Scribd
Upload
68 views1 page

1oT_eSIM-Test_Telit-LE910-v2

The Telit LE910 V2 modem supports eSIM and is available in LTE single-mode and 3G/2G fallback, requiring firmware version 20.00.405 or newer. To set up the module for eSIM, the SIM Application Toolkit must be enabled, and specific AT commands are provided for configuration and verification. After rebooting, users should check the settings to ensure the module is ready for Remote SIM provisioning.

Uploaded by

mcamarillo.twrs
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
68 views1 page

1oT_eSIM-Test_Telit-LE910-v2

The Telit LE910 V2 modem supports eSIM and is available in LTE single-mode and 3G/2G fallback, requiring firmware version 20.00.405 or newer. To set up the module for eSIM, the SIM Application Toolkit must be enabled, and specific AT commands are provided for configuration and verification. After rebooting, users should check the settings to ensure the module is ready for Remote SIM provisioning.

Uploaded by

mcamarillo.twrs
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

1oT eSIM TEST

Telit LE910 V2
Telit LE910 V2 is the new version of the original
LE910. It’s important to note that the original
modem does not have support for eSIM.

The LE910 V2 is available in LTE single-mode

and 3G/2G fallback.

Prerequisites
Firmware version: 20.00.405 or newer

Setting up the module with eSIM


Telit has not enabled SIM Application Toolkit(SAT) by default and as it is an essential

part of Remote SIM Provisioning it needs to be enabled. For future use the configuration

can also be stored so it would be enabled on every startup.

AT+CGDCONT=1,"IP","Terminal.apn" Set up the APN to be used by the PDP


context
AT#STIA=2 Enable SIM Tookit Interface and extended
unsolicited indication
AT#STTA=1 Attaches the SIM Application Toolkit to the AT
instance
AT&P0 Defines to load full profile 0 at startup
AT&W0 Stores the current configuration as profile 0
AT#REBOOT Restarts the module
After the reboot make sure that the profile was stored successfully and also loaded on

startup. Check the values with:


AT+CGDCONT=? Check APN name
AT#STIA=? Check if SIM Application Toolkit is enabled
If everything is showing up correctly the module is ready for Remote SIM provisioning.

You might also like