Scribd
Upload
53 views2 pages

ME-322_Machine-Design-1_MIDTERM_04-06-2022 (1)

Uploaded by

DWIGHT DIAMANTE
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
53 views2 pages

ME-322_Machine-Design-1_MIDTERM_04-06-2022 (1)

Uploaded by

DWIGHT DIAMANTE
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

University of Southeastern Philippines

College of Engineering
Obrero, Davao City

ME 322- Machine Design 1


Midterm Examination
April 6, 2022
(1:00 pm-3:00 pm)

General Instruction:

1. CHEATING IS STRICTLY PROHIBITED


2. SHOW YOUR SOLUTIONS NEATLY AND CLEARLY
3. Make your font bigger and use black pen.
4. Observe time limit.

1. A 16 mm plate is lapped over and secured by fillet weld on the inside and
outside to form a penstock 1.5 m in diameter. Determine the safe internal
pressure, assuming an allowable stress of 140 Mpa on the plate and an
allowable shear stress of 90 Mpa on the throat side of the 14 mm fillet weld.
(25 pts )
1
2. The connection shown has the following dimensions: d =1 in,
4
1 1 5 1
D=2 𝑖𝑛, D1=1 𝑖𝑛, h= 𝑖𝑛, t= 𝑖𝑛; it supports a load of 15 kips. Compute
2 2 8 2
the tensile, compressive, and shear stresses induced in the connection. What
is the corresponding design factor based on the yield strength if the rod and
nut are made of AISI C1045, as rolled, and the plate is structural steel (1020)?
(25 pts)
3. The beam shown has a circular cross section and supports a load F that varies
from 1000 lb to 3000 lb.; it is machined from AISI C1020 steel, as rolled.
Determine the diameter D if r = 0.2D and N=2; indefinite life. (25 pts)

4. The shaft shown in the figure carries a torque of 20,000 in-lb. What must be
the distance x in order to make the maximum shearing stress 8,000 psi? The
shafts rotates and loads are steady. Use the ASME code. (25 pts)

************************** end ***************************


GOOD LUCK!

You might also like