Scribd
Upload
32 views

Ec101 Basics of Electronics and Communication Engineering (End_sp22)

Uploaded by

Adarsha Smart
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
32 views

Ec101 Basics of Electronics and Communication Engineering (End_sp22)

Uploaded by

Adarsha Smart
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

BIRLA INSTITUTE OF TECHNOLOGY, MESRA, RANCHI

(END SEMESTER EXAMINATION)


CLASS: BTECH/IMSC SEMESTER : II
BRANCH: BT/CHEMICAL/CIVIL/MECH/PROD/FT SESSION : SP/2022

SUBJECT: EC101 BASICS OF ELECTRONICS AND COMMUNICATION ENGINEERING


TIME: 3 HOURS FULL MARKS: 50

INSTRUCTIONS:
1. The question paper contains 5 questions each of 10 marks and total 50 marks.
2. Attempt all questions.
3. The missing data, if any, may be assumed suitably.
4. Tables/Data hand book/Graph paper etc. to be supplied to the candidates in the examination hall.
----------------------------------------------------------------------------------------------------------------------------------

Q.1(a) Explain the working principle of a full-wave rectifier with a C-type filter and resistive load. Draw [5]
the related waveforms and derive the expression for the ripple factor.
Q.1(b) Determine the range of values of V i that will maintain the Zener diode of the following figure in [5]
the “on” state.

Q.2(a) What is the need for biasing? Draw the fixed bias circuit and derive the expression for 𝑉 and [1+4]
𝐼 .
Q.2(b) Compare the Depletion type MOSFET and Enhancement type MOSFET. Find the value for drain [5]
current of a JFET with 𝐼 =12mA, 𝑉 = −6𝑉 and 𝑉 = −3𝑉.

Q.3(a) List out any four advantages of negative feedback. An amplifier with negative feedback gives an [2+3]
output of 12.5 V with an input of 1.5 V. When feedback is removed, it requires0.25 V input for
the same output. Find the voltage gain without feedback (𝐴) , and the value of feedback factor
(𝛽).
Q.3(b) Write the characteristics of an ideal operational amplifier. Find the value of the output voltage [5]
V0 for the following figure.

Q.4(a) Implement the function 𝑭(𝑨, 𝑩, 𝑪, 𝑫) = 𝑨 + 𝑩𝑪 + 𝑨𝑩𝑫 + 𝑨𝑩𝑪𝑫 with basic logic-gates [5]
Q.4(b) Implement a full adder circuit by using a minimum number of two inputs NAND gates [5]

Q.5(a) Explain the different elements of an electronics communication system with a neat block [5]
diagram. Determine the required minimum antenna height for transmitting a voice signal of 1
KHz.
Q.5(b) What do you mean by modulation and demodulation? Why is modulation required in [5]
communication system? Explain the Amplitude modulation briefly.

::::::20/07/2022:::::

You might also like