D-PDD-DY-23

Exam Name: Dell PowerProtect DD Deploy 2023

Full version: 195 Q&As

Full version of D-PDD-DY-23 Dumps

Share some D-PDD-DY-23 exam dumps below.

1. Which command is used to add storage to either the active or cloud tier?
A. storage add disks
B. enclosure add storage
C. storage add cloud
D. storage add´enclosure
Answer: B

2. What is the maximum number of concurrently active virtual tape library instances on each
PowerProtect DD appliance?
A. 32
B. 56
C. 64
D. 128
Answer: C

3. An administrator is migrating their old cloud tier-enabled Data Domain to a new PowerProtect
DD appliance with cloud tier. During migration, the administrator recognizes that file system
cleaning on the source system is not possible.
What is the most likely cause of this behavior?
A. Migration will restrict all activities on source systems.
B. Migration will restrict all activities on both systems.
C. Filesystem is disabled on source system.
D. Source system is running in restricted mode.
Answer: A

4. What is one advantage of using PowerProtect DD instead of backing up to other disk-based

file systems?
A. Data is stored locally on the client for fast restore.
B. Only deduplicated data is sent across the network.
C. Only deduplicated blocks of data are needed for full recovery.
D. Data can be restored to any client operating system.
Answer: B

5. What is required to configure a cloud file system in a PowerProtect DD environment?

A. Active tier encryption using the embedded Key Manager
B. Active tier encryption using an external Key Manager
C. Local store for a local copy of the cloud metadata
D. Global store for a global copy of the cloud metadata
Answer: C

6. An administrator is using an on-premises cloud tier-enabled DDVE instance. A new DD6900

with cloud tier will replace the DDVE.
What must be considered for cloud tier migration?
A. The new system must have the same features enabled as the source
B. Both systems must use DDOS 7.3.0.5 or higher
C. Cloud tier migration with DDVE instances is not supported
D. Add a Dell Cloud Tier license on the new system
Answer: C
Explanation:
Cloud tier migration from DDVE instances to physical PowerProtect DD systems like DD6900 is
not supported, meaning data in the cloud tier cannot be directly transferred, necessitating
alternative migration methods or data retrieval strategies.

7. An administrator recognizes poor network performance when using CIFS shares from a
PowerProtect DD system. The network link utilization is under 100%.
What is the most likely cause of this issue?
A. TCP window size too small
B. TCP timeout too small
C. TCP timeout too large
D. TCP window size too large
Answer: B

8. An administrator monitors the performance statistics of a PowerProtect DD appliance. Low

disk-write rates are shown, and the network inbound traffic is high.
What is the most likely cause of this behavior?
A. NVRAM failure
B. Disk failure
C. Expired segments
D. Known segments
Answer: D

9. If PowerProtect DD administrator issue a cifs share destroy command, what is the result?
A. The CIFS share and contents of the share are deleted.
B. The contents of the CIFS share are deleted.
C. The CIFS share is deleted.
Answer: C
10. A backup administrator is tasked with verifying the compression settings of a DDVE
instance.
Which compression algorithm will be enabled by default?
A. gzfast
B. lzw
C. lz
D. gz
Answer: C

11. An administrator is configuring Cloud Tier with two units. The first is writing data to an AWS
S3 bucket and the second to an Azure Blob storage account.
What is the total capacity available to each cloud unit?
A. Total capacity of the AWS S3 bucket
B. Maximum capacity of the Active Tier
C. Maximum capacity of the Cloud Tier
D. Total capacity of the Azure Blob
Answer: B

12. Which types of replication are supported in a PowerProtect DD appliance?

A. Collection, Directory, MTree, Pool, and Managed File
B. Synchronous, Collection, MTree, Managed File, and Directory
C. MTree, Collection, and Directory only
D. Asynchronous, Collection, Directory, and MTree
Answer: C

13. A PowerProtect DD administrator must optimize TCP/IP performance on AIX host, what
setting must be used for each NIC interface?
A. large_send to yes
B. tcp_pmtu_discover to 0
C. tcp_pmtu_discover to 1
D. large_send to no
Answer: D

14. Which deduplication steps are offloaded when DSP is used?

A. Compress, Segment, and Filter
B. Segment, Fingerprint, and Compress
C. Fingerprint, Segment, and Filter
D. Filter, Fingerprint, and Segment
Answer: B

15. An administrator is scaling Cloud Tier for a DD9900 by adding a second cloud unit.
What is the required amount of metadata storage (TB)?
A. 120
B. 240
C. 300
D. 500
Answer: C

16. What is the correct practice when creating Fibre Chanel zones between PowerProtect DD
and the media server?
A. dual - initiator dual - target zoning
B. single - initiator single - target zoning
C. dual - initiator single - target zoning
D. single - initiator dual - target zoning
Answer: B

17. What are the terminal emulation settings that are used to establish serial communication
with a PowerProtect DD system?
A. BAUD Rate: 116200
Data Bits: 8
Stop Bits: 1
Parity: Even
Flow Control: Xon/XOFF
B. BAUD Rate: 115200
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: None
C. BAUD Rate: 115200
Data Bits: 1
Stop Bits: 2
Parity: None
Flow Control: None
D. BAUD Rate: 116200
Data Bits: 1
Stop Bits: 2
Parity: Odd
Flow Control: Xon/XOFF
Answer: B

18. What rule must be followed during an upgrade procedure with the FS25 expansion shelf?
A. FS25 shelf is cabled on a separate private chain
B. For high performance, the connections from a controller to FS25 shelves must be over FC
cables
C. FS25 shelf must be on the same chain with DS60
D. If ES40 SAS shelves are on the same chain as an FS25, the maximum number of shelves on
that chain is five
Answer: A

19. A CommVault Simpana administrator would like to use the benefits of DD Boost.
Which technology will allow this integration?
A. NFS
B. CIFS
C. VTL
D. BoostFS
Answer: D

20. An administrator must display the compression statistics for all files and directories in the file
system for the last 7 days and the last 24 hours.
Which command is used to gather this information?
A. storage show
B. mtree show
C. filesys report
D. quota show
Answer: C
Explanation:
The filesys report command provides detailed compression statistics, essential for
administrators to monitor storage efficiency over time. This insight into compression ratios aids
in storage optimization and management planning on PowerProtect DD systems.

21. What is a consideration for recalling the data from the cloud to the active tier?
A. Recall does not check for existing data segments
B. Recall is attempted even if no space is available
C. Recall is performed per file
D. Recall is only performed for segments present in the active tier
Answer: C

22. What is enabled by the following command? authorization policy set security-officer enabled
A. Automatic Retention Lock
B. MTree Retention Lock Revert
C. Dual authorization process
D. Security encryption
Answer: C
Explanation:
Enabling the security-officer authorization policy activates the dual authorization process,
adding a layer of security by requiring approvals for certain actions. This feature is critical for
environments with strict compliance and data governance requirements.

23. Which command is used to check if NFS is enabled?

A. nfs enable
B. nfs status
C. nfs show clients
D. system show
Answer: B

24. The finance department requires PDFs older than 90 days to be archived through Cloud
Tier into Azure Blob Storage. They want any PDFs older than 180 days archived into AWS S3.
Which data movement policy is used to archive files into Azure Blob Storage?
A. App-driven
B. Age-based
C. Age-range
D. Recall
Answer: C
25. A Power Protect DD system is configured for VTL. The backup application requires a
minimum tape capacity of 800 GB.
What is the minimum tape type to support this requirement?
A. LTO-5
B. LTO-3
C. LTO-2
D. LTO-4
Answer: D

26. What is a requirement to use the PowerProtect DD HA feature?

A. Each head unit requires its own FS25 shelf
B. Head units and nodes require an active/active configuration
C. A single set of shared storage
D. Dual set of shared storage configuration
Answer: D

27. Backup administrators have noticed slow backups on the AIX environment.
To fix the issue, what should the set large_send be for each NIC, and what should the NFS
option be set to?
A. no and nfs_rfc1323=0
B. yes and nfs_rfc1323=0
C. no and nfs_rfc1323=1
D. yes and nfs_rfc1323=1
Answer: C

28. Which backup applications create their own storage units when they are configured to use a
PowerProtect DD appliance as a backup target?
A. Dell EMC Avamar and Veritas Backup Exec
B. Veritas Backup Exec and NetBackup
C. Dell EMC NetWorker and Avamar
D. Veritas NetBackup and Dell EMC NetWorker
Answer: C

29. Which feature helps to ensure that data immutability is maintained on a PowerProtect DD
system?
A. DD Retention Lock
B. Encryption
C. Secure Multi-Tenancy
D. DD Replicator
Answer: A
Explanation:
DD Retention Lock enforces data immutability, ensuring that critical data cannot be altered or
deleted until its retention period expires. This feature is essential for regulatory compliance and
data integrity in long-term storage.

30. With DSP enabled on a PowerProtect DD appliance, which functions are performed on the
backup host?
A. Recording references to previous data and segmenting
B. Segmenting fingerprinting, and sending the fingerprints
C. Compressing segmenting, and fingerprinting
D. Sending the data, segmenting, and compressing
Answer: B
 More Hot Exams are available.

350-401 ENCOR Exam Dumps

350-801 CLCOR Exam Dumps

200-301 CCNA Exam Dumps

Powered by TCPDF (www.tcpdf.org)