Scribd
Upload
5 views

16EC5DCDSP (9)

Uploaded by

Harsh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
5 views

16EC5DCDSP (9)

Uploaded by

Harsh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

U.S.N.

BMS College of Engineering, Bengaluru-560019


Autonomous Institute Affiliated to VTU

December 2017 Semester End Main Examinations

Course: Digital Signal Processing Duration: 3 hrs


Course Code: 16EC5DCDSP Max Marks: 100
Date: 14.12.2017
Instructions: Answer five full questions choosing one from each unit

UNIT 1
1 a Compute the N-point DFT of x(n)=a for
n
0≤n≤N-1. 4
b For x(n)={1,-2,3,-4,5,-6} without computing its DFT, find following. 12
i) X(0) ii)∑𝑘=0 𝑋 𝐾 iii)X(3) iv)∑𝑘=0 |𝑋 𝐾 |2.
c Find 4-point DFT of x(n)=cos[nπ/4] using matrix method or using fundamental 4
definition.
OR
2 a An analog signal is sampled at 10 KHz and the DFT of 512 samples is computed. 6
Determine the frequency spacing between spectral samples of DFT. Determine the
frequency spacing of 1024-point DFT is calculated.
b Determine 8-point DFT of the signal x(n)={1,1,1,1,1,1,0,0}. 14
Also sketch its magnitude and phase.
UNIT 2
3 a Given x(n)={1,2,3,4} and h(n)={1,2,2}. Compute 8
i) Circular convolution
ii) Linear convolution
iii)Linear convolution using circular convolution
b Determine the Output y(n) of a filter whose impulse response is h(n)={1, 1, 1} and 12
input signal x(n)={3,-1,0,1,3,2,0,1,2,1} using
i) Overlap Save Method
ii) Overlap Add Method
UNIT 3
4 a What is the speed improvement factor in calculating 64-point DFT of a sequence 6
using direct computation and FFT algorithm? Also mention the number of registers
required.
b Write a note on geortzel algorithm. 4
c Compute IDFT of {0, 2-j4.8284, 0, 2+j0.8284, 0, 2-j0.8284, 0, 2+j0.8284} using 10
DIF-FFT algorithm.
OR
5 a Obtain the digital filter equivalent of the analog filter shown in fig below, where 12
R=1 ohm, C=1F

using (i)IIT (ii)BLT.


Assuming fs=8fc, where Fc is cut off frequency of the filter.
b The transfer function of a discrete causal system is given as 8
H (Z)=1-Z-1/1-0.2Z-1-0.15Z-2
i) Find the difference equation
ii) draw cascade &parallel realization
UNIT 4
6 a Design a digital IIR LP Butterworth filter that has 2dB pass band attenuation at a 10
frequency of 300𝜋 rad/sec & at least 60dB stop band attenuation at 4500𝜋
rad/sec.Use BLT.
b Design a lowpass 1.4531 rad / sec bandwidth chebyshev filter with the following 10
specifications
i) Acceptable passband ripple of 1 dB
ii) Cutoff random frequency of 1.4531 rad/sec
iii) Stopband attenuation of 20 dB or greater beyond 6.1536 rad/ Sec
( Filter table may be used)
UNIT 5
7 a 12
Design an Ideal BP FIR filter with frequency response H(ejw)= 1, for,
𝜋 𝜋
≤𝜔≤
use rectangular window with N=11.
b Bring out the difference between FIR & IIR filter 4
c Explain Gibb’s phenomenon in design of digital filter 4
*******

You might also like