Scribd
Upload
16 views

Program 1

Uploaded by

lakshgupta75009
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
16 views

Program 1

Uploaded by

lakshgupta75009
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

EXPERIMENT No.

Aim: To learn handling and configuration of networking hardware like RJ45 connector,
CAT6 cable, crimping tool etc.

Resources Required:
Hardware Requirements: RJ45, CAT cables, Crimping Tool, Printer, and Internet Connection.
Software Requirements: Cisco Packet Tracer.

Theory:
RJ45 (Registered Jack): RJ45 (Registered Jack) connector is used for connect the ALL HMI
and engineer station through a switch to communicated each other. It is used to download the
any modification and which is made in graphics in engineering station.RJ45 cable also used
for communicate the printer with computer. There are four pairs of wires in an Ethernet cable,
and an Ethernet connector (8P8C) has eight pin slots. Each pin is identified by a number,
starting from left to right, with the clip facing away from you.

There are two kinds of Ethernet cable is used for communication.


1. Straight Through
2. Cross over cable

STRAIGHT THROUGH CABLE: STRAIGHT THROUGH Ethernet cables are the


standard cable used for almost all purposes, and are often called “patch cables”. It is highly
recommendedyou duplicate the color order as shown on the left. Note how the green pair is
not side-by-side as areall the other pairs. This configuration allows for longer wire runs.
CROSSOVER CABLES:
The purpose of a Crossover Ethernet cable is to directly connectone computer to another
computer (or device) without going through a router, switch or hub.

CAT Cables:
The Cat, as you might know, is short for "Category." The term "Category" refers to the
differentlevels of performance in signal bandwidth, attenuation and crosstalk associated with
each cable'sdesign. Category 1 cablesare a 2-pair
2 pair copper UTP designed for POTS (plain old
telephonesystems). CAT 6 is currently the most commonly used cable, mainly due to its low
productioncost and support for spe
speeds faster than Cat 5 cables.
A CAT 6 cable has a bandwidth capacity of 250 MHz, for example, and it offers you speeds
of up to 10 Gbps. It's also compatible with both C
CAT5 and CAT5E
5E cables. A CAT6
C cable is
used mainly for computer networks reaching a GB, 1000
1000 Mbps or one Gbps of data transfer
speed (DTR) or higher.
CRIMPING TOOL:
Crimpers are tools used to make cold weld joints between two wires or a wireand
aconnector, such as lugs. Ideally, the electrical and mechanicalproperties of the weld
joint are as strong as the parent materials. Crimpingtools are sized according to the wire
gauges (using AWG - American WireGauge) they can accept. Some come with
interchangeable die heads that allow for a wider range of wire sizes and connectors.
How to use: First you will need to strip the length of wire that you want to crimp. Then,
attach the connector. For crimping tools with interchangeable dies, you will need to select the
right die head for the connector by matchingwire gauge ratings. For diesels crimpers, you will
need to match to theproper groove. Finally, apply pressure, take out the newly crimped
connector, and give a few tugs to make sure you have a solid and secure connection.

CONCLUSION:
Hence, we have implemented RJ45 and CAT cabling and connection using crimping tool.

You might also like