Scribd
Upload
8 views

Masala Interlock Current

Uploaded by

sandeep naik
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
8 views

Masala Interlock Current

Uploaded by

sandeep naik
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 2

//const int SW1 = 7; //o/p Switch

const int StartButton = 7; // Motor Start button


const int StopButton = 8; // Motor Stop Button
const int Relay1 = 12;
int flag = 0;
void setup() {
pinMode(StopButton, INPUT_PULLUP); // INPUT PIN D5
pinMode(StartButton, INPUT_PULLUP); // INPUT PIN D6
pinMode(Relay1, OUTPUT); // ENABLE AS OUTPUT PIN D12
digitalWrite(Relay1, HIGH);
Serial.begin(9600); //Start Serial Monitor to display current read value on
Serial monitor
}

void loop() {
digitalWrite(StartButton, HIGH);
digitalWrite(StopButton, HIGH);
//digitalWrite(Relay1, HIGH);
//int flag = 0;

if (digitalRead(StartButton) == LOW)
{
delay(5);
flag = 1;
Serial.print("SMPS\n");
}

if (digitalRead(StopButton) == LOW)
{
delay(5);
flag = 2;
Serial.print('flag\n');
}

unsigned int x = 0;
float AcsValue = 0.0, Samples = 0.0, AvgAcs = 0.0, AcsValueF = 0.0;

for (int x = 0; x < 150; x++) { //Get 150 samples


AcsValue = analogRead(A0); //Read current sensor values
Samples = Samples + AcsValue; //Add samples together
delay(3); // let ADC settle before next sample 3ms
}
AvgAcs = Samples / 150.0; //Taking Average of Samples

//((AvgAcs * (5.0 / 1024.0)) is converitng the read voltage in 0-5 volts


//2.5 is offset(I assumed that arduino is working on 5v so the viout at no
current comes
//out to be 2.5 which is out offset. If your arduino is working on different
voltage than
//you must change the offset according to the input voltage)
//0.185v(185mV) is rise in output voltage when 1A current flows at input
AcsValueF = (2.5 - (AvgAcs * (5.0 / 1024.0))) / 0.185;

Serial.print(AcsValueF); //Print the read current on Serial monitor


delay(50);
Serial.print("\n");
if (AcsValueF < 0.15) {
AcsValueF == 0;
Serial.print("zero'd\n");
}
if (((AcsValueF > 0.15) && (AcsValueF < 0.35)) && (flag == 1)) {
// if ((AcsValueF >0.15) && (AcsValueF <0.35)){
digitalWrite(Relay1, LOW);
//delay(50);
flag = 1;
Serial.print("INTERLOCKED\n");
}
else{digitalWrite(Relay1, HIGH);
Serial.print("dpooooo\n");}
if (AcsValueF < 0.15) {
AcsValueF == 0;
flag = 0;
Serial.print("zero'd\n");
}

You might also like