Scribd
Upload
11 views

TailScrape_brochure_EN

Uploaded by

Behnam Safabahar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views

TailScrape_brochure_EN

Uploaded by

Behnam Safabahar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

WORKING PRINCIPLE

Thorsten Koth
Sales & Distribution

Phone +49 2842 9 32 92 94


Mobile +49 171 1 24 22 59
[email protected]
scrapetec-trading.com

Wilfried Dünnwald
Managing partner
Like AirScrape ®, the TailScrape works according Product development & Sales
to the Venturi concept. The intelligent blade Phone +49 2842 9 32 92 92
Mobile +49 172 1 57 30 89
structure on the underside ensures that negative [email protected]
pressure is created in the conveying area. scrapetec-trading.com

Nothing can escape through the millimeter- THE


thick gap because the negative pressure allows TRANSFER TAIL SKIRTING
air to flow in. Dust generation and spills are
reduced by up to 100%. The TailScrape works
without contact to the belt and can therefore be
operated permanently without maintenance. Used
together with the AirScrape, the TailScrape saves
considerable costs and resources.
ScrapeTec Trading GmbH
In addition, the strong reduction in dust generation
Altfelder Straße 190
and contamination meets the requirements for 47475 Kamp-Lintfort, Germany

occupational health and environmental protection. Phone +49 2842 9 32 92 93


[email protected]
scrapetec-trading.com

TSBR2101V01EN
NO
BELT CONTACT ADVANTAGES & BENEFITS

NO • high efficiency with coarse material (no spillage


BELT DAMAGE and at the same time long service life of the special
lamellae)

• high efficiency with fine material (dust is kept in the


material flow by air intake)

• reduces dust generation and the risk of explosion


HOVERS EASY INSTALLATION
OVER BELT • no belt contact and therefore no damage to the belt

MAINTENANCE FREE • reduces the load on the drive system (no belt
friction)
WEAR FREE
• extends belt life

IDEAL • no wear of the skirting due to friction


SUPPLEMENT TO THE DESIGNS AND VARIANTS
• reduces maintenance and replacement costs
The TailScrape is available in small, medium and large for all belt significantly
widths to match the AirScrape variants and can be mounted so
precisely to the existing AirScrape that it seals the transfer to the • simple installation
bend avoiding dust or spillage.
• no gap in connection with the AirScrape

• contributes to occupational safety, environmental


protection and health protection
INSTALLATION
• can be made of flame-resistant and antistatic
In the rear area of the transfer a metal sheet is used matching the material
contour of the belt trough. Ideally, the sheet is mounted at a maxi-
mum distance of 10 mm from the belt. The TailScrape is shortened • in FDA approved material available
to the distance between the two AirScrapes mounted on the side
and bent to fit the trough. The TailScrape is fixed and adjusted to • in heat resistant material on request
the sheet by means of slotted holes and lifting elements allowing
almost no gap and contact to the belt.

You might also like