DENSO NEC76F0039GD 275036-1150 TOYOTA
plugin 1069
WARNING : for a correct identification of the ECU it is necessary to open the ECU and always
check that the ECU numbers printed on the motherboard are the same as the numbers declared
on the manual. Do not trust the numbers on the ECU cover.
https://ecu.design
DENSO NEC76F0039GD 275036-1150 TOYOTA
https://ecu.design
DENSO NEC76F0039GD 275036-1150 TOYOTA
DIRECT CONNECTION
For the connection use the cable F32GN037C connected to the ECU.
Make sure that the POWER led (red) on Trasdata is ON.
These connections are required for all the connection approaches: loose wires, soldering adapter,
metal positioning frame adapter.
ECU CONNECTOR
https://ecu.design
DENSO NEC76F0039GD 275036-1150 TOYOTA
LOOSE WIRES CONNECTION:
For the READING and WRITING procedure use the FLAT cable F34NTF53
https://ecu.design
DENSO NEC76F0039GD 275036-1150 TOYOTA
WARNING: for a correct reading and writing operation it is necessary to perform a LINK
between the pads displayed in the picture here below. Remove the LINK before placing back the
ECU into the car.
https://ecu.design
DENSO NEC76F0039GD 275036-1150 TOYOTA
F34NTA16 Soldering adapter connection or
F34DM023 metal positioning frame adapter connection.
In both cases, for a correct connection, it is necessary to identify the pin 1 for the reading&writing
procedures and the pin 18 to enable the Microprocessor communication.
https://ecu.design
DENSO NEC76F0039GD 275036-1150 TOYOTA
F34NTA16 Soldering adapter connection
By using the grey wire supplied with the adapter connect the pad 18 (see pg.6) to the specific
connector on the adapter itself.
The following picture of the F34NTA16 adapter connection is merely indicative.
https://ecu.design
DENSO NEC76F0039GD 275036-1150 TOYOTA
F34DM023 DIMA adapter connection
By using a wire connect the pad 18 (see pg.6) to the specific orange clamp ENA present on the
F34DM023 adapter.
The following picture of the F34DM023 adapter connection is merely indicative.
https://ecu.design
