Scribd
Upload
57 views3 pages

Pre Test Eim NC II Prepared by Ophir M Aycocho Rece Rme Epas Eim Pvsi Ncii Trainer

Uploaded by

John Carlo Bacalando
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
57 views3 pages

Pre Test Eim NC II Prepared by Ophir M Aycocho Rece Rme Epas Eim Pvsi Ncii Trainer

Uploaded by

John Carlo Bacalando
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

PRE-TEST EIM NC-II

1. Which of the following is not a type of 10. An open circuit occurs in a wiring system
service disconnect? when .
a. Knife blade switch b. Fuse block a. the system is working properly
c. Circuit Breakers d. Bus Bar b. a conductor is broken or separated
2. If a grounded conductor is attached to the c. a fuse is installed d. None of the
disconnect switch, which type of service
disconnect must be used? above CDA Practice Test

a. Circuit breakers b. Knife Blade Switch 11. Short circuits or grounds can be all of the
following except .
c. Fuse Block d. None of the above
a. Solid b. Partial
3. What is the most frequently used wire size for
interior wiring? c. Floating d. Contracted

a. 10 AWG b. 12 AWG 12. Which phase is probably open when you


test Phase A and Phase B and get a low voltage
c. 15 AWG d. 18 AWG reading, test Phase B and C and get a normal reading
and test Phase A and C and get a low voltage reading?
4. If you have four to six 12 AWG wires in a
conduit, what would be the allowable current-carrying a. Phase A b. Phase B
capacity in percentage to the normal?
c. Phase C d. None of the above
a. 50% b. 60%
13. In residential buildings, small appliance
c. 70% d. 80% loads should have two or more .
5. If a box is to contain four No. 10 conductors a. 15 ampere branch circuits
and two No. 12 conductors, what is the minimum
sized box that can be used in cubic inches? b. 20 ampere branch circuits

a. 12 b. 13 1/2 c. 40 ampere branch circuits

c. 14 1/2 d. 15 d. 50 ampere branch circuits

6. A run of electrical conduit may not have more 14. What law would you use to determine the
than quarter bends between fittings and outlets? voltage of a power supply?

a. 2 b. 3 a. Coulomb's Law b. Kirchhoff’s Law

c. 4 d. 5 c. Ohm's Law d. None of the above

7. The total load on any single overcurrent 15. Ohm's law states .
device in a panelboard must not exceed 80 percent of
its capacity where the load continues for 3 or more a. Voltage = amps x resistance
hours to avoid overheating of the conductor.
b. Voltage = current / resistance
True False
c. Voltage = watts x current
8. A fuse should be rated higher than the lowest
rated component in a panelboard to be protected. d. Voltage = current/watts

True False e. None of the above

9. Which of the following locations would most 16. The amount that a given conductor resists
likely require installation of a ground fault circuit the flow of electric current is measured in .
interrupter?
a. Watts b. Volts
a. living room b. closet
c. Iambs d. Coulombs
c. bedroom d. bathroom
e. Ohms
17. Which law holds that like-charged objects
repel and opposite- charged objects attract?

a. Coulomb's Law b. Kirchoff's Law

c. Ohm's Law d. None of the above

18. Direct current can change direction.

True False

19. Alternating current changes direction at


which of the following frequencies?

a. 40 Hz b. 50 Hz

c. 60 Hz d. 70 Hz

e. None of the above

20. Electron Theory and Conventional Theory


hold opposite current flow directions.

True False

21. Which of the following will not affect the


resistance of a circuit?

a. Length of the Conductor

b. Diameter of the Conductor

c. Insulation of the Conductor

d. Temperature

e. Physical Condition

22. The greater the resistance, the more power


is dissipated in the form of heat energy.

True False

23. Which of the following are a source of


electricity?

a. Friction b. Heat

c. Light d. Pressure

e. Chemical action

f. All of the above

24. In a series circuit, the current has


path(s) to take.

a. 1 b. 2

c. 3 d. 4

e. 5

25. When connecting a voltmeter lnto a DC


circuit, what should be observed?

a. Power Factor b. Rms

c. Resistance d. Polarity
ANSWER KEY;
1. D
2. C
3. B
4. D
5. C
6. C
7. TRUE
8. FALSE
9. D
10. B
11. D
12. A
13. B
14. C
15. A
16. E
17. A
18. FALSE
19. C
20. TRUE
21. C
22. TRUE
23. F
24. A
25. D

You might also like