Scribd
Upload
6 views

Tech Graphics Paper2 2009

Academic notes

Uploaded by

nokutendakawanzas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
6 views

Tech Graphics Paper2 2009

Academic notes

Uploaded by

nokutendakawanzas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 9
SHEET 1 OF 4 SECTION A Answer any five questions from this section. (a) Locknuts (b) Standard nut and spring washer (© Taper pin 1 Draw conventionally the following locking devices: Jocknuts; standard nut and spring washer, and taper pin. (6) ZIMBABWE SCHOOL EXAMINATIONS COUNCIL General Certifiate of Education Ordinary Level ‘TECHNICAL GRAPHICS 704972 PAPER 2 Mechanical Drawing NOVEMBER 2009 SESSION 3 hours LOZIMSECN2009 TIME 3 hours Instructions to Candidates Print your name, Centre number and candidate number in the [Answer five questions from Section A in the spaces provided All answers should be drawn accurately with instruments unle ‘The number of marks is given in brackets [ ] at the end of eact Drawing aids may be used. Colour should only be used if ask 2 Views of a cast iron bracket are shown in Figure 1. Project the section B-B. (61 o » A For Examiner's Use SHEET 7 2 7 Ponca 7 paces provided Candidate's Name “nd all of Section Bon sheet - | Centre Number ... S otherwise stated Soewton orpartquestin, | Candidate's Number facet ge 4 for in the question. arias 3 Orthographic views of a forked bracket are given in Figure 2. Draw freehand, an isometric view of the bracket with point C as the lowest point. [6] 618 R18 20 | tied af | 8 a oe 10 | a7 a -E-}+ 4 Figure 3 shows a plan and elevation of a slotted link. Project an end view looking from the direction of arrow Q. 1 ey : : : Hl Q : : toy oad Fig. 3 (6) SHEET 2 OF 5 5 Anincomplete section of a block assembly is shown in Figure 4. (@) Complete the section by adding an M8 square head retaining screw along centre X to hold the bush in position, (b) Complete the parts list in Table 1. (6) fa) Yj Nzx

You might also like