Scribd
Upload
2 views1 page

stackwirs

Uploaded by

Pablo Proaño
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
2 views1 page

stackwirs

Uploaded by

Pablo Proaño
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Step 1. Configure the StackWise Virtual domain.

On the two switches, configure the same virtual switch domain number (in this case it is 100)

SV-1#conf t SV-2#conf t
Enter configuration commands, one per line. End with CNTL/Z. Enter configuration commands, one per line. End with CNTL/Z.
SV-1(config)#stackwise-virtual SV-2(config)#stackwise-virtual

Please reload the switch for StackWise Virtual configuration to take Please reload the switch for StackWise Virtual configuration to take
effect effect

SV-1(config-stackwise-virtual)#domain 110 SV-2(config-stackwise-virtual)#domain 110

Step 2. Configure the StackWise Virtual link.

By default in standalone mode, the switches are identified with switch 1 unless explicitly changed to some other switch number. During the conversion to StackWise Virtual, the switch numbers are
changed automatically to reflect two switches in the StackWise Virtual domain.
SV-1#conf t SV-1#conf t
Enter configuration commands, one per line. End with CNTL/Z. Enter configuration commands, one per line. End with CNTL/Z.
SV-1(config)#interface range GigabitEthernet 1/0/23-24 SV-2(config)#interface range GigabitEthernet 1/0/23-24
SV-1(config-if-range)#stackwise-virtual link 1 SV-2(config-if-range)#stackwise-virtual link 1

WARNING: All the extraneous configurations will be removed for WARNING: All the extraneous configurations will be removed for
GigabitEthernet1/0/23 on reboot GigabitEthernet1/0/23 on reboot

WARNING: All the extraneous configurations will be removed for WARNING: All the extraneous configurations will be removed for
GigabitEthernet1/0/24 on reboot GigabitEthernet1/0/24 on reboot
SV-1(config-if-range)#end SV-2(config-if-range)#end

Step 3. Configure the StackWise Virtual dual-active-detection.


SV-1(config)#interface GigabitEthernet 1/0/22 SV-2(config)#interface GigabitEthernet 1/0/23
SV-1(config-if-range)# stackwise-virtual dual-active-detection SV-2(config-if-range)# stackwise-virtual dual-active-detection

You might also like