0% found this document useful (0 votes)
7 views

Instructions to Author

Uploaded by

Anagha somalkar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
7 views

Instructions to Author

Uploaded by

Anagha somalkar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

INSTRUCTION TO AUTHOR

International Journal of Technology (IJT)


International Journal of Technology (IJT) [ISSN- 2231-3907 File size
(Print) ; 2231-3915 (Online)] is an international, peer-reviewed No article should exceed more than 10 pages unless necessary,
journal, research journal aiming at promoting and publishing authors will be requested to substantiate the need if it exceeds the
original high quality research in all disciplines of engineering maximum number of pages. The file size of the MS word format
sciences and technology. Viz. Mechanical Engineering, Civil may not exceed 10 MB size for submission through manuscript
Engineering, Electrical Engineering, Electronics and submission portal of www.anvpublication.org.
Telecommunication Engineering, Computer Engineering,
Chemical Engineering, Biotechnology, Information Technology, Language
Architecture Engineering etc. Language of the articles should be only in English, we are not
processing articles in any other languages
IJT publishes Original research Articles, Short Communications,
Review Articles in all areas of Engineering and Technology. The Font type
subject covered is Engineering Mechanics, Construction Materials, Articles should be typed in single line spacing with the following
Surveying, Fluid Mechanics and Hydraulics, Modeling and font pattern
Simulations, Thermodynamics, Refrigeration and Air- Font type : Times new roman
conditioning, Metallurgy, Electronic Communication Systems, Size : For heading or title: 14 points and Bold (Small Letters, not
Agricultural Machinery and Equipment, Applied Sciences, capitalize the titles unnecessarily unless required, e.g. HPLC,
Chemical Engineering etc. HPTLC, UV, GC, TLC, SEM, TEM, etc.)
Author/ Coauthors name: 11 points and Bold
The journal is published semiannually every year in last week of Affiliation/ Institute name: 10 points
June and December. For subtitles: 11 points and Bold
Content of article : 10 points
General Table title and Content: 8 points
All submitted manuscripts should contain original work neither
published previously nor under consideration for publication Submission order
elsewhere. Articles shall be accepted from any country provided The following order should be strictly followed while submitting
submitted in English language only. There is page limitation for the article
articles up to 10 pages; the authors must strive to present their Front page: (Page-1) Title of article, authors' names, authors'
results as clearly and concisely as possible. Authors, in their cover institutional affiliations only and leave other spaces empty
note to Editor, shall have to clearly mention whether the On second page: (Page-2) Start with abstract of about 200-400
manuscript is to be considered as a Research article, Short words exactly conveying the content of the article, Keywords (at
communications or a Review article. least 5 words)
On third page: (Page-3 onwards) Main content text with all tables
Peer review policy and figures aligned in their proper place (do not send tables and
The journal aims at rapid publication of articles while maintaining figures separately unless requested), List of symbols and
rigorous peer review process, each article will be subjected to a Abbreviations, Acknowledgement, References (follow standard
minimum of two reviews by two individual reviewers. Reviewers format),
will be insisted to review the paper within 15 days time and if he/
she fail to return will be sent to other reviewer for review. All Preparation of manuscripts:
authors are requested to send one copy of manuscript to suggested Manuscripts should be submitted as per order: Title Page, name of
one reviewer by electronically to review the manuscript not of author (s), Abstract, Key words, Introduction, Material and
authors' institution or affiliation and the editorials shall send Methods, Results, Discussion, Acknowledgements (if necessary)
second copy to enlisted reviewer for reviewing the article. The and References. If the Result and Discussion sections are
reviewer shall reviewed the article as per instruction to author, combined, then a Conclusion section should be added.
special emphasis on spelling, format of references in text and
reference section, methodology, citation of journals cited, and Title Page: The first page should contain a concise and
summary and findings. Manuscripts shall go through a peer review informative title, the names and addresses of the authors and
process to adjudge their suitability and authenticity, for publication contact details of the corresponding author (postal address, e-mail,
in the journal. A confirmation about the acceptance of the and fax and telephone numbers).
manuscript will be sent to e-mail address of the corresponding
author. Please check your e-mail account frequently, because you Abstract: It should be about 200-400 words. Key words: A
will receive all important information about your manuscript maximum of 5 key words must be given at the end of the Abstract.
through e-mail only.
Introduction: This part should define the background and
Submission of Manuscript significance of the study by considering the relevant literature,
Authors may submit the articles only through the online particularly the most recent publications.
manuscript submission Submit a Paper system. Authors are
advised to submit the articles as MS Word 2003 or 2007 format Material and Methods: Please provide concise but complete
only with the pdf copy of letter for publication and copyright form information about the material and the analytical, statistical and
duly signed by author/(s), scanned. experimental procedures used. This part should be as clear as
possible to enable other scientists to repeat the research presented.

1
Results: In this part, the same data/ information given in a table Tables:
must not be repeated in a figure, or vice versa. It is not acceptable All tables should be numbered in order with grid lines. The table
to repeat extensively the numerals from tables into text and give number should be properly given, large size tables should be split
lengthy and unnecessary explanations of the Tables and Figures. into two or more tables so that it can be accommodated within the
Discussion: This part must be written with reference to the tables page size. Table width and cell sizing should be even and all the
and figures and by considering information from the literature. content should be left side aligned. Number of the tables and title
Statements made in the Introduction and Results sections should should be given above the tables and without any border, shading.
not be repeated here. Do not give on separate page. The table should with a brief but
complete and self-explanatory caption so that the reader can easily
Acknowledgements: If necessary, a brief Acknowledgements understand the results presented in the table. Please do not
section may be included. duplicate material that is already presented in the figures.
Ethics and Consent
References: References should be cited in the text in Arabic When reporting experiments on human subjects, authors should
numerals in superscript. The references should be cited at the end indicate whether the procedure follows were in accordance with
of the manuscript in the order of their appearance in the text. For the ethical standards of the responsible committee on human
citation of references with three or more authors, only the first experimentation. Do not use patients' names, initials, or hospital
author’s name followed by et al. should be used. In the numbers, especially in illustrative material. Papers including
manuscript, it is compulsory to cite references of the related animal experiments or clinical trials must be conducted with
articles from journals of A&V Publications. References to approval by the local animal care or human subject committees,
journal articles, books, chapters in books, etc. should be cited, as respectively.
follows:
Certificate of Conflict of Interest/ Plagiarism Report
Journal Articles Author(s) shall declared the conflict of interest Yes/ No before
Samuel PK, Rupa G. A Study to Assess Level of Job Satisfaction submission of manuscript for publication. The conflict of interest
and Subjective Wellbeing of Teaching Faculty Employed in as mentioned in manuscript before references section or by the use
Selected Colleges of Nursing at Pandalam, Pathanamthitta District, of any free plagiarism checker, the author(s) shall provide the
Kerala. Asian Journal of Nursing Education and Research. 2017 plagiarism report with submission of manuscript.
Apr 1;7(2): 222-4.doi: 10.5958/2349-2996.2017.00045.3 Plagiarism Checker
By the use of any free plagiarism checker, the author(s)
Singh AK. Acid Catalised Solvolysis of Amyl Methanoate in
Processing charges:
Binary Aquous solvent system and solvent effect on kinetics of
There is no processing fees or publication charges. The one printed
activation parameters. Asian Journal of Research in Chemistry.
copy of journal and publication certificate will be posted after
2020 Nov 1;13(6):485-8. doi: 10.5958/0974-4150.2020.00085.1
publication of article at the postal address of corresponding author.
Also one pdf copy of published manuscript shall be send as
Al-Ogaili NA, Osama S, Jazme D, Saad S. In Vitro Antibacterial
attached documents at author’s email. There is no processing fee
investigation and Synergistic Effect of Ficus carica and Olea
for co-authors.
europaea Aqueous Extracts. Research Journal of Pharmacy and
Technology. 2020 Mar 1;13(3): 1198-203.doi: 10.5958/0974- Transfer of copyright agreement:
360X.2020.00221.8 The article entitled ________________________________is
herewith submitted for publication in International Journal of
Book Technology (IJT). It has not been published before, and it is not
Stacey GL and Keen NT. Plant-microbe interactions. Chapman under consideration for publication in any other journal (s). It has
and Hall, New York.1996. not been published before, and it is not under consideration for
publication in any other journal (s). It contains no matter that is
Book Chapter scandalous, obscene, libelous, or otherwise contrary to law. I/We
Mandell GL. and. Petri WA. Antimicrobial agents: Penicillins, agree that copies made under these circumstances will continue to
Cephalosporins, and other ß-lactam antibiotics. In Goodman and carry the copyright notice that appeared in the original published
Gilman`s. The pharmacological basis of therapeutics, Edited by work. I/We certify that I/We have obtained written permission for
Hardman JG and Limbird LE. McGraw-Hill, New York. 1996; 9th the use of text, tables, and/or illustrations from any copyrighted
ed: pp. 1073-1101. source(s), and I/We agree to supply such written permission(s) to
International Journal of Technology (IJT) upon request. When the
Electronic journal article/ World Wide Web: article is accepted for publication, I/We, as author/authors, hereby
G. Mallika, V. Tulasi Das. Impact of Stress on working agree to transfer(s), assign(s), or otherwise convey(s) all copyright
performance of Nurses and Organizational effectiveness in ownership, including any and all rights incidental thereto,
Hospitals. Asian Journal of Management. 2020;11(3):225-32. doi: exclusively to the Journal, in the event that such work is published
10.5958/2321-5763.2020.00035.9 available on by the Journal. The Journal shall own the work, including 1)
https://ajmjournal.com/AbstractView.aspx?PID=2020-11-3-1 copyright; 2) the right to grant permission to republish the article
in whole or in part, with or without fee; 3) the right to produce
Figures: preprints or reprints and translate into languages other than English
Photos or drawings must have a good contrast of dark and light. for sale or free distribution; and 4) the right to republish the work
Legends of figures should be brief, but complete and self- in a collection of articles in any other mechanical or electronic
explanatory so that the reader can easily understand the results format. The article will be published under the terms of the latest
presented in the figure. Figure legends should be attached to the Creative Commons Attribution-NonCommercial- ShareAlike
figures. All figure number should be arranged orderly, the figures License, unless the journal notifies the author otherwise in writing.
should not be supplied separately but pasted in the proper place. Signature of author(s) with date
Figure number and title should be given below the figure, the Name(s) and designation
content of the figure should be explained in the title of figure. Name(s) of Institution/ Organization
2

You might also like