Scribd
Upload
12 views

How To Configure Interface On Gajshield Firewall-1

Uploaded by

0997rv
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
12 views

How To Configure Interface On Gajshield Firewall-1

Uploaded by

0997rv
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 9

HOW TO CONFIGURE INTERFACE ON GAJSHIELD FIREWALL

Steps for creating a New Interface.

Step 1: Need to go Configuration >> Device >> Interface >>

Step 2: Click on the Edit. You have options of Type of Interface Standard/PPPoE/DHCP for your
ISP Interface Configuration Depending upon the type of Link.
You will get a checkbox where you can select a single ISP as Default Gateway.

Step 3: After adding all the Details selecting on Edit to save the Interface created. You will get
an confirmation as shown below.
Step 4: After clicking on OK, we need to Restart Network for updating the Routes.

Step 5: After the Network Restart is been done, it will give you the below message as shown
below.
Step 6: Now come to Configuration >> WAN Failover >> WAN Failover. Click on
Note: The WAN Failover setting is done for displaying the Internet Status, whether the Status
of the ISP Link is UP / DOWN on Dashboard.
And we need to set the Primary, Secondary, Third etc. target IP by pinging the IP for checking
whether the Link is UP / DOWN or we can select TCP (Telnet) for specific port which will
define the Internet Status of the ISP Link whether it is UP / DOWN.

Step 7: After editing WAN Failover setting we need to do Install Policies by going in
Firewall >> Policies >> Install Policies

After Doing Install Policies you can check on Dashboard under the Internet Status,
It will be displayed as Shown Below.
Steps for Re-configuring Interface.

Step 1: User has Configured Interface 3 and he needs to re configure it, so he needs to select
by clicking on (Reset Interface).
Details Required for Configuring ISP Links.

1. Standard Link

2. PPPoE Static Link


3. PPPoE Dynamic Link

4. DHCP Link
Note: In GajShield Firewall each and every port is re-configurable. There is no restriction of
Configuring at specific Interface.
You can configure LAN / DMZ / MPLS / Private Network LEASE LINE interface the same way as
you have configured the ISP interface.
User can select only a single ISP Link as Default Gateway. No two or more can be selected.
After doing any changes in the Configuration >> Device Tab, Restart Network is Mandatory
for the changes to be Saved/Updated in the Firewall.

***

You might also like