Circle PDF Ncert
Circle PDF Ncert
d
he
CIRCLES 10
is
10.1 Introduction
bl
You have studied in Class IX that a circle is a collection of all points in a plane
which are at a constant distance (radius) from a fixed point (centre). You have
also studied various terms related to a circle like chord, segment, sector, arc etc.
pu
Let us now examine the different situations that can arise when a circle and a line
are given in a plane.
be T
So, let us consider a circle and a line PQ. There can be three possibilities given
in Fig. 10.1 below:
re
o R
tt E
C
no N
Fig. 10.1
©
In Fig. 10.1 (i), the line PQ and the circle have no common point. In this case,
PQ is called a non-intersecting line with respect to the circle. In Fig. 10.1 (ii), there
are two common points A and B that the line PQ and the circle have. In this case, we
call the line PQ a secant of the circle. In Fig. 10.1 (iii), there is only one point A which
is common to the line PQ and the circle. In this case, the line is called a tangent to the
circle.
You might have seen a pulley fitted over a well which is used
in taking out water from the well. Look at Fig. 10.2. Here the rope
on both sides of the pulley, if considered as a ray, is like a tangent
to the circle representing the pulley.
d
Is there any position of the line with respect to the circle
other than the types given above? You can see that there cannot
he
be any other type of position of the line with respect to the circle.
Fig. 10.2
In this chapter, we will study about the existence of the tangents
to a circle and also study some of their properties.
is
In the previous section, you have seen that a tangent* to a circle is a line that
intersects the circle at only one point.
bl
To understand the existence of the tangent to a circle at a point, let us perform
the following activities:
Activity 1 : Take a circular wire and attach a straight wire AB at a point P of the
pu
circular wire so that it can rotate about the point P in a plane. Put the system on a table
and gently rotate the wire AB about the point P to get different positions of the straight
wire [see Fig. 10.3(i)].
be T
with the point P in the position A′B′ of A′′B′′. Again note, what happens if ‘AB’ is
rotated rightwards about P? The common point R3 gradually comes nearer and nearer
to P and ultimately coincides with P. So, what we see is:
The tangent to a circle is a special case of the secant, when the two end
points of its corresponding chord coincide.
*The word ‘tangent’ comes from the Latin word ‘tangere’, which means to touch and was
introduced by the Danish mathematician Thomas Fineke in 1583.
d
the chord cut by the lines will gradually
decrease, i.e., the two points of intersection of
the line and the circle are coming closer and
he
closer [see Fig. 10.3(ii)]. In one case, it
becomes zero on one side of the secant and in
another case, it becomes zero on the other side
of the secant. See the positions P′Q′ and P′′Q′′
is
of the secant in Fig. 10.3 (ii). These are the
tangents to the circle parallel to the given secant
PQ. This also helps you to see that there cannot Fig. 10.3 (ii)
bl
be more than two tangents parallel to a given
secant.
pu
This activity also establishes, what you must have observed, while doing
Activity 1, namely, a tangent is the secant when both of the end points of the
corresponding chord coincide.
be T
The common point of the tangent and the circle is called the point of contact
re
[the point A in Fig. 10.1 (iii)]and the tangent is said to touch the circle at the
o R
common point.
Now look around you. Have you seen a bicycle
tt E
d
circle). Therefore, OQ is longer than the radius
OP of the circle. That is,
he
OQ > OP.
Since this happens for every point on the
line XY except the point P, OP is the
shortest of all the distances of the point O to the
is
points of XY. So OP is perpendicular to XY.
(as shown in Theorem A1.7.) Fig. 10.5
bl
Remarks :
1. By theorem above, we can also conclude that at any point on a circle there can be
pu
one and only one tangent.
2. The line containing the radius through the point of contact is also sometimes called
be T
EXERCISE 10.1
o R
4. Draw a circle and two lines parallel to a given line such that one is a tangent and the
other, a secant to the circle.
d
two points. So, it is not possible to draw any
tangent to a circle through a point inside it
he
[see Fig. 10.6 (i)].
Next take a point P on the circle and draw
tangents through this point. You have already (i)
observed that there is only one tangent to the
is
circle at such a point [see Fig. 10.6 (ii)].
Finally, take a point P outside the circle and
bl
try to draw tangents to the circle from this point.
What do you observe? You will find that you
can draw exactly two tangents to the circle
pu
through this point [see Fig. 10.6 (iii)].
We can summarise these facts as follows:
be T
d
PQ, PR on the circle from P (see Fig. 10.7). We
are required to prove that PQ = PR.
he
For this, we join OP, OQ and OR. Then
∠ OQP and ∠ ORP are right angles, because
these are angles between the radii and tangents,
and according to Theorem 10.1 they are right Fig. 10.7
is
angles. Now in right triangles OQP and ORP,
OQ = OR (Radii of the same circle)
OP = OP (Common)
bl
Therefore, Δ OQP ≅ Δ ORP (RHS)
This gives PQ = PR (CPCT)
pu
Remarks :
be T
1. The theorem can also be proved by using the Pythagoras Theorem as follows:
re
PQ2 = OP2 – OQ2 = OP2 – OR 2 = PR2 (As OQ = OR)
o R
i.e., the centre lies on the bisector of the angle between the two tangents.
Let us take some examples.
C
Now AB is a chord of the circle C1 and OP ⊥ AB. Therefore, OP is the bisector of the
chord AB, as the perpendicular from the centre bisects the chord,
i.e., AP = BP
Example 2 : Two tangents TP and TQ are drawn
d
to a circle with centre O from an external point T.
Prove that ∠ PTQ = 2 ∠ OPQ.
he
Solution : We are given a circle with centre O,
an external point T and two tangents TP and TQ
to the circle, where P, Q are the points of contact
(see Fig. 10.9). We need to prove that
is
∠ PTQ = 2 ∠ OPQ Fig. 10.9
bl
Let ∠ PTQ = θ
⎛ 1 ⎞
o R
1 1
θ = ∠ PTQ
=
2 2
∠ PTQ = 2 ∠ OPQ
C
This gives
d
TP RP TP 4 20
This gives = , i.e., = or TP = cm.
PO RO 5 3 3
he
Note : TP can also be found by using the Pythagoras Theorem, as follows:
Let TP = x and TR = y. Then
x2 = y2 + 16 (Taking right Δ PRT) (1)
is
x + 5 = (y + 3)
2 2 2 (Taking right Δ OPT) (2)
Subtracting (1) from (2), we get
bl
32 16
25 = 6y – 7 or y = =
6 3
2
⎛ 16 ⎞ 16 16 × 25
pu
Therefore, x = ⎜ ⎟ + 16 = (16 + 9) =
2
[From (1)]
⎝3 ⎠ 9 9
20
be T
or x=
3
re
o R
EXERCISE 10.2
In Q.1 to 3, choose the correct option and give justification.
tt E
1. From a point Q, the length of the tangent to a circle is 24 cm and the distance of Q from
the centre is 25 cm. The radius of the circle is
C
(A) 7 cm (B) 12 cm
(C) 15 cm (D) 24.5 cm
no N
4. Prove that the tangents drawn at the ends of a diameter of a circle are parallel.
5. Prove that the perpendicular at the point of contact to the tangent to a circle passes
through the centre.
6. The length of a tangent from a point A at distance 5 cm from the centre of the circle is 4
d
cm. Find the radius of the circle.
7. Two concentric circles are of radii 5 cm and 3 cm. Find the length of the chord of the
he
larger circle which touches the smaller circle.
8. A quadrilateral ABCD is drawn to circumscribe a circle (see Fig. 10.12). Prove that
AB + CD = AD + BC
is
bl
pu
be T
9. In Fig. 10.13, XY and X′Y′ are two parallel tangents to a circle with centre O and
another tangent AB with point of contact C intersecting XY at A and X′Y′ at B. Prove
that ∠ AOB = 90°.
tt E
10. Prove that the angle between the two tangents drawn from an external point to a circle
is supplementary to the angle subtended by the line-segment joining the points of
contact at the centre.
C
10.4 Summary
In this chapter, you have studied the following points :
1. The meaning of a tangent to a circle.
2. The tangent to a circle is perpendicular to the radius through the point of contact.
d
3. The lengths of the two tangents from an external point to a circle are equal.
he
is
bl
pu
be T
re
o R
tt E
C
no N
©