Scribd
Upload
13 views

ECEN280 Spring 2020 Final 16May2020

Uploaded by

yazanqazzaz
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
13 views

ECEN280 Spring 2020 Final 16May2020

Uploaded by

yazanqazzaz
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

American University of Ras Al Khaimah

Electrical, Electronics and Communications Engineering Department


Electric Circuit Analysis I (ECEN 280), Spring 2020

Final Exam Date: May 16, 2020

Student Name: AURAK ID:

Instructions: This Final Exam consists of 6 questions. Each question worth 5 points.
Please provide your worked solutions and answers with all the necessary steps clearly and
in readable English. Please use pen (don’t use red pen) for all calculations. Please write
your FULL NAME and AURAK ID at the top of the first page of YOUR WORKSHEET
and submit the scanned copy of your worked solutions (WORK SHEET) to the instructor
email address ([email protected]) immediately at the end of the Exam time. Please make
sure that your scanned copy is clear and readable.

Time: 11:00 -13:00


1. The circuit in Fig. 1 shows a cascade connection of two integrators. Determine the output
voltages v01 and v0 at t= 2 ms assume the integrators are reset to 0 V at t=0. Use the time
domain method that you learnt in the course to solve the problem.
(5 pts)
5 μF 10 μF

20 kΩ 25 kΩ

v01
10 V

Fig. 1 for Question 1


2. The switch in Fig. 2 has been closed at t=0. Determine the capacitor voltage v(t) for t > 0
assuming the capacitor has reached steady state for t < 0. Find the time t0 that is required
for the capacitor voltage to reach 50% of its final value at t=. Use the time domain
method that you learnt in the course to solve the problem.
(5pts)

15 V 5

4

Fig. 2 for Question 2

1
3. In the circuit of Fig. 3, find v(t) & i(t) for t > 0. Assume that v(0) = 0 V and i(0) =1 A.
Use the time domain method that you learnt in the course to solve the problem.
(5 pts)

1
F
64

Fig. 3. Circuit for Question 3.


4. In the circuit of Fig. 4, determine the mesh currents i1(t) & i2(t) where v1(t)=10cos(2t) V
(5 pts)
0.5 H 0.5 H

0.5 F

1

Fig. 4. Circuit for Question 4.


5. In the circuit shown in Fig. 5, (5 pts)
a. Calculate the value of ZL in order for ZL to receive maximum average power
from the source current.
b. Calculate the maximum average power received by ZL.

 j 20  20 

a b 1000 A

50  j 25 

Fig. 5 Circuit for Question 5


6. A 110-V (the voltage is rms value) and 60-Hz source supplies a parallel combination of
a 10-kW heater and a 60-kVA induction motor whose power factor is 0.8. Determine:
(5 pts)
a. the system apparent power
b. the system reactive power
c. the kVA rating of a capacitor required to adjust the system power factor to 0.98
lagging and the value of the capacitor, C to be used for the system power
correction.

You might also like