Scribd
Upload
20 views1 page

Backlight Circuit A1466

Uploaded by

marc dubert
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
20 views1 page

Backlight Circuit A1466

Uploaded by

marc dubert
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

When troubleshooting backlight circuit, the output voltage is important.

Different voltages tell you different things.

On an air, 39-49v means that the backlight boost circuit is working, but there
is no load - aka, it doesn't "See" the light of the screen. Once there is a load
on the circuit, like the light of the screen, the voltage will go down. This can
be caused by bad LCD connector, bad LCD cable, LCD backlight cable being
plugged in upside down(most common one), bad LED strip in the screen.

25-27v means backlight is working and we are just blind.

18-20v means that the boost circuit is partially working. This is usually
missing BKL_PWM signal, or bad LED driver. BKL_PWM sets the brightness on
the screen. If the LED driver is working but PWM is too low, there will be
voltage boost, but it will be just below the threshold required to light the
screen. Sometimes BKL_PWM is missing because the brightness down key is
stuck down(liquid on keyboard), sometimes this is missing because the
machine is fucked(you can just send pp3v3_s0 to the bkl_pwm line if it is
missing to tell it to stay on at full brightness), sometimes the LED driver is
shorting it to ground.

If you have 8.5v on backlight, that means no boosting is occurring. This can
be bad LED driver, this can be feedback line from backlight output to ball A5
of the LED driver for feedback being destroyed(VERY COMMON). Also BKL_EN
voltage divider being bad - you need at least 2.7v on BKL_EN or you get no
boosting and wind up with 8.5v on backlight, which is just PPBUS_G3H being
passed through the circuit.

If you have anything below 8.5v it could be a number of things. Here, if we


have 0 volts, the first thing to determine is if we can actually see an IMAGE on
the screen. If the computer does not detect the screen properly, and does not
display an image, our issue is image/screen recognition, not backlight. The
computer is smarter than an iPad, it won't send backlight out if the screen is
fucked. So do you see a picture?

If you do have 0v, it is often a short to ground on the line, or dead fuse, or
blown via/trace somewhere in the boost circuit. See on the top of my picture
where L9701 goes to D9701 which goes to output? If there is a break
anywhere in that line, you get 0v on output, OR soemthing like 1.2v, or
0.125v, or some really low shit because the via is broken and making
intermittent contact.

Either way, in order to start properly troubleshooting what is going on, we


need way more information. I have also attached pictures of some common
backlight faults. Again, don't make fun of me and microsoft paint, it's all I

got it works for GradeAUnderA!!

You might also like