Narayana IIT Academy 04-08-24_JR.

STAR CO-SC(MODEL-A)_JEE-ADV_WAT-16_QP
PHYSICS Max. Marks: 61
SECTION – I
(MULTIPLE CORRECT ANSWER TYPE)
This section contains 7 multiple choice questions. Each question has 4 options (A), (B), (C) and (D) for its answer,
out of which ONE OR MORE than ONE option can be correct.
Marking scheme: +4 for all correct options & +1 partial marks, 0 if not attempted and -2 in all wrong cases
19. Three masses A, B and C are kept on the smooth horizontal surface as shown in the
figure. A sharp jerk is given to the mass A, so that it starts moving towards B with speed
V 0. For what value(s) of m is there only one collision between masses A and B. (all
collisions are elastic)

A) M B) 3M C) 4M D) 5M

20. An object of mass m1 and another of mass m2 are dropped from a height h, the second
one immediately following the first one. All collisions are perfectly elastic and occur
along a vertical line. m1 comes to rest after the collisions while m2 bounces up.

m1
A) Ratio of the masses =3
m2

m1
B) Ratio of the masses =2
m2

C) Height to which m2 rises after the collision is 3h measured from its lowest point in
the trajectory.

D) Height to which m2 rises after the collision is 4h measured from its lowest point in
the trajectory.

JR.IIT_*CO-SC Page. No. 7

Narayana IIT Academy 04-08-24_JR.STAR CO-SC(MODEL-A)_JEE-ADV_WAT-16_QP
21. A horizontal frictionless rod is threaded through a bead of mass m. The length of the cart
is L and the radius of the bead, r, is very small in comparison with L (r << L). Initially at
(t = 0) the bead is at the right edge of the cart. The cart is struck and as a result, it moves
with velocity 0 . When the bead collides with the cart’s walls, the collisions are always
completely elastic. (Given: m > M). Select the correct options.

2M
A) Velocities of bead and cart after the first collision in ground frame is Vm V0
m M
m M
rightward and VM V0 leftward.
M m

MV0
B) Velocities of bead and cart after the first collision in COM frame are Vm CM
M m
mV0
rightward and VM leftward.
CM
M m

2L
C) Time at which the second collision happens is t
V0

3L
D) Time at which the third collision happens is t
V0

R
22. A uniform chain of length is lying symmetrically on the top of a fixed smooth half
2

cylinder (see figure) of radius R. The chain is pulled slightly from one side and released.
It begins to slide at t = 0. The centre of cross-sectional semi-circle is O and the
instantaneous point at which the centre of mass is located is named C. rc , VE & VC are
0

respectively the distance of centre of mass of the chain from point O, speed of the end E
and speed of the centre of mass of the chain relative to the ground.

JR.IIT_*CO-SC Page. No. 8

Narayana IIT Academy 04-08-24_JR.STAR CO-SC(MODEL-A)_JEE-ADV_WAT-16_QP

The end E of the chain hits the ground at t = t0. Then

2 2 4 2 1 gR
A) at t = 0, rc 0
R B) at t = t 0 , VE

4 2 1 gR 32 2 1 gR
C) at t = t 0 , VC D) at t = t 0 , VC 3

23. A pendulum bob of mass m connected to the end of an ideal string of length l is released
from rest from horizontal position as shown in the figure. At the lowest point the bob
makes an elastic collision with a stationary block of mass 5m, which is kept on a
frictionless surface. Mark out the correct statements (s) for the instant just after the
impact.

17
A) Tension in the string is mg
9

B) Tension in the string is 3 mg.

2 gl
C) The velocity of the block is
3

D) The maximum height attained by the pendulum bob after impact is ( measured from
4l
the lowest position)
9

JR.IIT_*CO-SC Page. No. 9

Narayana IIT Academy 04-08-24_JR.STAR CO-SC(MODEL-A)_JEE-ADV_WAT-16_QP
24. Two blocks of masses 2kg and 3kg are connected by string of length 1m. At any instant
the velocities of block of mass 2kg and 3kg is 5 m/s in opposite direction and
perpendicular to the length of string and is also parallel to horizontal table.

A) Tension in the string is 110 N

B) Tension in the string is 120 N

C) Speed of centre of massafter 1s is 1 m/s

D) Speed of centre of mass after 1s is 2 m/s

25. The inclined surface of two movable wedges of the same mass M are smoothly
conjugated with the horizontal plane (Figure). A washer of mass m slides down the left
wedge from a height h. There is no friction anywhere. The speed of m just when it
reaches the lowestpoint isu. Then

M
A) u 2 gh
M m

m
B) Final speed of the left wedge is u
M

m
C) Speed of the right wedge when the washer reaches the highest points on it is u.
M m

M2
D) The maximum height reached by the washer on the right wedge is hmax 2
h
M m

JR.IIT_*CO-SC Page. No. 10

Narayana IIT Academy 04-08-24_JR.STAR CO-SC(MODEL-A)_JEE-ADV_WAT-16_QP
SECTION-II
(INTEGER ANSWER TYPE)
This section contains 5 questions. The answer is a single digit integer ranging from 0 to 9 (both inclusive).
Marking scheme +3 for correct answer , 0 if not attempted and 0 in all other cases.
26. A symmetric block of mass m with a notch of hemispherical shape of radius r = 0.8m

rests on a smooth horizontal surface near the wall (Fig). A small washer of same mass m
slides without friction from the initial position as shown.

The maximum velocity of the block is n m/s. The value of n is

27. A small ball of mass m is connected by an inextensible massless string of length l = 2m

with an another ball of mass M = 4m. They are released with zero tension in the string
from a height h = 0.2m as shown in figure. Find the time (in seconds) when the string
becomes taut for the first time after the mass M collides with the ground. Take all
collisions to be elastic.

28. As shown in the figure, a smooth hemisphere of radius R is fixed to the top of a cart total
mass of the cart is M, and it is initially at rest. A point like ball of mass m is dropped
into the hemisphere tangentially, from a point h = R above its edge. The ball slides all
the way along the hemisphere with negligible friction. The ball reaches the maximum

JR.IIT_*CO-SC Page. No. 11

Narayana IIT Academy 04-08-24_JR.STAR CO-SC(MODEL-A)_JEE-ADV_WAT-16_QP
height during its subsequent motion when the magnitude of its horizontal displacement
from its initial position is x. The value of 10x is

(Let R = 0.5 m, M = 2kg, m = 0.5 kg, use g 10m / s 2 )

29. Figure shows a small block of mass m = 1 kg which is given a horizontal velocity 0 =
10 m/s on the horizontal part of the bigger block of mass M = 9 kg placed on a
horizontal floor. The curved part of the surface shown is semicircular of radius R = 1 m.
The distance from point B where the block m lands finally after looping the semicircular
part BCD is d. The integer nearest to the value of d in meters is (Neglect friction
everywhere. Assume that the horizontal portion AB is long enough. g 10 m / s 2

30. The distance of centre of mass from O of a uniform plate having quarter circular inner
x 2
and outer boundaries of radii a and b (=2a) is found to be b . The value of x – y is
y

JR.IIT_*CO-SC Page. No. 12

Narayana IIT Academy 04-08-24_JR.STAR CO-SC(MODEL-A)_JEE-ADV_WAT-16_QP
SECTION – III
(SINGLE CORRECT ANSWER TYPE)
This section contains 6 multiple choice questions. Each question has 4 options (A), (B), (C) and (D) for its answer,
out of which ONLY ONE option can be correct.
Marking scheme: +3 for correct answer, 0 if not attempted and -1 in all other cases.
Answer Q,31, Q,32 and Q,33 by appropriately matching the information given in the three
columns of the following table.
Two particles of masses m & M are located in a smooth and fixed circular groove
located on a horizontal plane. M is initially at rest. m moves with speed v0 towards M
and collides with M for the first time at t = 0. Columns give the value of ratio of masses
(M/m), time taken for 2nd collision and speed of M right after the 2nd collision, all in SI
units. Assume 2 R / v0 1s.

Time taken for 2nd

M/m Speed of M after 2nd collision
collision
10
I) 1 i) P) v0
33
II) 2 ii) 2 Q) 0
3
III) 3 iii) 1 R) v0
16
IV) 4 iv) 3 S) No second collision
31. Which combination holds true if e = 1

A) I, ii, R B) II, iv, P C) I, iii, Q D) I, i, P

32. Which combination holds true if e = 0

A) I, i, S B) II, i, S C) I, iii, R D) II, i, R

33. Which combination holds true if e = ½

A) IV, iv, P B) III, iv, P C) IV, ii, R D) III, ii, R

JR.IIT_*CO-SC Page. No. 13

Narayana IIT Academy 04-08-24_JR.STAR CO-SC(MODEL-A)_JEE-ADV_WAT-16_QP
Answer Q,34, Q,35 and Q,36 by appropriately matching the information given in
the three columns of the following table.
A particle falls from a height h = 0.2m on ground and rebounds. The given columns give
the coefficient of restitution (e), average speed (< v >) and magnitude of average
velocity ( v ) for the total time of motion different cases. Take g = 10 m/s2.

e <v> v

1 5
I) i) P) 3 2 2
2 9
1 41
II) ii) Q) 5 2 6
2 81

2 1
III) iii) 9 6 2 R)
3 9

4 1
IV) iv) 25 10 6 S)
5 3

34. For which of the following will the particle rise to half the original height after first
impact?

A) II, i, S B) II, iii, P C) I, iii, P D) I, i, S

35. For which of the following will the total distance covered be 1 metre?

A) III, iv, Q B) III, iv, P C) III, iii, Q D) III, iii, P

36. For which of the following is the total time of motion equal to nine times the time of
initial fall?

A) IV, ii, R B) I, iv, P C) I, iii, S D) IV, ii, R

JR.IIT_*CO-SC Page. No. 14