Scribd
Upload
12 views

Ee 8511 C & I Lab University QP

AU Ques Paper

Uploaded by

mohanaelectrical
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
12 views

Ee 8511 C & I Lab University QP

AU Ques Paper

Uploaded by

mohanaelectrical
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Page 1 of 2

B.E / B.Tech. PRACTICAL END SEMESTER EXAMINATIONS, APRIL/MAY 2021

Fifth Semester
ELECTRICAL AND ELECTRONICS ENGINEERING
EE 8511 - CONTROL AND INSTRUMENTATION LABORATORY

(Regulations 2017)

Date: 10.08.2021 Max. Marks 100


Time : 3 Hours

1. Analyze the step response of the given system using P,PI, PID controller.

2. Experimentally Analyze the stability of linear systems.

3. Design and implement a lead and lag compensator and draw the bode plots from the measured
value.

4. Plot the performance characteristics of the given DC motor angular position control system.

5. Plot the performance characteristics of the given Synchro transmitter and receiver.

6. Analyze the stability of the linear systems using bode plot using MATLAB software tool.

7. Design the P, PI and PID controller response for the first order and second order transfer
function using MATLAB software tool.

8. Determine the value of unknown resistance using suitable bridge.

9. Find the value of unknown inductance using suitable bridge.

10. Measure the value of unknown capacitance using suitable bridge.

11. Measure and plot the temperature and output voltage of the given thermistor.

12. Measure the pressure using pressure transducer with respect to signal conditioned output voltage.
Page 2 of 2

13. Measure and plot the displacement and output voltage of linear variable displacement transducer.

14. Plot the characteristics of LDR and RTD using optical sensor.

15. Plot the characteristics of the given strain gauge and to obtain error.

16. Calibrate the given energy meter using a standard wattmeter and to obtain percentage error.

17. Design and plot the characteristics of instrumentation amplifier.

18. Design and test a 4bit digital to analog converter by R-2R ladder network and weighted resistor
network.

19. Design and test the analog to digital converter.

20. Calibrate the given Wattmeter by direct loading and obtain its percentage error.

INTERNAL EXAMINER EXTERNAL EXAMINER

MOHANABALAN R xxxxxxxxx
ASSISTANT PROFESSOR ASSISTANT PROFESSOR
7204036/CMSCET xxxxxxxxx

You might also like