Scribd
Upload
12 views

Strength of Materials-i October-2020

Uploaded by

prudvilovely4338
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
12 views

Strength of Materials-i October-2020

Uploaded by

prudvilovely4338
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Code No: 153BU

R18
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
B.Tech II Year I Semester Examinations, October - 2020
STRENGTH OF MATERIALS - I
(Civil Engineering)
JN

Time: 2 hours Max. Marks: 75


Answer any five questions
All questions carry equal marks
---
TU

1.a) Derive the relationship between the three elastic constants.


b) Derive an expression for strain energy stored in a body when the load is applied with an
impact. [7+8]
H

2. A steel tube of internal diameter 100mm and external diameter 125mm is surrounded by
a brass tube of external diameter 150mm. The composite bar is subjected to an axial pull
U

of 10KN. Find the load carried by each tube and the stresses and strains developed in
them if Es= 200GPa and Eb= 100GPa. [15]
SE

3. A simply supported beam AB of span 10m carries a UDL of 20N/m over 3m from left
hand support and also over 4m from the right-hand support. It has also two isolated loads
of 20KN and 60KN at 3m and 8m respectively from the left hand support. Draw the B.M
D

and S.F diagrams and calculate the B.M at significant points. [15]

4. Construct S.F.D and B.M.D for a simply supported beam shown in Figure. [15]
07
-1
1-

5. Obtain the shear stress distribution for a rectangular cross section 230×40mm subjected
to a shear force of 40KN. Calculate the maximum and average shear stress. [15]
20

6. Derive the bending equation from fundamentals M/I = f/y = E/R. [15]

7.a) Determine slope and deflection of a cantilever loaded with a point at the free end using
20

Moment Area method.


b) Find the deflection at the free end of a cantilever of length ‘L’ subjected to UDL of
intensity ‘w’ per unit length over its entire span. Use Double integration method. [7+8]
AM

8. Derive an expression for the distortion energy per unit volume when a body is subjected
to principal stresses σ1, σ2 and σ3. [15]

---ooOoo---

You might also like