DRIVER CONTROLS

HRN
A

B
SECTION
HORN C

E
CONTENTS
PRECAUTION ............................................... 2 Commercial Service Tool ......................................... 3 F

PRECAUTIONS ................................................... 2 WIRING DIAGRAM ....................................... 4

Precaution for Supplemental Restraint System G
(SRS) "AIR BAG" and "SEAT BELT PRE-TEN- HORN ................................................................. 4
SIONER" ................................................................... 2 Wiring Diagram ......................................................... 4
Precaution Necessary for Steering Wheel Rota-
REMOVAL AND INSTALLATION ................ 7 H
tion After Battery Disconnect ..................................... 2
HORN ................................................................. 7
PREPARATION ............................................ 3 Exploded View .......................................................... 7
Removal and Installation .......................................... 7 I
PREPARATION ................................................... 3

HRN

Revision: November 2016 HRN-1 2017 D23

 PRECAUTIONS
< PRECAUTION >
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER" INFOID:0000000014251660

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the SR and SB section of
this Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, it is recommended that all mainte-
nance and repair be performed by an authorized NISSAN/INFINITI dealer.
• Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury
caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module,
see the SR section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the
Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s)
with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly
causing serious injury.
• When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the
battery or batteries, and wait at least three minutes before performing any service.
Precaution Necessary for Steering Wheel Rotation After Battery Disconnect
INFOID:0000000014251661

NOTE:
• Before removing and installing any control units, first turn the push-button ignition switch to the LOCK posi-
tion, then disconnect both battery cables.
• After finishing work, confirm that all control unit connectors are connected properly, then re-connect both
battery cables.
• Always use CONSULT to perform self-diagnosis as a part of each function inspection after finishing work. If
a DTC is detected, perform trouble diagnosis according to self-diagnosis results.
This vehicle is equipped with a push-button ignition switch and a steering lock unit.
If the battery is disconnected or discharged, the steering wheel will lock and cannot be turned.
If turning the steering wheel is required with the battery disconnected or discharged, follow the procedure
below before starting the repair operation.
OPERATION PROCEDURE
1. Connect both battery cables.
NOTE:
Supply power using jumper cables if battery is discharged.
2. Carry the Intelligent Key or insert it to the key slot and turn the push-button ignition switch to ACC position.
(At this time, the steering lock will be released.)
3. Disconnect both battery cables. The steering lock will remain released with both battery cables discon-
nected and the steering wheel can be turned.
4. Perform the necessary repair operation.
5. When the repair work is completed, re-connect both battery cables. With the brake pedal released, turn
the push-button ignition switch from ACC position to ON position, then to LOCK position. (The steering
wheel will lock when the push-button ignition switch is turned to LOCK position.)
6. Perform self-diagnosis check of all control units using CONSULT.

Revision: November 2016 HRN-2 2017 D23

 PREPARATION
< PREPARATION >
PREPARATION A
PREPARATION
Commercial Service Tool INFOID:0000000014251662
B

Tool name Description

C
Power tool Loosening nuts, screws and bolts

E
PIIB1407E

HRN

Revision: November 2016 HRN-3 2017 D23

 HORN
< WIRING DIAGRAM >
WIRING DIAGRAM
HORN
Wiring Diagram INFOID:0000000014251663

ABLWA3669GB

Revision: November 2016 HRN-4 2017 D23

 HORN
< WIRING DIAGRAM >

HRN

ABLIB0066GB

Revision: November 2016 HRN-5 2017 D23

 HORN
< WIRING DIAGRAM >

ABLIB0419GB

Revision: November 2016 HRN-6 2017 D23

 HORN
< REMOVAL AND INSTALLATION >
REMOVAL AND INSTALLATION A
HORN
Exploded View INFOID:0000000014251664
B

ALIIA1067ZZ J

1. Horn (LOW) 2. Horn (HIGH) Front

K
Removal and Installation INFOID:0000000014251665

HRN
REMOVAL
Horn (LOW)
1. Remove front grille. Refer to EXT-24, "Removal and Installation". M
2. Disconnect harness connectors (A) from horn (LOW) (1).
3. Remove nut (B) from horn (LOW), then remove horn (LOW) (1).
N

P
ALIIA1761ZZ

Horn (HIGH)

Revision: November 2016 HRN-7 2017 D23

 HORN
< REMOVAL AND INSTALLATION >
1. Remove front side of fender protector (RH). Refer to EXT-29,
"Removal and Installation".
2. Disconnect harness connectors (A) from horn (HIGH) (1).
3. Remove bolt (B) and horn (HIGH) (1).

ALLIA1760ZZ

INSTALLATION
Installation is in reverse order of removal.

Revision: November 2016 HRN-8 2017 D23