Bulletin PD-20300 rev.

C 01/04

30CTQ060
30CTQ060S
30CTQ060 -1
SCHOTTKY RECTIFIER 30 Amp

IF(AV) = 30Amp
VR = 50 - 60V

Major Ratings and Characteristics Description/ Features

This center tap Schottky rrectifier has been optimized for very
Characteristics 30CTQ Units low forward voltage drop, with moderate leakage. The
proprietary barrier technology allows for reliable operation
IF(AV) Rectangular 30 A up to 150° C junction temperature. Typical applications are
in switching power supplies, converters, free-wheeling
waveform
diodes, and reverse battery protection.
VRRM 50 - 60 V 150° C TJ operation
Center tap configuration
IFSM @ tp = 5 µs sine 1000 A
Very low forward voltage drop
VF @ 15 Apk, TJ = 125°C 0.56 V High purity, high temperature epoxy encapsulation for
enhanced mechanical strength and moisture resistance
(per leg)
High frequency operation
TJ range - 55 to 150 °C Guard ring for enhanced ruggedness and long term
reliability

Case Styles

30CTQ... 30CTQ... S 30CTQ... -1

Base Base Base

Common Common Common
Cathode Cathode Cathode
2 2 2

2 2 2
1 Common 3 1 Common 3 1 Common 3
Anode Cathode Anode Anode Cathode Anode Anode Cathode Anode

TO-220 D2PAK TO-262

www.irf.com 1
30CTQ... Series
Bulletin PD-20300 rev. C 01/04

Voltage Ratings
Part number 30CTQ050 30CTQ060
VR Max. DC Reverse Voltage (V) 50 60
VRWM Max. Working Peak Reverse Voltage (V)

Absolute Maximum Ratings

Parameters Values Units Conditions
IF(AV) Max. Average Forward (Per Leg) 15 A 50% duty cycle @ TC = 105°C, rectangular wave form
Current * See Fig. 5 (Per Device) 30
IFSM Max. Peak One Cycle Non-Repetitive 1000 5µs Sine or 3µs Rect. pulse Following any rated
A load condition and with
Surge Current (Per Leg) * See Fig. 7 260 10ms Sine or 6ms Rect. pulse rated V RRM applied
EAS Non-Repetitive Avalanche Energy 13 mJ TJ = 25 °C, I AS = 1.50 Amps, L = 11.5 mH
(Per Leg)
IAR Repetitive Avalanche Current 1.50 A Current decaying linearly to zero in 1 µsec
(Per Leg) Frequency limited by TJ max. VA = 1.5 x VR typical

Electrical Specifications
Parameters Values Units Conditions
VFM Max. Forward Voltage Drop 0.62 V @ 15A
TJ = 25 °C
(Per Leg) * See Fig. 1 (1) 0.82 V @ 30A
0.56 V @ 15A
TJ = 125 °C
0.71 V @ 30A
IRM Max. Reverse Leakage Current 0.80 mA TJ = 25 °C
VR = rated VR
(Per Leg) * See Fig. 2 (1) 45 mA TJ = 125 °C
VF(TO) Threshold Voltage 0.39 V TJ = TJ max.
rt Forward Slope Resistance 8.47 mΩ
CT Max. Junction Capacitance (Per Leg) 720 pF VR = 5VDC (test signal range 100Khz to 1Mhz) 25°C
LS Typical Series Inductance (Per Leg) 8.0 nH Measured lead to lead 5mm from package body
dv/dt Max. Voltage Rate of Change 10000 V/ µs
(Rated VR)
(1) Pulse Width < 300µs, Duty Cycle <2%
Thermal-Mechanical Specifications
Parameters Values Units Conditions
TJ Max. Junction Temperature Range -55 to 150 °C
Tstg Max. Storage Temperature Range -55 to 150 °C
RthJC Max. Thermal Resistance Junction 3.25 °C/W DC operation
to Case (Per Leg)
RthJC Max. Thermal Resistance Junction 1.63 °C/W DC operation
to Case (Per Package)
RthCS Typical Thermal Resistance, Case 0.50 °C/W Mounting surface , smooth and greased
to Heatsink (only for TO-220)
wt Approximate Weight 2 (0.07) g (oz.)
T Mounting Torque Min. 6 (5) Kg-cm
Max. 12 (10) (Ibf-in)

2 www.irf.com
 30CTQ... Series
Bulletin PD-20300 rev. C 01/04

1000 1000

100 TJ = 150°C

Reverse Current - IR (mA)

125°C
10
100°C
1 75°C

TJ = 150°C 0.1 50°C

Instanta neous Forward Current - IF (A)

100 TJ = 125°C 25°C

0.01
TJ = 25°C
0.001
0 10 20 30 40 50 60
Reverse Voltage - VR (V)
Fig. 2 - Typical Values Of Reverse Current
Vs. Reverse Voltage (Per Leg)
1000
Junction Capacitanc e - C T (pF)

10
TJ = 25°C

1 100
0 0.4 0.8 1.2 1.6 2 0 10 20 30 40 50 60
Forward Voltage Drop - V FM (V) Reverse Voltag e - VR (V)
Fig. 1 - Max. Forward Voltage Drop Fig. 3 - Typical Junction Capacitance
Characteristics (Per Leg) Vs. Reverse Voltage (Per Leg)

10
Thermal Impedance Z thJC (°C/ W)

D = 0.75
D = 0.50
D = 0.33 PDM
0.1 D = 0.25
D = 0.20
t1
t2
0.01 Notes:
Single Pulse 1. Duty fac tor D = t 1/ t 2
(Thermal Resistance)
2. Peak TJ = PDM x Z thJC+ TC
0.001
0.00001 0.0001 0.001 0.01 0.1 1 10 100
t 1 , Rectangular Pulse Duration (Seconds)
Fig. 4 - Max. Thermal Impedance ZthJC Characteristics (Per Leg)

www.irf.com 3
30CTQ... Series
Bulletin PD-20300 rev. C 01/04

160 14
D = 0.20
150
Allowable Case Temperature - (°C)

12 D = 0.25

Average Power Loss - (Watts)

140 D = 0.33
D = 0.50
130 10
D = 0.75
DC DC
120
8
110 RMS Limit

100 Square wave (D = 0.50) 6

80% Ra ted VR a p plied
90 4
80
2
70
see note (2)
60 0
0 5 10 15 20 25 0 5 10 15 20 25
Average Forward Current - I F(AV) (A) Average Forward Current - I F(AV) (A)

Fig. 5 - Max. Allowable Case Temperature Fig. 6 - Forward Power Loss Characteristics
Vs. Average Forward Current (Per Leg) (Per Leg)
1000
Non-Repetitive Surge Current - I FSM (A)

At Any Rated Load Condition

And With Rated VRRM Applied
Following Surge

100
10 100 1000 10000
Square Wave Pulse Duration - t p (microsec)
Fig. 7 - Max. Non-Repetitive Surge Current (Per Leg)

HIGH-SPEED
DUT IRFP460 SWITCH

FREE-WHEEL
Rg = 25 ohm Vd = 25 Volt
DIODE +

CURRENT 40HFL40S02
MONITOR

Fig. 8 - Unclamped Inductive Test Circuit

(2) Formula used: TC = TJ - (Pd + PdREV) x RthJC ;

Pd = Forward Power Loss = IF(AV) x VFM @ (IF(AV) / D) (see Fig. 6);
PdREV = Inverse Power Loss = VR1 x IR (1 - D); IR @ VR1 = 10 V

4 www.irf.com
 30CTQ... Series
Bulletin PD-20300 rev. C 01/04

Outline Table

10.54 (0.41)
1.32 (0.05)
MAX. 3.78 (0.15)
DIA. 1.22 (0.05)
3.54 (0.14)
6.48 (0.25)
2.92 (0.11) 6.23 (0.24)
15.24 (0.60)
2.54 (0.10)
14.84 (0.58) TERM 2
2°
1 2 3

Base
14.09 (0.55) 3.96 (0.16) Common
13.47 (0.53) 3.55 (0.14) 0.10 (0.004) Cathode
2

2.04 (0.080) MAX.

1.40 (0.05) 2.89 (0.11)
1.15 (0.04) 2.64 (0.10)
0.94 (0.04)
2
0.69 (0.03) 1 Common 3
Anode Cathode Anode

1 2 3 0.61 (0.02) MAX.

4.57 (0.18)
4.32 (0.17)

5.08 (0.20) REF.

Conform to JEDEC outline TO-220AB
Dimensions in millimeters and (inches)

Base
Common
Cathode
2

2
1 Common 3
Anode Cathode Anode

Conform to JEDEC outline D2Pak (SMD-220)

Dimensions in millimeters and (inches)

www.irf.com 5
30CTQ... Series
Bulletin PD-20300 rev. C 01/04

Outline Table

Base
Common
Cathode
2

2
1 Common 3
Anode Cathode Anode

Modified JEDEC outline TO-262

Dimensions in millimeters and (inches)

Marking Information

PART NUMBER
THIS IS A 30CTQ060S WITH INTERNATIONAL
LOT CODE 58 07 RECTIFIER
ASSEMBLED ON WW 21, 2000 LOGO
IN THE ASSEMBLY LINE "L" DATE CODE
YEAR 0 = 2000
ASSEMBLY
LOT CODE WEEK 21
LINE L

6 www.irf.com
 30CTQ... Series
Bulletin PD-20300 rev. C 01/04

Tape & Reel Information

TRR

1.60 (0.063)
1.50 (0.059)
1.60 (0.063)
4.10 (0.161) DIA.
1.50 (0.059)
3.90 (0.153) 0.368 (0.0145)
0.342 (0.0135)
FEED DIRECTION
1.85 (0.073) 11.60 (0.457)
1.65 (0.065)
11.40 (0.449)
24.30 (0.957)
15.42 (0.609)
23.90 (0.941)
TRL 15.22 (0.601)

1.75 (0.069)
DIA.
10.90 (0.429) 1.25 (0.049)
4.72 (0.186)
10.70 (0.421) 16.10 (0.634) 4.52 (0.178)
15.90 (0.626)

FEED DIRECTION

13.50 (0.532) 26.40 (1.039)

12.80 (0.504) DIA. 24.40 (0.961)

SMD-220 Tape & Reel

When ordering, indicate the part
number, part orientation, and the
quantity. Quantities are in multiples
of 800 pieces per reel for both
60 (2.362) TRL and T RR.
360 (14.173)
DIA. MIN.
DIA. MAX.

Dimensions in millimeters and (inches)

Ordering Information Table

Device Code
30 C T Q 060 -1

1 2 3 4 5 6

1 - Essential Part Number

2 - C = Common Cathode
3 - T = TO-220
4 - Q = Schottky Q Series
050 = 50V
5 - Voltage Rating
060 = 60V
6 - 1 = TO-262
S = D2Pak

www.irf.com 7
30CTQ... Series
Bulletin PD-20300 rev. C 01/04

Data and specifications subject to change without notice.

This product has been designed and qualified for Industrial Level.
Qualification Standards can be found on IR's Web site.

IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245, USA Tel: (310) 252-7105
TAC Fax: (310) 252-7309
Visit us at www.irf.com for sales contact information. 01/04

8 www.irf.com