TDS 09.

Rev 9

Data / Specification Sheet • Novus 34

Novus 34 is a superior
performance universal compressed
sheet material based on a blend
of aramid/ inorganic fibres and
special additives, with high quality
nitrile rubber binder system.

Service Typical Physical Properties

Novus 34, a superior performance material
Thickness 1.5mm
with excellent mechanical properties, it is
suitable for many applications including oils, Density 1.75g/cc
solvents, high pressure steam and gases Tensile Strength ASTM F152 9-11MPa
including oxygen.
Compression ASTM F36 9%
Approvals / Compliance Recovery ASTM F36 55% min
WRAS Potable Water: o
Residual Stress BS 7531 (300 C) 26MPa
Registration No. 1406501
DIN 52913 32MPa
BAM (Oxygen service) up to 60oC and 160 bar
Gas Leakage BS 7531 <1.0cc/min
Complies with BS Specification 7531 Grade X
ASTM Oil 1 Thickness increase 1.0%
TA-LUFT
(in accordance with VDI Guideline 2440) IRM 903 Oil Thickness increase 2.5%

GL Approval cert 37702 – 12HH ASTM Fuel B Thickness increase 3.0%

API 6FB Fire-safe

Novus 34 Pressure/Temperature Limits
Availability As the company’s products are
120 used for a multiplicity of purposes
Thickness range:
and as the company has no
0.25mm to 6.0mm 100 control over the method of their
3 applications or use, the company
Standard sheet sizes: 80
2 excludes all conditions or
2.0m x 2.0m 60 warranties, expressed or implied
2.0m x 1.5m by statute or otherwise, as to
2.0m x 1.0m 40 1 their products and/or their fitness
Pressure (Bar)

for any particular purpose. Any

1.5m x 1.5m 20 technical co-operation between
1.5m x 1.0m the company and the customer
0 is given for customers assistance
Standard roll sizes: only, and without liability on the
Up to a maximum size of 6.0m x 2.0m 0 50 100 150 200 250 300 350 400 450 part of the company.
Temperature (oC)
Available with fine mesh mild steel
reinforcement: Novus 34 Metallic or gauze
1 Suitable subject to chemical compatibility.
mild steel wire reinforcement: Novus 34 GWI.
2 Suitable in some cases but check your application requirements
It can be supplied with anti-stick coating with Flexitallic.
and graphite coating. 3 Contact the Technical Team for applications with higher
temperatures and pressures. Applicable to 2.0mm and below.
The operating temperature of non-asbestos sheet material
is related to the thickness of materials selected. Thinner
materials give better temperature and pressure properties.

Tel. +44 (0)1274 851273 Fax. +44 (0)1274 300303 www.flexitallic.eu Email. [email protected]