American International University - Bangladesh (AIUB)

Faculty of Engineering
Department of Electrical and Electronic Engineering (EEE)
Course Name: Microprocessor and Embedded Systems Course Code: EEE 4103
Semester: Fall 2024 Term: Mid
Faculty Name: Tahseen Asma Meem Assignment #: 01

Course Outcome Mapping with Questions

Item COs POIs K P A Marks Obtained Marks
Q1 CO2 P.a.4.C3 K4 P1, P3, P7 10
Total: 10

Student Information:
Due Date: 15/11/2024 Submission Date:
Student Name: Hamim Ibne Rahman
Student ID #: 22-49933-3 Department: CSE Section:

Reference : study a few of the initial pages from the datasheets of reference link to complete your
assignment 1.
( reference link : one drive datasheet section)

Marking Rubrics (to be filled by Faculty):

Excellent Proficient Good Acceptable Unacceptable No Response
[9-10] [7-8] [4-6] [2-3] [1] [0]
Detailed unique Response with no Response shows Partial problem is Unable to clarify No Response/
Secured
Problem # response explaining apparent errors understanding of solved; response the understanding copied from
Marks
the concept properly and the answer is the problem, but indicates part of the of the problem and others/identical
and answer is correct correct, but the final answer problem was not method of the submissions with
with all works explanation is not may not be understood clearly problem solving gross errors/image
clearly shown. adequate/unique. correct or not solved. was not correct file printed
Comments Total Marks (10)

Page 1 of 3
Question # 1: Complete Table 1 after going through the datasheet of the specified microcontrollers.

Table 1
Specifications ATMega328P STM32F205G STM32F401RET6R ATMega2560 PIC16F68

Architecture ARM Cortex-

AVR RISC ARM Cortex-M4 AVR RISC CMOS
Type M3

Maximum
20 MHz 120 MHz 84 MHz 16 MHz 20MHz
Clock Speed

Program Flash
Memory 32 KB 1024 KB 512 KB 256 KB 7KB
(Kbytes)

SRAM (Kbytes) 2KB 128 KB 96 KB 8 KB 0.36KB

ADC Resolution 10-bit 12-bit 12-bit 10-bit 10-bit

Operating
Voltage Range 1.8V to 5.5V 1.8V to 3.6V 2.0V to 3.6V 4.5 V to 5.5 V 2.0V to 5.5V
(V)
Number of
PWM 6 16 18 12 4
Channels
Number of
3 10 11 6 3
timers
Universal
Synchronous/
Asynchronous Universal
Receiver/Trans Synchronous
mitter Asynchronous Universal Universal
(USART), Receiver/Transmitter Synchronous/ Synchronous/
Universal Serial (USART), Serial Asynchronous Asynchronous
Peripheral Peripheral Receiver/Trans
Synchronous/ Receiver/Tran
Interface (SPI), Interface(SPI), Inter- mitter
Asynchronous smitter
Two-Wire Integrated (USART),
Receiver/Transmitter (USART),
Communicatio Interface Circuit(I2C), Serial
(USART), (TWI), Serial
n Interfaces Universal Serial Peripheral
Serial Peripheral Controller Area Peripheral
Bus(USB), Interface (SPI),
Interface (SPI), Network Controller Area Two-Wire Interface
Two- Wire (CAN), Interface (SPI), Two-
Network(CAN),
Interface (TWI) Ethernet, Secure Digital Input (TWI), Joint Wire
Universal Serial Output(SDIO), Joint Test Action Interface
Bus(USB), Test Action Group / Group (JTAG) (TWI)
Inter-IC Sound Serial Wire
(I2S), Joint Debug(JTAG/SWD)
Test Action
Group (JTAG)

Page 2 of 3
The unit prices of the above mentioned MCUs are as follows: (1 USD = 108 BDT)

ATMega328P STM32F205VG STM32F401RET6TR ATMega2560 PIC16F628

Price $3.60 $3.9 $4.12 $20 $1.9

X Company in Bangladesh is trying to develop an affordable shop security system and they have shortlisted
the listed 5 MCUs as possible candidates for their system CPU. The required minimum specifications for
their intended design for the CPU are given below:

Minimum Clock Speed 16 MHz

Minimum SRAM 8 Kbytes
Minimum ADC Resolution 12-bit
Minimum Program Memory 64 KBytes
Minimum Number of PWM Channels 12
Required Serial Communication Interfaces 4 SPI, 2 TWI, 4
USARTs

Being a design engineer at X industry, you have been given the responsibility to select the most suitable IC
from the list for the security system design requiring minimum of 1200 MCU ICS.
Please select an IC from the list to design an affordable and efficient system and justify your answer with
proper reasoning.

Page 3 of 3