Scribd
Upload
12 views

JSS 3 Basic Tech

Uploaded by

Emmanuel Uba
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
12 views

JSS 3 Basic Tech

Uploaded by

Emmanuel Uba
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

IDEAL HIGH SCHOOL

47 PALM STREET, CALABAR


FIRST TERMINAL EXAMINATION 2024/2025 ACADEMIC SESSION
SUBJECT: BASIC TECHNOLOGY CLASS: JSS 3
TIME: 1 HOUR 30 MIN

SECTION A: OBJECTIVES (ANSWER ALL QUESTION)

1. A process of enlarging or reducing the size of drawing is known as


a) Free hand sketch b) isometric drawing c) orthographic drawing c) scale drawing
2. Drawing paper is placed squarely on the drawing board with the aid a) tee — square b) scale
rule c) ruler d) hands
3. To measure and draw various angles you need a a) template b) set square c) protractor d) French curve
4. The type of maintenance carried out by a man who often sends his car for serving is known as
a) correction b) predictive c) preventive d) detective
5. A regular polygon with nine sides is called a) hexagon b) heptagon c) decagon d) nonagon
6. Scale rules are used to produce a) reduced or enlarged size b) equal and normal size of drawing c)
enlarged size of drawing only d) a good linear drawing
7. We can take care of our drawing boarding by a )keeping it inside the locker b) keeping it on the
floor c) washing with soap and water d) avoiding scratches on the surface
8. The purpose of maintenance in engineering equipment is to a) keep it in good working condition always
b) prevent it from making loud noise c) stop it from working too long d) enable it to last for ever
9. is used to make holes in wood or metal a) Hack saw b)
rip saw c) drill c) spoke shave
10. Hack saw is used to cut a) wood b) metal c) plastic d) clothes
is used for determining angle at various degrees a) protractors b) steel rule c) micrometer d)
steel tape
11. are called coniferous wood is a) soft wood b) cheap wood c) wet wood d) dry wood
12. Wood can be classified into and a) Hard wood and wet wood b) soft wood and wet
wood c) Hard wood and soft wood d) wet and dry wood
13.
THEORY
ANSWER FOUR (4) QUESTIONS ONLY
Use all the necessary drawing instruments and in mm, Marks will be awarded for good draughtsman ship
and show all the construction lines.
1. Draw the block below in isometric projection

2. Define wood conversion


2b. mention the two methods of wood conversion
2c. list five reasons for seasoning wood
2d. list five reasons for seasoning wood

3. What is an alloy?
3b. state three examples of alloy ferrous metals and mention (2) practical uses of each.
3c. differentiate between ferrous metals and non-ferrous metals.
3d. in a tabular form, mention two example of ferrous alloys and non-ferrous alloys, state their components,
properties and uses.

4. Mention the five methods of processing plastics material.


4b. what is calendaring?
4c.state two advantages of rubber over plastic.
4d.state the importance of isometric drawing.
.
5. Determine the moisture content of a particular type of wood where the weight of wet sample of the wood
is 60 and dry sample is 20. Calculate the moisture content of the wood.
5b. what do you understand by defects in wood.
5c. Defects in wood are classified into two, list and briefly explain them

You might also like