EcoFlow Wave 2 Add-on Battery

User Manual V1.0

 Disclaimer

Please read the product document and ensure that you understand it fully before using the
product. After reading this document, keep it properly for future reference. Improper use of this
product may cause serious injury to yourself or others, or cause product damage and property
loss. Once you use this product, it is deemed that you understand, approve and accept all the
terms and content in this document. EcoFlow is not liable for any loss caused by the user's
failure to use the product in compliance with the Disclaimer and Safety Instructions.

In compliance with laws and regulations, EcoFlow reserves the right to final interpretation of
this document and all documents related to the product. This document is subject to changes
(updates, revisions, or termination) without prior notice. Please visit EcoFlow's official website
to obtain the latest product information.
Contents

Specifications 1

Safety Instructions 2

Use 2

Disposal 3

What's in the Box 3

Product Details 4

Power On/Off 4

Charging Your Devices 5

Charging Wave 2 5

Charging Other Devices 6

Charging the Add-on Battery 7

AC Charging (Household Outlet) 7

Solar Charging 7

Car Charging 8

Battery Pack Charging 8

Indicator Light and Troubleshooting 9

Care and Maintenance 9

Specifications
Input/Output Specifications
Model EFKT210-EB

Capacity 1159 Wh (50.4 V 23 Ah)

USB-A Output 5/9/12 V 2.4/2/1.5 A, 18 W max

USB-C Output 5/9/12/15/20 V 5 A , 100 W max

XT150 Input Power 857 W max
XT150 Output Power 712 W max
Battery Life 2-8 hours

Battery Specifications
Battery Cell Material NCM ternary lithium battery

Cycle Life 80%+ capacity after 800 cycles

IP Rating IP65

Operating Temperature
Optimal Operating Temperature 20°C—45°C (68°F to 113°F)

Discharging Temperature -20°C—50°C (-4°F to 122°F)

Charge Temperature 0°C—45°C (32°F to 113°F)

Ordinary temperature
Storage Temperature
optimal: 20°C—30°C (68°F—86°F)

General Information
Net Weight Approximately 7.8 kg (17.2 lbs)

Dimensions (L × W × H) 515×272×92 mm (20.3×10.7×3.6 inch)

1
 Safety Instructions
Use
1. Do not use the product near a heat source, such as fire or a heater, and avoid direct
exposure to sunlight.
2. Strictly comply with the recommended ambient temperature set in this user manual when
using this product. If the temperature is too high, the battery may catch fire or explode. If
the temperature is too low, the product may not work normally.
3. If the product catches fire, we recommend that you use fire extinguishers in the following
order: water or water mist, sand, fire blanket, dry powder, and carbon dioxide.
4. If the product is wet inside or it falls into water by accident, immediately stop using the
product, turn off the power supply, and place it in a safe open area. Stay away from the
product until it is dry. Please take measures to prevent electric shock when touching it.
Do not operate or discard the dry product without authorization. Please contact customer
service to dispose of it properly.
5. If there is dirt in or on any outlets, clean it with a dry cloth.
6. Do not use this product in environments with strong static electricity or magnetic fields (such
as thunderstorm).
7. Do not place the product where the air pressure is extremely low, as this may cause
flammable liquids to leak or explode.
8. Do not pile heavy objects on the product.
9. Please store the product in a dry and ventilated space.
10. Please keep the product out of the reach of children and pets.
11. For long-term storage, please discharge and then charge the product every three months
(discharge it to 0% first, and then charge it to 30%-50% for long-term storage). The
product will not be covered by the warranty if it is not charged or discharged for more
than 6 months.
12. Electromagnetic fields created by this product may affect the normal functioning of
medical implants or personal medical devices, such as pacemakers, cochlear implants,
hearing aids, defibrillators and so on. If you are using these medical devices, please
consult the manufacturers about the restrictions on the use of relevant devices to ensure
that a safe distance is maintained between this product and the implanted medical
devices (such as pacemakers, cochlear implants, hearing aids, defibrillators and so on)
during operation.
13. Do not disassemble the product in any way or pierce it with sharp objects.
14. Do not touch product outlets with wires or other metal objects. Please do not wear any
metal jewelry when plugging/unplugging the power cord to avoid a short circuit.
15. During the operation or transportation of the product, please avoid external damage, like
drops or impact. In case of a strong external impact, immediately stop using the product
and turn off the power supply.
16. If the battery has severe swelling, please stop using it, and properly dispose of it
according to the method in Article 2 of [Disposal].

2
17. If the case of the product falls off, the inside is exposed or other conditions arise, please
stop using it. Contact the manufacturer, dealer or qualified electrical engineer for repair and
replacement.
18. Do not use unofficial wiring or accessories since they will void your warranty. If they need
to be replaced, please purchase them through the official EcoFlow distribution channels.

Disposal
1. Whenever possible, please completely discharge the battery before placing the product in
the designated battery recycling bin. Batteries are hazardous chemicals and should not be
disposed of in ordinary trash cans. For details, please follow local laws and regulations on
battery recycling and disposal.
2. If the battery cannot be completely discharged due to product failure, please do not dispose
of the battery directly in the battery recycling bin, and contact a professional battery
recycling company for further processing.
3. If the battery will not start after over discharging, please dispose of it.

What's in the Box

Wave 2 add-on battery DC charging cable User Manual &

Warranty Card

3
Product Details

❶ ❺
❷ ❹
❸

1. A
 dd-on battery socket 2. Unlock button 3. USB-C output port
(XT150)
5. Indicator lights 6. Power button
4. USB-A output port

Power On/Off
After the battery is connected to Wave 2, turn on Wave 2 to power the battery at the same
time. If used separately, long press the main power button to power on/off the product.During
first use, long press the power button for 3 seconds to activate the product.

When the battery is charging other devices, it can't be turned off by long pressing the main
power button unless the charging cable is unplugged first.

1s

Long press to
power-on/off

4
Charging Your Devices

Charging Wave 2

Installation

1. Align the connecting positions 2. Slide forward

ON

3. Connect the plug and turn the power on

5
Disassembly
3s

OFF

1. Power off and remove the plug 2. Press and hold the unlock
button, and slide it backward

3. Remove Wave 2

1. If Wave 2 and the battery are to be moved, ensure that they are secured in position,
and handle them as smoothly as possible to prevent them from falling.
2. D o not directly remove the cable to avoid damaging the battery cell.

Charging Other Devices

After the battery is started, the device can be charged through the USB port.

6
Charging the Add-on Battery
The add-on battery can be charged from AC outlets, portable power stations, car charging
outlets, and solar panels.

Except for when charging with a portable power station, other charging methods can only be
used after the add-on battery is connected to Wave 2 to avoid product damage caused by a
voltage mismatch. Refer to the Wave 2 User Manual for more requirements.

AC Charging (Household Outlet)

AC
outlet

Maximum input power: 857 W

Solar Charging

Solar panel

Solar panel charging cable

(sold separately)
Maximum input power: 400 W

Turn off Wave 2 when charging the add-on battery for improved charging efficiency.

7
 Car Charging

Car charging cable

(sold separately)

Maximum input power: 200 W

Battery Pack Charging

EcoFlow portable power station (DELTA series)

Extra battery connection cable (sold separately)

8
Indicator Light and Troubleshooting
Off Solid white Flashing white Flashing orange

Type Indicator status Indications

Power-on LEDs 1-4 turn on in order

Power-off LEDs 4-1 turn off in order
≤5%

Discharging ≤25%
≤50%
level
≤75%
≤100%
≤25%
Charging
75% - 99%
level
100%
Firmware update LEDs 2-3 flash alternately
USB fault Contact customer service for help.
The temperature
Restart after the unit temperature drops.
is too high
The temperature
Restart after the unit temperature rises.
is too low
Permanent fault Contact customer service for help.

Care and Maintenance

1. Use or store this product within an ambient temperature range of 20°C-45°C (68°F-113°F),
and keep away from water sources, heat sources, and metal objects.
2. For long-term storage, please recharge the product every three months (discharge it to
0% first, and then charge it to 30-50% for long-term storage). If the battery has been idle
for a long time with low power, it will cause irreversible damage to the battery cells. The
product will not be covered by the warranty if it is not charged or discharged for more than
6 months.
3. For safety, please do not store the product in ambient temperatures higher than 45°C (68°F)
or lower than -10°C (14°F) for a long time.
4. If the product has been idle for too long and the power level is 0%, it will enter a deep
sleep protection mode. Charge the product before using it again.