Scribd
Upload
285 views5 pages

BMW 7 Series F01 F02 2008 2009 2010 2011 2012 2013 2014 Factory Repair Manual

gvb

Uploaded by

zedfold3
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
285 views5 pages

BMW 7 Series F01 F02 2008 2009 2010 2011 2012 2013 2014 Factory Repair Manual

gvb

Uploaded by

zedfold3
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

2009 BMW 750Li

ENGINE Engine Electrical System - Repair

Fig. 57: Locating Regulator Switch Screws


Courtesy of BMW OF NORTH AMERICA, INC.

Valeo

Installation:

Clean contact surfaces and check pretension of contact spring, replace regulator switch if necessary.

Measurement A = min. 5 mm.

Check collector ring for wear and recondition if necessary.

Fig. 58: Identifying Measurement A


2009 BMW 750Li
ENGINE Engine Electrical System - Repair

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit new regulator (1) with attached mounting sleeve (2) or locked carbon brush.

Pull off mounting sleeve (2) and replace with cover (3).

Fig. 59: Identifying Regulator, Mounting Sleeve And Cover


Courtesy of BMW OF NORTH AMERICA, INC.

1241 STARTER WITH MOUNTING


12 41 020 REMOVING AND INSTALLING/REPLACING STARTER (N63)

Necessary preliminary work

 Switch off ignition.


 Disconnect BATTERY EARTH LEAD .
 Remove right ENGINE SUPPORT ARM .

Release connector (1) and remove.

Slacken nut (2).

Tightening torque 12 42 2AZ .

Detach starter positive cable.


2009 BMW 750Li
ENGINE Engine Electrical System - Repair

Fig. 60: Identifying Starter Connector And Nut


Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 12 41 1AZ .

Disengage cable (2) from holder.

Pull out starter in direction of travel, feed out and remove.

Installation note:

When replacing the starter, convert cable holder for cable (2).
2009 BMW 750Li
ENGINE Engine Electrical System - Repair

Fig. 61: Identifying Starter Screws And Holder Cable


Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check starter pinion and starter ring gear for damage. If necessary, replace damaged components.

Reassemble the vehicle.

12 41 041 REPLACING SOLENOID SWITCH

Turn off ignition

Remove starter motor.

Release nut (1).

Remove cable lug (2).


2009 BMW 750Li
ENGINE Engine Electrical System - Repair

Fig. 62: Identifying Starter Motor Nut And Cable Lug


Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not turn cable lug (2) while tightening down - risk of short circuit to
starter motor housing.

TIGHTENING TORQUE, 12 41 4AZ .

Release screws (1).

Fig. 63: Identifying Starter Motor Housing Screws


Courtesy of BMW OF NORTH AMERICA, INC.

You might also like