Scribd
Upload
8 views

module-11

Uploaded by

Abdelhamid Benallel
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
8 views

module-11

Uploaded by

Abdelhamid Benallel
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 8

Module-11

1. Which is the best conductor of electricity

Iron

Silver

Aluminum

Carbon
Correct Answer : b Explanation : The best conductor of electricity is pure silver

2. For which of the following ‘ampere second’ could be the unit

Reluctance

Charge

Power

Energy
Correct Answer : b Explanation : The SI derived unit of electric charge is the coulomb, which is defined as
an ampere second.

3. 6 ohm resistor having 2 A current will dissipate the power of

12 watts

4 watts

24 watts

8 watts
Correct Answer : c Explanation : P = I2R= 4*6= 24W

4. Which power should be connected to Anode/Cathode to make PN Diode


forward Biased?

+7V, +10V

3V, +5V

+0.3V, +5V
+5V, 1V
Correct Answer : d Explanation : during forward bias condition,anode potential should be greater than cathode
potential

5. The resistance of a few meters of wire conductor in closed electrical circuit


is

practically zero

low

high

very high
Correct Answer : a Explanation : When wire conductor is made for smooth electric current carrying then the
resistance of the wire conductor is kept low or as near to zero.

6. Which of these formulae gives the voltage gain of an amplifier?

Vout/ Vin

Vin/ Vout

Vout/ Iin

Vin x hfe
Correct Answer : a Explanation : Gain is defined as the ratio of output to input

7. The maximum efficiency of a distribution transformer is

at no load

at 60% to 70% full load

at 80% full load

at full load
Correct Answer : b Explanation : The main difference between power and distribution transformer is
distribution transformer is designed for maximum efficiency at 60% to 70% load as normally doesn't operate at full load all
the time.

8. Transformer breaths in when

load on it increases
load on it decreases

load remains constant

none of the above


Correct Answer : b Explanation : When the oil cools down, air from the atmosphere is drawn in to
the transformer. This is called breathing in of the transformer. Use of Silica gel breather. During the breathing process, the
incoming air may consist of moisture and dirt which should be removed in order to prevent any damage

9. No-load current of a transformer has

has high magnitude and low power factor

has high magnitude and high power factor

has small magnitude and high power factor

has small magnitude and low power factor


Correct Answer : d Explanation : No-load current of a transformer has small magnitude and low power
factor

10. On which of the following factors skin effect depends

Frequency of the current

Size of the conductor

Resistivity of the conductor material

All of the above


Correct Answer : d Explanation : Factors affecting skin effect: Frequency, Diameter, The shape of the
conductor, Type of material.

11. The power transformer is a constant

voltage device

current device

power device

main flux device


Correct Answer : d Explanation : The power transformer is a constant flux device.

12. The ratio of starting torque to running torque in a synchronous motor is


zero

one

two

infinity
Correct Answer : a Explanation : The torque developed at the instant of
starting of a motor is called as starting torque. Starting torque may be greater than running torque in some cases, or it may
be lesser.

13. In a 3-phase, 4-pole, 50 Hz synchronous motor, the frequency, pole


number and load torque all are halved. The motor speed will be

3000 r.p.m.

1500 r.p.m.

750 r.p.m.

none of the above


Correct Answer : b Explanation : Ns=120f/P

14. What is the voltage gain of an amplifier at the half power points on the
amplifier response curve?

0.5

0.707

1.414

2
Correct Answer : b Explanation : These half power points corresponds to a fall in gain of 3dB (0.7071)
relative to its maximum dB value. Most amplifiers and filters have a flat frequency response characteristic in which the
bandwidth or passband section of the circuit is flat and constant over a wide range of frequencies.

15. A differential amplifier has a differential gain of 20,000. CMMR=80dB.


The common mode gain is given by

0.5
0
Correct Answer : a Explanation : CMRR = Ad/Acm

16. Specific energy consumption is least in _______ service

main line

urban

Suburban

None of these
Correct Answer : a Explanation : Since main line is allocated for transmission purpose, the Specific
energy consumption is less.

17. _______ was the first city in India to adopt electric traction.

Delhi

Madras

Calcutta

Bombay
Correct Answer : d Explanation : Bombay was the first city in India to adopt electric
traction.

18. _______ frequency is not common in low frequency traction system

40 Hz

25 Hz

16 Hz

None of the above


Correct Answer : a Explanation : Low-frequency voltage fluctuation of traction network
around 40 Hz has been found frequently, which affects both traction power supply system (TPSS) and utility system
seriously.

19. Which of the following is the output of Source Selection?

Proposals.
Evaluation criteria.

Contract negotiation.

Contract.
Correct Answer : d Explanation : People is the least constraint for a project

20. Which of the following is an acceptable reason in a project delay?

Strike of labors

Delay integrating license

Bad quality work

None of the above


Correct Answer : b Explanation : Delay integrating license is one of the main and acceptable reason
in a project delay.

21. For a base current of 10 μA, what is the value of collector current in
common emitter if βdc = 100

10 μA

100 μA

1 mA

10 mA
Correct Answer : c Explanation : IC = 10 x 100 μA = 1 mA.

22. Terminal representing control input of BJT

Emitter

Base

Collector

None of the above


Correct Answer : b Explanation : Collector current can be controlled by varying the base
current

23. Transconductance of BJT is


dIE/dIC

VBE/IE

IE/IC

Ic/VBE
Correct Answer : d Explanation : The transconductance for the bipolar transistor can be
expressed as. where IC = DC collector current at the Q-point, and VT = thermal voltage, typically about 26 mV at room
temperature.

24. Information to develop a project network is collected from the

Organization breakdown structure

Work breakdown structure

Budget

Project proposal
Correct Answer : b Explanation : In a Work Breakdown Structure such elements (activity or
deliverable), also known as work packages, are the items that are estimated in terms of resource requirements, budget and
duration; linked by dependencies; and scheduled.

25. A 3-phase 440 V, 50 Hz induction motor has 4% slip. The frequency of


rotor e.m.f. will be

200 Hz

50 Hz

2 Hz

0.2 Hz
Correct Answer : c Explanation : s = 0.04, rotor frequency = s*f = 0.04*50 = 2 Hz

Question 26

N-channel FETs are superior to p-channel FETs because

mobility of electrons is smaller than that of holes

mobility of electrons is greater than that of holes

they consume less power


they have high switching time
Correct Answer : b Explanation : High switching device. (mobility of electrons is high)

You might also like