Scribd
Upload
11 views1 page

me5 md1 May-2007

Machine design Question paper

Uploaded by

bobymajotra123
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views1 page

me5 md1 May-2007

Machine design Question paper

Uploaded by

bobymajotra123
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Machine Design-1

(ME-301, May. 2007)

Time: 3 Hours Max. Marks: 60

Note: Question No. 1 is compulsory. Attempt any four questions from section B and two questions from section C.

Section-A
1. (a) What are prerequisite for design?
2
(b) How will you designate plain carbon steel with minimum tensile strength of 320 N/mm .
(c) What is endurance limit?
(d) Explain the significance of Soderberg & Goodman diagram.
(e) Define the strength of a fillet weld joints.
(f) Define Notch sensitivity.
(g) What is difference between caulking and fullering?
(h) Write the expression for the shearing strength of socket collar.
(i) What is the effect of the keyway cut into the shaft?
(j) What is the difference between muff coupling and pin & bush coupling?

Section-B
2. State the objectives and applications of case hardened components.
3. Explain the following terms in connection with design of machine members subjected to variable loads.
(a) Endurance limit
(b) Size factor
(c) Surface finish factor
4. Two lengths of shafts are connected through a flange coupling provided with four bolts of same material as shaft.
The bolts are set in reamed holes located on a bolt circle of 25 mm diameter. Determine least bolt size to transmit
the same torque. Justify the final bolt size.
Chosen
Minor dia dc 2
Pitch P mm Pitch dia dp (mm) Major D mm Stress N/mm
mm
M10 1.5 9.026 8 6.466 36.6
M12 1.75 10.863 10 8.160 58.00
M16 2.00 14.701 12 9.853 84.3

5. Explain the various types of pipe joints commonly used in engineering practice.
6. State the application of a foot lever. Discuss the procedure for designing a foot lever.

Section-C
7. List out various modes of failures while designing a gib and cotter joint. Explain one of them in detail.
2
8. (a) Find the diameter of rivet for the riveted connection as shown in Figure. Allowable shear stress = 900 kg/cm .

Figure.

(b) Explain the design procedure for a lever safety valve.


9. (a) A gear transmit 50 hp at 750 rpm. It is rigidly fastened to a 4.5 cm diameter shaft made of 40 Cr 1 Mo 28 alloy
2
steel having yield strength of 5400 kg/cm . Suggest a suitable key for gear. Assume a suitable factor of safety.
(b) Explain how you would determine the strength of transverse and parallel fillet weld joint.

You might also like