.

17 State the laws of photoelectric emission.

Ans. Laws of photoelectric emission. On the basis of the experimental results on
photoelectric effect, Lenard and Millikan gave the following laws of photoelectric
emission:

Downloaded from www.studiestoday.com

 Downloaded from www.studiestoday.com
6

1. For a given photosensitive material and frequency of incident radiation, (above the
threshold frequency), the photoelectric current is directly proportional to the intensity of
light. The saturation current is directly proportional to the intensity of incident radiation.

2. For a given photosensitive material, there exists a certain minimum cut off
frequency below which no photoelectrons are emitted, howsoever high is the intensity of
incident radiation. This frequency is called threshold frequency.

3. Above the threshold frequency, the stopping potential or equivalently the

maximum kinetic energy of the photoelectrons is directly proportional to the frequency of
incident radiation, but is independent of its intensity.

4. The photoelectric emission is an instantaneous process. The time lag between the
incidence of light radiation and the emission of photoelectrons is very small, even less
than 10-9 s.

18 Assume that the frequency of the radiation incident on a metal plate is greater than
its threshold frequency. How will the following change, if the incident radiation is
doubled?
(1) Kinetic energy of electrons
(2) Photoelectric current
Ans. (1) If the frequency of the incident radiation is doubled hv hv0 is increased,
hence kinetic energy is increased.
(2) If the frequency of the incident radiation is doubled there will be no change in
the number of photoectrons i.e. photo electronic current.

19 An electron and an alpha particle have the same De Broglie wavelength associated
with them? How are their kinetic energies related to each other?
Ans.

20 State the limitations of Bohr’s atomic model?

Ans. (1) It does not give any indication regarding the arrangement and distribution
of electrons in on atom.
(2) It could not account for the wave nature of electrons.

Downloaded from www.studiestoday.com

 Downloaded from www.studiestoday.com
7

21 A radioactive nucleus undergoes a series of decay according to the scheme

If the mass number and atomic number of A are 180 and 72 respectively, what are there
number for A4?
Ans.

22 For a extrinsic semiconductor, indicate on the energy band diagram the donor and
acceptor levels
Ans.

23 In the following diagrams indicate which of the diodes are forward biased and which are
reverse bias?

Ans. (a) forward bias (b) Reverse bias

24 Determine the currents through resistance R of the circuits (i) and (ii) when similar
diodes D1 and D2 are connected as shown in the figure.

Downloaded from www.studiestoday.com

 Downloaded from www.studiestoday.com
8

Ans. In figure (i) D1 and D2 are forward biased

In figure (ii) D1 is forward biased but D2 is reverse biased due to which D1 & D2 offers
infinite resistance
I 0
25 In the given block diagram of a receiver identify the boxes labelled as X and Y also write
their functions.

Receiving Amplifier X Detector Y Output

Antenna Received
Signal
Ans: X is Intermediate frequency (IF) stage, Y is power amplifier
IF stage changes the high frequency of carrier wave curve into lower frequency and
amplifier enhances the strength for the signals.
26. Write two factors justifying the need of modulation for transmission of a signal.
Ans: (i) The transmission of low frequency signal needs antenna of height 4-5 km which
is impossible to construct. So there is need to modulate the wave in order to reduce the
height of antenna to a reasonable height.
(ii)Effective power radiated by antenna for low wavelength or high frequency wave as
pα(l/λ2).
27. Identify the logic gates marked ‘P’ and ‘Q’ in the given circuit. Write the truth table for the combination.

Ans. P in NAND Gate and Q is OR Gate

Truth table :

28. State Kirchhoff s rules. Explain briefly how these rules are justified.
Sol. Kirchoff’s Current (Junction) rule: At any junction, the sum of the currents entering the
junction is equal to the sum of current leaving the junction.When currents are steady, there is no
accumulation of charge at any junction or at any point in a line. This is based on the conservation
of charge.
Kirchoff loop rule: The algebric sum of changes in potential difference across all the elements
in any closed loop involving resistors and cells is zero. This law is based on the conservation of
energy.

Downloaded from www.studiestoday.com