Scribd
Upload
26 views

MAGCAWAS - 2.9.1 Packet Tracer

Uploaded by

mgcwsqm
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
26 views

MAGCAWAS - 2.9.1 Packet Tracer

Uploaded by

mgcwsqm
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Packet Tracer - Basic Switch and End Device Configuration

Magcawas, Queenie Marie O.


CPE3A

Addressing Table
Device Interface IP Address Subnet Mask

ASw-1 VLAN 1 10.10.10.100 255.255.255.0


ASw-2 VLAN 1 10.10.10.150 255.255.255.0
User-01 NIC 10.10.10.4 255.255.255.0
User-02 NIC 10.10.10.5 255.255.255.0

Objectives
 Configure hostnames and IP addresses on two Cisco Internetwork Operating System (IOS) switches
using the command-line interface (CLI).
 Use Cisco IOS commands to specify or limit access to the device configurations.
 Use IOS commands to save the running configuration.
 Configure two host devices with IP addresses.
 Verify connectivity between the two PC end devices.

Scenario
As a recently hired LAN technician, your network manager has asked you to demonstrate your ability to
configure a small LAN. Your tasks include configuring initial settings on two switches using the Cisco IOS and
configuring IP address parameters on host devices to provide end-to-end connectivity. You are to use two
switches and two hosts/PCs on a cabled and powered network.

Instructions
Configure the devices to fulfill the requirements below.

Requirements
 Use a console connection to access each switch.
 Name ASw-1 and ASw-2 switches.
 Use the 8ubRu password for all lines.
 Use the C9WrE secret password.
 Encrypt all clear text passwords.
 Configure an appropriate message-of-the-day (MOTD) banner.
 Configure addressing for all devices according to the Addressing Table.
 Save your configurations.
 Verify connectivity between all devices.
 2013 - 2024 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 1 of 4 www.netacad.com
Packet Tracer - Basic Switch and End Device Configuration

Note: Click Check Results to see your progress. Click Reset Activity to generate a new set of requirements.
If you click on this before you complete the activity, all configurations will be lost.
End of Document

 2013 - 2024 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 2 of 4 www.netacad.com
Packet Tracer - Basic Switch and End Device Configuration

 2013 - 2024 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 3 of 4 www.netacad.com
Packet Tracer - Basic Switch and End Device Configuration

 2013 - 2024 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 4 of 4 www.netacad.com

You might also like