Scribd
Upload
18 views

Check_point_for_ONT_Testing

Uploaded by

vinitprajapati6
Copyright
© © All Rights Reserved
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
18 views

Check_point_for_ONT_Testing

Uploaded by

vinitprajapati6
Copyright
© © All Rights Reserved
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 12

Sr. No.

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35

36

37
38
39
40
41
42
43
44
45
46
Post Firmware, Test Parameters (Comway)
Logo
Speed Test, Traffic throughput on LAN
LAN port syncronization rate (10/100/1000Mb)
Via LAN to CPE & DNS Latency, approx 10K packet should be observe
Speed Test, Traffic throughput on 5G Band
On wifi syncronization rate on 5G Band
RSSI Value (netsh wlan show interfaces) on 5G Band
Wifi SSID/Channel/Width need to check on 5G Band
Via Wifi to CPE & DNS Latency, approx 10K packet should be observe
Speed Test, Traffic throughput on 2.4G Band
On wifi syncronization rate on 2.4G Band
RSSI Value (netsh wlan show interfaces) on 2.4G Band
Wifi SSID/Channel/Width need to check on 2.4G Band
Via Wifi to CPE & DNS Latency, approx 10K packet should be observe
At the time of speed test latency should not be increased
At the time of speed test if the latency increased that time if any VPN has connected that should not be disconnected.
Device uptime more than 2-3Hrs & 6Hrs and than speed test should be ok.
Speed test near ont, than 3mtr and than 6mtr at least 10times at every stage
ONT Coverage area on both band
On Wifi connected all devices NAME OR HOSTNAME should be visible & correct (Iphone must check after connect)
On Wifi connected devices IP ADDRESS/LEASE TIME/RSSI vlaue should be visible & correct
Multiple WAN should be create with different VLAN. (MAC should not same on both WAN, need to check with atleast 5-7 rebo
Service name should be strict.
Session timer check after session disconnect from bras.(Session need to check with stopwatch timer)
Port forwarding & DMZ need to check. (( netstat -aon ))
Bridge Mode should not be visible
Wifi bridge & wifi to wifi option should not be unabled
LAN to wifi (secondary router) should not work (as repeater should not work)
DHCP server details hide or unhide need to check
Mac cloning option should not visible
Device uptime & wan uptime should be visible.
After Reboot WAN settings & MAC should not be change
Service restoration time after optical link restoration
Service restoration time after ONT Reboot
Voice parameter should be check (like, registration time, dial tone, incoming, outgoing & status onhook/offhook/ringing)
DNS Testing: 1. Comway DNS should be on route WAN, then only internet should work. After taking our DNS on WAN, interne
work on LAN with any manual DNS. 2. If our DNS not on route WAN then internet should not work & If our DNS not on route W
internet also should not work on LAN with our manual DNS.
ONT Local user admin, user rights need to check
ONT performance should be check on all OLTs (like..RLtech, Syrotech, Zte, Huawei)
Auto DFS (dynamic frequecny slection) should be enable
Current temperature & threshold need to check
Stun should be enable.
Technical Report 069 (TR-069) & should not be disable
After Firmware upgrade wifi name (SSID) should not be change
Logs file need to verify (Type of logs)

Device Information:-
ONT model number : TJ2100N-G002010-AC1200
ONT SN : 4857544300AC23B9
ONT Hardware Version: 1.0
ONT Software Version: 2.3.5.36
ONT PON SN:
ONT Chipset:
ONT Flash: 128Mb
ONT Ram: 256Mb
Electrical Power Adoptor Rating: 12V/1.5A
LAN Port : 2
Voice Port: 1
Fiber Pigtail: Green
Test with user account:
Test Status New-Firmware
Need to change Logo Image Y
851/898, 859/891, 852/887, 832/911, 851/904
1000Mb
OK
412/554, 411/588, 452/560, 447/557, 408/536
866.7
100%
OK
OK
59/50, 49/47 ,68.41 ,62/40, 61/39
144
100
OK
OK
OK
OK
OK
Done
Pefect
Not OK y
OK
OK
OK y
OK
Ok
OK
OK
OK y
OK
OK y
OK
OK
OK
Not OK
OK

OK
checked on Huawei,ZTE y
N/A
current temprature ok / Threshold need to check with Tejas y
OK
OK y
need to verify by firmware
OK
Test Points
Configurations Test
ONT Add Via NMS/CLI
Line and Service Profile configuration
Configure ONT ETH port in bridge from NMS/CLI

ONT ETH port status from NMS

DHCP Option82 string in bridge port


DHCP Option82 string in route
Internet WAN configuration in Route
PPPOE Internet Configuration with Service Name
Configure Voice on ONT via NMS/CLI
Access Control/Remote management

Data and Voice WAN deletion from ZTE CLI/NMS

ONT optical Power status RX/TX (dbm)


OLT side ONT TX optical power status
ONT Pigtail type (UPC/APC) Blue color/Green color and its losses
ONT FE/GE ETH port sync status from NMS and CLI
Voice registration status from NMS and CLI
ONT pots line status (Hook state)
Calling from ONT to another ONT
Voice Ringback tone status on Instrument
Voice Ringtone status on Instrument
Call waiting/Call busy/Call Transfer test via Intercom number
Call waiting/Call busy/Call Transfer test via Landline/Mobile number
Reboot the ONT from NMS/CLI via OMCI
Restore factory from NMS/CLI via OMCI
ONT last down cause and current uptime status
Performance Tests
ONT optical Power status on Spitters (1X8, 1X16, 1X64)
Service restoration time after optical link restoration
Service restoration time after ONT Reboot
Internet Speed on ONT ETH FE/GE port
Internet Speed on ONT Wifi 2.4G and 5Ghz
Wifi Signal (RSSI value ) and Speed test on 10-15m Distance
Voice registration test on routed IPPBX server
Services status on multiple ONT WAN
ONT MAC change test after reboot
ONT side Route/Bridge MAC status and aging time
MAC limit on ONT in case of Bridge Port Configuration
Loop detection on ONT ports test
DHCP, PPPOE request interval time
Voice (SIP Registration and keep alive) interval time
Electrical Power Adoptor Rating
Fusionnet and Comway Internet with Customization Test
Tr069 Testing
Tejas-Fusion V1.0-2.3.5.36

checked on Huawei
VOIP profile is pushed from OLT
NA
OKAY ( Second port not showing connected in huawei
NMS)
NA
OKAY
OKAY
OKAY
from ONT web Only
Hardcoded in ONT
Data from ONT Web, Voice from OLT OMCI ( Wan will
not be deleted )
Okay in Huawei/
OKAY
Green
Okay
ONLY ONT WEB
Idle State
Okay
Okay
Okay

okay
Not working from Huawei, need to check at ZTE
Okay

okay
with in one minute
within 2 Min(No)
Okay
Okay
Okay
Okay
okay
Stable
Okay
NA
Okay

Okay
1.5 Amp

OK
Parametrique

checked on Huawei
VOIP profile is pushed from OLT
NA

OKAY ( Second port not showing connected in huawei NMS)

NA
OKAY
OKAY
OKAY
from ONT web Only
Hardcoded in ONT
Data from ONT Web, Voice from OLT OMCI ( Wan will not be deleted )

Okay in Huawei/
OKAY
Green
Okay
ONLY ONT WEB
Idle State
Okay
Okay
Okay

okay
Not working from Huawei, need to check at ZTE
Okay

okay
with in one minute
within 2 Min
Okay
Okay
Okay
Okay
okay
Stable
Okay
NA
Okay

Okay
1.5 Amp

You might also like