Scribd
Upload
34 views2 pages

DTC P1380

Was ddjs

Uploaded by

jim382828
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views2 pages

DTC P1380

Was ddjs

Uploaded by

jim382828
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ENGINE (DIAGNOSTICS)(H4DOTC DIESEL) > Diagnostic Procedure with Diagno...

Page 1 of 2

ENGINE (DIAGNOSTICS)(H4DOTC DIESEL) > Diagnostic Procedure with


Diagnostic Trouble Code (DTC)
DTC P1380 GLOW RELAY CIRCUIT (LOW)
DTC DETECTING CONDITION:
Detected when two consecutive driving cycles with fault occur.
TROUBLE SYMPTOM:
• Hard to start
• White smoke emitted when engine is cold.
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode and
Inspection Mode .
WIRING DIAGRAM:

STEP CHECK YES NO


1.CHECK POOR Is there poor Repair the poor
CONTACT. contact in ECM contact of the ECM
Check for poor contact connector, main connector, main fuse
in ECM connector, main fuse box connector box connector or
fuse box connector and or glow relay glow relay
glow relay connector. connector? connector.
2.CHECK HARNESS Is the resistance 1 In this case, repair or
BETWEEN GLOW MΩ or more? replace the following
RELAY CONNECTOR item:
ENGINE (DIAGNOSTICS)(H4DOTC DIESEL) > Diagnostic Procedure with Diagno... Page 2 of 2

STEP CHECK YES NO


AND GLOW PLUG • Short circuit to
CONNECTOR. ground in harness
1) Turn the ignition between glow relay
switch to OFF. connector and glow
2) Remove the glow plug connector
relay. • Short circuit to
3) Disconnect the ground in harness
connectors from ECM between ECM
and all glow plugs. connector and glow
4) Measure the relay connector
resistance between • Blown out of glow
glow relay connector fuse
and engine ground.
Connector &
terminal
(F9) No. 9 — Engine
ground:
3.CHECK HARNESS Is the resistance 1 In this case, repair or
BETWEEN ECM AND MΩ or more? replace the following
GLOW RELAY item:
CONNECTOR. • Short circuit to
Measure the resistance ground in harness
between ECM connector between ECM
and chassis ground. connector and glow
Connector & terminal relay connector
(B134) No. 34 — • Blown out of fuse
Chassis ground: (relay block)
(B134) No. 73 —
Chassis ground:
4.CHECK HARNESS Is the resistance Repair the open
BETWEEN ECM AND less than 1 Ω? circuit of harness
GLOW RELAY between ECM
CONNECTOR. connector and glow
Measure the resistance relay connector.
of harness between ECM
connector and glow
relay connector.
Connector & terminal
(B134) No. 34 — (F9)
No. 10:
(B134) No. 73 — (F9)
No. 9:
5.CHECK HARNESS Is the resistance Repair the open
BETWEEN GLOW less than 1 Ω? circuit in harness
RELAY CONNECTOR between glow relay
AND ENGINE connector and chassis
GROUND. ground.
Measure the resistance
of harness between glow
relay connector and
engine ground.
Connector & terminal
(F9) No. 11 — Engine
ground:
6.CHECK GLOW PLUG. Are all glow plugs Replace the glow Replace the faulty
Check all glow plugs. normal? relay. glow plug.

You might also like