Scribd
Upload
39 views

19A02201T Basic Electrical & Electronics Engineering (3)

Uploaded by

brahmaiah334
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
39 views

19A02201T Basic Electrical & Electronics Engineering (3)

Uploaded by

brahmaiah334
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Code: 19A02201T R19

B.Tech I Year II Semester (R19) Supplementary Examinations April 2021


BASIC ELECTRICAL & ELECTRONICS ENGINEERING
(Common to CE, ME, CSE, IT & FT)

Time: 3 hours Max. Marks: 70


Answer all the questions
(Use single answer booklet only)
*****
PART – A
UNIT – I
1 (a) Derive the average and rms value of a sinusoidal voltage of magnitude Vm.
(b) Determine the current flowing in 10Ω resistor in the network shown in figure below by using
Superposition theorem.

I1 I2

I3

OR
2 (a) What do you understand by real power, reactive power and apparent power?
(b) A coil having a resistance of 12Ω and an inductance of 0.1H is connected across a 100 V, 50 Hz
supply. Calculate: (i) The reactance and the impedance of the coil. (ii) The current flowing in the
coil. (iii) The power factor.
UNIT – II
3 (a) Draw and explain the internal characteristics of DC shunt motor.
(b) A 6-pole lap wound DC generator has 600 conductors on its armature. Flux per pole is 0.02 Wb,
speed is 1500 rpm. Calculate EMF generated. Also calculate EMF generated if the generator is
wave wounded.
OR
4 (a) Explain the procedure for performing the open circuit test on a single phase transformer.
(b) Explain any one of the speed control techniques of D.C shunt motor.
UNIT – III
5 With a neat layout diagram, explain the working of thermal power station.
OR
6 Explain the following:
(a) Transmission lines.
(b) Wind turbines.
Contd. in page 2

Page 1 of 2
Code: 19A02201T R19

PART – B
UNIT – I
7 (a) Briefly explain the applications of a diode as a switch and rectifier.
(b) Draw and explain the output and input characteristics of a BJT in CE configuration.
OR
8 (a) Compare CE, CB and CC configurations.
(b) Draw the block diagram of op-amp and mention the characteristics of an ideal op-amp.
UNIT – II
9 (a) Draw the logic symbol and truth tables of basic logic gates.
(b) Convert JK Flip-Flop to SR Flip-Flop.
OR
10 (a) Implement Full adder circuit using NAND gates.
(b) Distinguish between combinational and sequential logic circuits.
UNIT – III
11 (a) With a block diagram, explain the elements of communication system.
(b) Compare AM and FM.
OR
12 (a) Define modulation. Discuss the need for modulation in communication systems.
(b) Briefly explain the working of mobile communication system.

*****

Page 2 of 2

You might also like